Jaguar JLM10 31 99 552 User Manual

BLUETOOTH® IN-CAR

TELEPHONE HANDBOOK

Publication Part No. JJM 10 31 99 552

Published June 2005 by Technical Communications, Jaguar Cars Limited

JAGUAR CARS LIMITED, as manufacturer, is dedicated to the design and production

of vehicles which meet the expectations of the world’s most discerning purchasers.

This handbook forms part of the owner literature supplied with your vehicle. It is designed to complement the relevant features and systems of the vehicle, and make them easy to understand and operate. For safety and the pleasure you will get from your new vehicle, please take the time to get well acquainted with your vehicle by reading the handbooks.

This handbook describes every option and model variant available and therefore, some of the items covered may not apply to your particular vehicle.

For the specification of a particular vehicle, owners should consult their Jaguar Dealer/Authorised Repairer.

To cover changes, it is sometimes necessary to issue one or more handbook supplements. When reading this handbook, check the owner literature for possible supplements. Any further updates will be posted on the Jaguar Cars internet site and can be accessed at www.jaguar.com in the Owner Information area.

For full details of the owner literature originally supplied with the vehicle, owners should consult their Jaguar Dealer/Authorised Repairer.

When left-hand or right-hand is used in the text, this refers to the left-hand side or right-hand side of the vehicle, when viewed from the rear.

The manufacturer reserves the right to vary its specifications with or without notice, and at such times and in such manner as it thinks fit. Major as well as minor changes may be involved in accordance with the Manufacturer’s policy of constant product improvement.

All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form, electronic, mechanical, photocopying, recording or other means without prior written permission from the Service Division of Jaguar Cars Limited.

This book is printed on paper that originates from sustainable forests, is recyclable, bio-degradable and acid-free. The wood pulp is chlorine-free and the effluent water is purified before being discharged.

Contents

Quick Overview. . . . . . . . . . . . 6

Introduction. . . . . . . . . . . . . . 15

Safety. . . . . . . . . . . . . . . . . . . 17

Audio Panel Controls . . . . . . 19

Getting Started . . . . . . . . . . . 21

Phone Book. . . . . . . . . . . . . . 25

Hands-free Controls. . . . . . . 27

Hands-free Operation . . . . . 31

Touch-screen Controls . . . . 34

Voice Activation . . . . . . . . . . 38

Declaration of Conformity . . 39

A comprehensive index is located at the back of this handbook.

Quick Overview

INTRODUCTION . . . . . . . . . . . . . . . . . . 6

TOUCH-SCREEN SYSTEM . . . . . . . . . 6

AUDIO SYSTEM . . . . . . . . . . . . . . . . . 10

Quick Overview

Quick Over view

INTRODUCTION

Bluetooth communication operates between bluetooth equipped devices; in this case, the Jaguar Touch-screen System or Audio System and a mobile phone.

There are a limited number of mobile phones (currently ten) that have been tested and proved to function correctly with the Jaguar system - ask your Jaguar Dealer for details.

Before any phone can operate with the Jaguar system, it must be Paired with the system.

This involves the phone and the Jaguar system communicating a unique code between them, at initiation, so that in future they each recognise one another.

When Pairing any phone with the Jaguar system make sure that the phone is switched on, the phone battery is fully charged and the User's Handbook for the phone is available.

This Quick Overview describes the Touch-screen System first (Page 6), followed by the Audio System display (Page 10).

The Bluetooth system is identical for both the Touch-screen and the Audio displays, the difference is only in the way that the information is presented to the user.

TOUCH-SCREEN SYSTEM

Icons and buttons used in the following Touch-screen instructions:

Phone Mode button, to manually select the phone mode. Located to the left of the Touch-screen. Send/End icon. Located on the Touch-screen.

Switching ON the ignition

Each time the ignition is switched on, the following screens may be displayed.

This screen may be displayed for a few seconds while the system is performing a self-check.

Do not take any action. However, should the screen stay on for longer than twenty seconds, switch the ignition OFF and wait for at least 6 minutes. Refer to Reason for Ignition OFF for 6 Minutes, page 8 for more information.

After the brief system check, you should see the following screen:

Quick Overview

This screen will be displayed to indicate one of two possible conditions:

1. There is no phone currently Paired to the vehicle system or no phone is available. Should this be the case, this screen will continue to be displayed while the system is in phone mode (the system may display the Discover Me screen ready for you to Pair your Bluetooth mobile phone).

2. Displayed only for a few seconds if a phone IS Paired, but whilst the system is booting-up and looking for a Paired device. If the last Paired phone is available and switched on in Bluetooth mode, then the screen changes from No BT Phone to Phone

Connected.

Pairing your phone

The following instructions describe how to initiate Pairing your mobile phone to the Jaguar system.

If there is no mobile phone Paired to the vehicle system and the No BT Phone screen is displayed, Pairing may be performed as follows:

Select Phone Mode (if not already selected).

Use the touch-screen keypad to enter the following digit sequence and press the green Send/End icon.

##3#*#

The display will then show the following screen.

At the Discover Me screen the vehicle system is waiting for communication with a Bluetooth equipped telephone.

Check that your mobile phone is set to the Jaguar Bluetooth system, using the menu functions on the phone. Refer to the handbook that was supplied with your specific mobile phone.

When Jaguar device is found on the mobile phone display, the phone will prompt you to enter the pass key (1313) on the mobile phone keypad.

Quick Overview

When the above operation has been completed and the phone is successfully Paired and connected with the vehicle system, the Phone Connected screen will be displayed.

Note: The screen may briefly change from Discover Me to No BT Phone whilst the

system connects the Bluetooth link, before the Phone Connected screen is displayed.

Downloading your phonebook entries

The Phonebook entries on your mobile phone can be downloaded from your phone to the vehicle system, dependent on the capability of the mobile phone.

For more information, refer to the specific Quick Guide (available from your Jaguar Dealer or Authorised Repairer) for your phone.

The following process will only work with specific phones. The phone must be ON and already Paired with the Jaguar system.

1. Press the vehicle Phone Mode button. (If not already in phone mode.)

2. Use the touch-screen keypad to enter the key sequenc e ##2#*#, followed by the green, Send/End icon on the screen.

3. To use or access your phonebook immediately after Pairing:

Switch OFF the ignition for 6 minutes, to allow the vehicle Bluetooth system to complete the download process.

4. Switch ON the ignition.

The download should now have completed successfully.

Note: Should you not wish to switch off the ignition for 6 minutes at this time, the phone book will be displayed after the next normal ignition off cycle that elapses for that duration.

Reason for Ignition OFF for 6 Minutes

The Bluetooth phone module in the vehicle remains active for 6 minutes after the ignition has been switched off.

It is important to wait this 6 minutes so that a clean boot-up of the Bluetooth module is achieved and the correct information is stored.

Quick Overview

Once a phone has been Paired with the vehicle system, it will not need to be done again unless the vehicle battery is disconnected, or possibly if the system closes down for security reasons, or if you choose to Pair a different phone with the system - only one phone at any time can be Paired with the system.

To pair a different phone with the system

If you attempt to Pair a different phone immediately after switching ON the ignition and the last Paired phone is NOT available, you will have 2 minutes within which to enter the the digit sequence

##3#*# to put the system into Discover Me mode.

This is because, when the ignition is switched ON, the system is looking for the last Paired phone and if it does not find it the system will revert to the Handset in Use screen.

To Pair a different phone, select Phone Mode and use the keypad to enter the following digit sequence ##3#*#.

Then, refer to Page 7 at the Discover Me screen.

If the screen displays - Registered

If the ignition is switched to Accessory or to the ON position for a short period of time, then switched OFF and ON again, the message di splayed subsequently may change to Registered (instead of Discover Me or No BT Phone or Phone Connected).

This is not due to a fault. It is because the system has sensed an incorrect shut-down of the Bluetooth module - that is, it has not been allowed to follow its normal closing down procedure time of 6minutes.

However, the state of the five bars still indicates the correct (current) status of the system. You can still Pair a phone to the system and use the system as normal.

When the system changes from one mode to another (for example, Discover Me to Phone connected) the Registered message will disappear.

Press the green Send/End icon to initiate the Pairing process again and to overwrite the previously Paired phone.

Quick Overview

AUDIO SYSTEM

The buttons used in the following Audio System instructions:

Phone Mode button, to manually select the phone mode. Located to the left of the Audio panel display. Send/End button. Located to the left of the Audio panel display.

Switching ON the ignition

Each time the ignition is switched on, the following screens may be displayed.

This screen may be displayed for a few seconds while the system is performing a self-check.

After the brief system check, you should see the following screen:

This screen will be displayed to indicate one of two possible conditions:

1. There is no phone currently Paired to the vehicle system or no phone is available. Should this be the case, this screen will continue to be displayed while the system is in phone mode (the system may display the SIG**** or SIG***** screen ready for you to Pair your Bluetooth mobile phone).

Quick Overview

Pairing your phone

The following instructions describe how to initiate Pairing your mobile phone to the Jaguar system.

If there is no mobile phone Paired to the vehicle system and the SIG screen is displayed, Pairing may be performed as follows:

Select Phone Mode (if not already selected).

Use touch-screen keypad to enter the following digit sequence and press the Send/End button.

##3#*#

The display will then show the following screen.

Check that your mobile phone is set to the Jaguar Bluetooth system, using the menu functions on the phone. Refer to the handbook that was supplied with your specific mobile phone.

When Jaguar device is found on the mobile phone display, the phone will prompt you to enter the pass key (1313) on the mobile phone keypad.

When the above operation has been completed and the phone is successfully Paired and connected with the vehicle system, the SIG* screen will be displayed.

Note: The screen may briefly change from SIG**** to SIG whilst the system connects

the Bluetooth link, before the SIG* screen is displayed.

At the SIG**** screen the vehicle system is waiting for communication with a Bluetooth equipped telephone.

Quick Overview

Downloading your phonebook entries

The Phonebook entries on your mobile phone can be downloaded from your phone to the vehicle system, dependent on the capability of the mobile phone.

For more information, refer to the specific Quick Guide (available from your Jaguar Dealer or Authorised Repairer) for your phone.

The following process will only work with specific phones. The phone must be ON and already Paired with the Jaguar system.

1. Press the vehicle phone mode button. (If not already in Phone Mode.)

2. Use the Audio panel keypad to enter the key sequence ##2#*#, followed by pressing the Send/End button.

3. To use or access your phonebook immediately after Pairing:

Switch OFF the ignition for 6 minutes, to allow the vehicle Bluetooth system to complete the download process.

4. Switch ON the ignition.

The download should now have completed successfully.

Note: Should you not wish to switch off the ignition for 6 minutes at this time, the phone book will be displayed after the next normal ignition off cycle that elapses for that duration.

Reason for Ignition OFF for 6 Minutes

The Bluetooth phone module in the vehicle remains active for 6 minutes after the ignition has been switched off.

It is important to wait this 6 minutes so that a clean boot-up of the Bluetooth module is achieved and the correct information is stored.

Quick Overview

To pair a different phone with the system

If you attempt to Pair a different phone immediately after switching ON the ignition and the last Paired phone is NOT available, you will have 2 minutes within which to enter the the digit sequence ##3#*# to put the system into SIG**** mode.

This is because, when the ignition is switched ON, the system is looking for the last Paired phone and if it does not find it the system will revert to the Handset screen and drop out of Phone Mode.

To Pair a different phone, select Phone Mode and use the keypad to enter the following digit sequence ##3#*#.

Press the Send/End button to initiate the Pairing process again and to overwrite the previously Paired phone.

Then, refer to Page 11 at the SIG**** screen.

+ 28 hidden pages