Olson Technology S450P User Manual

S450P

FREQUENCY AGILE PROCESSOR

INSTRUCTION MANUAL

Phone:

E-Mail: [e-mail]

025-000485 REV X1 7/28/04

[phone]
[phone]

Fax:

[phone]

www.olsontech.com

025-000485 REV x1

Page 2

Table of Contents

Section Page

1.1 Description 4

2.1 Installation 5

2.2 Rear Panel IF Connections 6

2.3 Input Connections 7

2.4 Output Connections 7

3.1 Adjustments and Operation 7

3.2 Standby Carrier Threshold Adjustment 7

3.3 Powering 7

3.4 Input Channel Tuning 7

3.5 Output Channel Tuning 13

3.5.1 On-Channel Operation 13

3.5.2 Offset Mode 13

3.6 Output Carrier Level 16

3.7 Picture/Sound Ratio 16

025-000485 REV x1

Page 3

1.1 Description

The Olson T echnology Model S450P is a high quality , channel processor designed with front-panel selectable
frequency agility . The input tuner is capable of selecting any VHF , UHF , or cable channel from 54 to 860MHz, in
1MHz increments. The output tuner can select any output frequency from 55.25 to 547.25, also 1MHz increments.

The S450P input and output channels are selected by setting front panel dip switches concealed behind cover
plates. Frequency offsets (+12.5 or +25 KHz) as required by the FCC, are also selectable via dip switches in the
group of output channel selection switches.

The IF output of the input tuner is externally connected to the IF input of the output tuner at the S450P’ s rear panel.
This connection must be in place for standard operation.

Specifications for the S450P are listed in T able 1-1; a block diagram of the unit is shown in Figure 1-1.

025-000485 REV x1

Page 4

1.1 Description
(Continued)

2.1 Installation

Front and rear panel controls and connectors used in the installation and operation procedures are shown in Figure
2-1, 2-2, and listed in T ables 2-1 and 2-2.

025-000485 REV x1

Page 5