HK630
Integrated Amplifier
Service MANUAL
Troubleshooting
ENGLISH
This unit is designed for trouble-free operation. Most problems users encounter are due to operating errors. So, if you have a problem, first check this list for a possible solution. If the problem persists, consult your authorized Harman/Kardon Service Center.
IF THE PROBLEM IS... |
MAKE SURE THAT... |
No lights illuminate when POWER cord is plugged into AC outlet |
• The unit is plugged into a live outlet |
|
|
No sound is heard |
• Speaker switches corresponding to the desired speakers are pressed |
|
• Correct source button has been pressed |
|
• Volume is turned up |
|
• Speaker wires are connected properly |
|
• Hook-up wires to source component are connected properly |
|
|
Sound is not heard from the speaker system on one side |
• The speaker wires and connection wires are connected correctly |
|
• The balance control knob is set to the center |
|
|
When listening to stereo sound, the left and right sounds are reversed |
• The speaker wires are connected correctly |
|
• The wires between components are connected correctly |
|
|
Intermittent or continuous buzzing or hissing |
• The unit is away from fluorescent lights, TV, motors and other electrical appliances |
|
|
The remote control and front panel controls don't appear to work |
• Disconnect the AC line cord from the wall socket, wait 5 minutes and then re-connect it |
|
|
Phone sound is too faint, has hum, ringing, or »howl« |
• Ground wire from turnable has been connected to ground terminal on amplifier |
|
• Cable from turntable is away from power cords and speaker cables |
|
• Turntable is away from speakers |
|
• Turntable is on stable surface |
|
|
Specifications
|
|
HK630 |
|
|
NOMINAL |
Continuous Average Power Per Channel (FTC) |
8 Ohms: |
40 Watts@<0.09%THD |
20Hz – 20 kHz, both channels driven |
4 Ohms: |
60 Watts@<0.3%THD |
|
|
|
Dynamic Power (IHF, 1kHz Tone Burst) |
8 Ohms: |
70 Watts |
|
4 Ohms: |
100 Watts |
|
2 Ohms: |
135 Watts |
|
|
|
High instantaneous current capability (HCC) |
|
±40 Amps |
|
|
|
Power Bandwidth @ Half-Rated output, 8Ω |
|
<10Hz - 100kHz |
|
|
|
Frequency response @ 1W (+0/-3dB) |
|
0.5Hz - 100kHz |
|
|
|
Damping factor |
|
120 |
|
|
|
Signal-to-noise Ratio (Reference rated power output, A-WTD) |
Tuner/CD |
90 dB |
|
Phono (MM): |
80 dB |
|
|
|
Input sensitivity/Impedance |
Tuner/CD |
150mV/43kΩ |
|
Phono (MM): |
2.5mV/47kΩ, 125pF |
|
|
|
Phono-Overload: |
Phono (MM): |
100 mV |
|
|
|
Tone control range, Bass @ 50 Hz/Treble @ 10kHz |
|
±10 dB/±10 dB |
|
|
|
Power supply: |
|
AC 230V, 50/60 Hz |
|
|
|
Power consumption: |
|
230 W |
|
|
|
Dimensions (Width × Height × Depth): |
|
443 × 91 × 359 mm |
|
|
|
Weight: |
|
6.4 kg |
|
|
|
ENGLISH