OWNER’S
INSTRUCTIONS
AWT18QBHDA
MODEL CODE:
AWT17QBHD***/XTL
AWT18QBHD***/XTL
Window-type Room Air Conditioner
(Cool)
E DB98-15151A(1)
The following safety precautions must be taken when using your air conditioner.
1 The unit must be plugged into an independent circuit.
The air conditioner must be installed in accordance with national wiring regulations and safety regulations wherever applicable.
2 Some installation locations may require installation of a short circuit breaker or grounding.
3 If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent.
4MAKE sure that the unit is correctly ventilated at all times ; do NOT place clothing or other materials over it.
5NEVER spill any kind of liquid into the unit. Should this happen, unplug the unit and contact an authorized service center.
6Do NOT insert anything between the air outlet blades because the inner fan may be damaged and could cause injury. Keep children away from the unit.
7Do NOT place any obstacles in front of the unit.
8Users of this product are cautioned not to attempt repairs.
Instead, they are requested to directly contact a designated service center or the outlet at which the product was purchased.
9Do not use an extension cord with this product.
10The appliance is not intended for use by young children without supervision ;
young children should be supervised to ensure that they do not play with the appliance.
11Never store or ship the air conditioner upside down or sideways to avoid damage to the compressor.
12Max current is measured according to IEC standard for safety
and current is measured according to ISO standard for energy efficiency.
CAUTION
The manufacturer does not assume responsibility for accidents or injury caused by an incorrectly installed air conditioner. If you are unsure about installation, contact an installation specialist.
E-2
|
Contents |
|
PREPARING YOUR AIR CONDITIONER |
|
|
■ |
Safety Precautions ......................................................................................... |
2 |
■ Description of Each Component .................................................................... |
4 |
|
■ |
Remote Control - Buttons .............................................................................. |
5 |
■ |
Getting Started ............................................................................................... |
6 |
■ Inserting the Remote Control Batteries .......................................................... |
7 |
|
OPERATING YOUR AIR CONDITIONER |
|
|
■ |
Cooling Your Room ........................................................................................ |
8 |
■ |
Ventilating Your Room ..................................................................................... |
9 |
■ Adjusting the Air Flow Direction Horizontally .................................................. |
10 |
|
■ Adjusting the Air Flow Direction Vertically ...................................................... |
11 |
|
PROGRAMMING YOUR AIR CONDITIONER |
|
|
■ Setting the On Timer ...................................................................................... |
12 |
|
■ Setting the Off Timer ...................................................................................... |
13 |
|
■ Setting the Sleep Timer .................................................................................. |
14 |
|
■ Selecting Energy Saving mode ...................................................................... |
15 |
|
RECOMMENDATIONS FOR USE |
|
|
■ |
Operating Recommendation ........................................................................... |
16 |
■ Temperature and Humidity Ranges ................................................................ |
16 |
|
■ |
Cleaning Your Air Conditioner ........................................................................ |
17 |
■ |
Solving Common Problems ............................................................................ |
18 |
■ |
Technical Specifications ................................................................................. |
19 |
INSTALLATION ..................................................................................................... |
20 |
E-3
Air inlet (Inside)
Air filter (Inside)
Operating mode indicators (Cool, Fan)
Mode selection button (Cool, Fan)
Energy Saver indicator
Energy Saver button
Sleep timer indicator
Sleep timer setting button
Timer setting button
BLUE BROWN YELLOW/GREEN
Main Power Earth
Inner air flow blades (right/left orientation)
Outer air flow blades (up/down orientation)
Air inlet (Outside)
Air outlet
Ventilation lever
Power cable connection should be committed to an installation engineer.
Temperature/ Timer settings
Temperature adjustment buttons
Timer indicator
Air flow blade swing button
On/Off button
Fan speed adjustment button |
|
Remote control signal receiver |
|
|
|
|
|
|
E-4
Remote Control - Buttons
Timer setting button |
|
|
Temperature adjustment |
Sleep timer setting button |
buttons |
|
Mode selection
buttons
Fan speed adjustment buttons
Energy Saver button
Air flow blade swing button |
On/Off button |
Swing
E-5
Getting Started
You have just purchased a Samsung window-type room air conditioner which should be installed following your installation manual.
Your Owner’s Instructions contain much valuable information on using your air conditioner. Please take the time to read them as they will help you take full advantage of the unit’s features.
The booklet is organized as follows.
The following figures are shown on pages 4 and 5:
-Description of Each Component
-Remote control (buttons)
They will help you find the buttons and understand the symbols displayed.
In the manual, you will find a series of step-by-step procedures for each function available.
The illustrations in the step-by-step procedures use four different symbols:
PRESS |
PUSH |
IMPORTANT |
NOTE |
E-6
You must insert or replace the remote control batteries when :
You purchase the air conditioner
The remote control does not work correctly
Use two AAA, LR03 1.5V batteries.
Do not use old batteries or different kinds of batteries together.
Batteries may be completely discharged after 12 months, even if they have not actually been used.
1Push the battery cover on the rear of the remote control with your thumb in the direction of the arrow and remove it.
2Insert the two batteries, taking care to respect the polarities :
+ on the battery with + on the remote control.
- on the battery with - on the remote control.
3Close the cover by sliding it back until it clicks into place.
E-7
|
|
|
|
|
You must select the Cool mode if you wish to lower the temperature |
|||
|
|
|
|
|
in your room. You can also set the Fan speed. |
|||
Remote Control |
Control Panel |
|
|
|
|
|
||
|
1 Press the |
|
(On/Off) button. |
|||||
|
|
|||||||
|
|
|||||||
|
|
|
|
|
Result: The air conditioner starts up in the cool mode(Fan speed |
|||
|
|
|
|
|||||
|
|
|
|
|
|
|
will not be changed). |
|
|
|
|
|
|
The unit beeps twice. |
|||
|
|
|
|
|||||
|
|
|
|
|
The air conditioner is fitted with a protection mechanism to prevent |
|||
|
|
|
|
|||||
|
|
|
|
|
the unit from being damaged when it is started immediately after |
|||
|
|
|
|
|
being: |
Plugged in
Stopped
It will start up normally after three minutes.
2 If the temperature is not displayed on the control panel:Press the button on the remote control
or
Press the button on the unit one or more times until the temperature is displayed.
Result: The unit beeps each time you press the / button.
The air conditioner starts up in the Cool mode.
You can change modes at any time.
3 To adjust the temperature, press the or buttons on the remote control or unit one or more times until the desired temperature is displayed.
The temperature can be set between 18°C and 30°C. Result: Each time you press the or buttons:
– The temperature is adjusted by 1°C and displayed on the control panel
–The unit beeps
The air conditioner starts cooling, if the room temperature is higher than the selected temperature.
If the room temperature reaches the set temperature, the air conditioner stops cooling, but the fan is still operating.
4 To set the fan speed:
Press the , or button on the remote control as desired. or
Press the button on the unit one or more times until the desired Fan speed(F1, F2 or F3) is displayed.
Low
Medium
High
5 To control the direction of the air flow, refer to pages 10 and 11.
E-8