Logitech Ultimate Ears 200 User Manual

www.logitech.com

© 2011 Logitech. All rights reserved. Logitech, the Logitech logo, and
other Logitech marks are owned by Logitech and may be registered. All
other trademarks are the property of their respective owners. Logitech
assumes no responsibility for any errors that may appear in this manual.
Information contained herein is subject to change without notice.

iPod is a trademark of Apple Inc., registered in the U.S. and other
countries. Apple is not responsible for the operation of this device or its
compliance with safety and regulatory standards. All other trademarks are
the property of their respective owners.

620-003246.002

What do you think?

Please take a minute to tell us.

Thank you for purchasing our product.

www.logitech.com/ithink

www.logitech.com/support

United States [phone]

Hearing and Health is Critical!
Please review the safety guidelines

in the Important Information

Document.

Getting started with
Ultimate Ears™ 200
Noise-Isolating Earphones

www.facebook.com/ultimateears

www.twitter.com/ultimateears

Getting started with
Ultimate Ears™ 200
Noise-Isolating Earphones

Important information

Safety, compliance, and warranty

www.facebook.com/ultimateears

www.twitter.com/ultimateears

Tuned by Ultimate Ears

1

2

3

Rib

LMSXSXXS

Choose an ear cushion size, extra, extra small (XXS)
to large (L), which best fits your ears. Selecting the
correct ear cushion size helps ensure a comfortable fit
and seal to achieve optimal sound quality.

4 5

Gently insert earphone into your ear for a
good seal: R for right ear; L for left. Never
remove an earphone from your ear by
pulling on its cable.

Store by wrapping cable around fingers;
place earphones inside protective
pouch. To clean, remove cushion and
wipe with a clean cloth.

Attach ear cushions to earphone nozzle. Push ear
cushion past rib on nozzle so ear cushion will not
separate from nozzle during use.

Troubleshooting

• No sound – ensure that the 3.5 mm earphone connector is fully seated into
the iPod/MP3 player headphone jack.

• Weak bass – check ear cushion seal; try another ear cushion size.

• Detached ear cushions – firmly attach ear cushions to earphone nozzle. See

step 2 on reverse side.

• Diminished sound quality – remove ear cushions, check for blockage in
nozzle, and wipe with a clean cloth.

• Missing ear cushions – go to www.logitech.com for replacements.

Product information:
www.logitech.com

Support: www.logitech.com/support (see phone numbers in this document)

Product registration:

www.logitech.com/register

Protect your hearing: Read safety guidelines in Important Information Document.

Nozzle

Insert the earphone cable connector into the

3.5 mm headphone jack on your iPod® or
MP3 player.