HOOVER HGH 640 1 B, HGH 640 1 SW, HGH 640 1 SB, HGH 640 1 SX, HGH 640 1 W User Manual

GB IE HOBS

USER INSTRUCTIONS

Grafica RB - 09-2005 - Cod. 41017810 - Imprimè en Italie

HOOVER - Via Privata Eden Fumagalli - 20047 Brugherio (Milano) - Italy

Tab. 1

BUILT IN HOBS

Burners/hotplates

4 a gas

5 a gas

Type / reference

PL 03/PL 04

PL 73/PL 74

Flame failure device

- / si

- / si

Little burner

AUS ø 50 mm

1

1

Double ring burner

QC ø 135 mm

Ultra rapid burner

UR ø 110 mm

1

1

Semirapid burner

SR ø 75 mm

1

1

Rapid burner

R ø 100 mm

Griddle 174x160 mm

Griddle 229x379

Electric plate

ø80

PE

Electric plate

ø145

PE

Electric plate

160x265 mm PE

Installed gas Type/Power:

G20 20mbar*

(METHANE)

8,75 kW

11,25 kW

G30 28-30mbar

(GPL)

636 g/h

818 g/h

Installation class

Voltage/Frequency

V/Hz

220-240/50

220-240/50

Electrical imput power

Electronic ignition

si

si

Product dimension WXD (mm)

* Manufacturer setting

IE cat. II2H3 +

GB cat. II2H3 +

This appliance has been designed for non-professional, i.e. domestic, use.

GB IE

1

INSTRUCTIONS FOR THE INSTALLER

INSTALLATION

The Purchaser is responsible for the installation of the hob. The Manufacturer does not accept any responsibility for any damage or loss resulting from incorrect installation, and as such this will not covered by the Manufacturer’s Guarantee.

The hob may be installed in any worktop which is heat resistant to a temperature of 100° C, and has a thickness of 25 - 45 mm. The dimensions of the insert to be cut out of the worktop are in shown in Fig. 1.

If the Hob is fitted next to a cabinet on either side, the distance between the Hob and the cabinet must be at least 15 cm (see Fig. 2); while the distance between the hob and the rear wall must be at least 5,5 cm.

The distance between the hob and any other unit or appliance above it (e.g. An extractor hood) must be no less than 70 cm (fig.2).

When there is an accessible space between the built-in hob and the cavity below, a dividing wall made of insulating material should

be inserted (wood or a similar material) (fig. 3).

Important - The diagram below shows how the sealant should be applied.

Plan 60

Plan 75

The Hob unit is fitted by attaching the Fixing

Clamps supplied, using the holes at the base of the unit.

Fig. 1

accessible space

Fig. 2

Fig. 3

2 GB IE