380-2 / C-380
380C-2 / C-380C
Please read these instructions before use Veuillez lire ce Mode d’emploi avant utilisation Favor de leer estas instrucciones antes del uso
ENGLISH
FRANÇAIS
ESPAÑOL
Get More Done Today™
N
|
B |
A |
E |
|
|
|
C |
|
P |
L
M
D
C
|
I |
|
J |
|
|
K |
|||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
F
G |
H |
|
Dear Customer,
Thank you for buying a Fellowes Commercial Shredder. We have made many improvements in our commercial shredder since its introduction in 1982. We are confident that it offers you the greatest value for your money in its product category today. We hope it meets – or even exceeds – your expectations.
To ensure years of safe, efficient use, please read these few pages about your new shredder. If this manual doesn’t answer all your questions or if you wish to comment on this product, we welcome your call or letter.
Sincerely,
James Fellowes
Chairman & CEO
Contents
Product Profile . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Set-Up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
Supplies . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7
2
Product Profile
This product is built to shred paper, staples, CDs, DVDs, small paper clips and credit cards. It is not built to shred adhesive labels, transparencies, newspaper, cardboard, large paper clips, or plastic (other than credit cards). Attempting to shred items not intended for this shredder may cause damage.
|
|
Strip-Cut |
Confetti-cut |
|
|
380-2 |
380C-2 |
|
Paper |
|
|
Sheet capacity* |
26-28 sheets |
14-16 sheets |
|
Paper shred size |
7/32” / 5,8 mm |
5/32 X 1-1/8” / 3,9 x 30 mm |
|
Maximum paper width |
15” / 380 mm |
15” / 380 mm |
|
Recommended daily capacity |
14,000 sheets |
7,000 sheets |
|
Credit cards |
|
|
|
Credit card capacity |
1 |
1 |
|
Recommended daily capacity |
150 |
150 |
|
CDs/DVDs |
|
|
|
CD/DVD capacity |
1 |
1 |
|
Recommended daily capacity |
150 |
150 |
*Based on 8-1/2 x 11” (75 g/20 lb.) paper with shredder operating at rated voltage; heavier paper, high humidity, or other than rated voltage may reduce sheet capacity.
NOTE: These products have met international standards for motor temperature rise: Independent product testing agencies approved each model at the midpoint of its sheet-per-pass limit. In the tests, the agencies also varied the available voltage 10% below and 6% above its normal range, stopping shredding only to empty the basket.
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING
While setting up shredder
•Check shredder for damage or defects; some paper particles in the basket are normal due to product testing and does not indicate a defect.
•If the cord is damaged do not replace cord or use the machine. Return machine for a replacement.
•Avoid touching exposed blades on underside of confetti-cut shredder head.
•Plug power cord in an outlet that can easily be reached. The plug is the primary electrical disconnect.
•Make sure the electrical rating listed on the serial label (located near the power cord on the back of the shredder) matches the available electric power.
•Do not place shredder near or over a heat or water source.
•Secure shredder to wall with hardware provided in order to meet UL 60950 stability requirements.
While operating shredder
•Keep hands and hanging objects (jewelry, ties, loose clothing, long hair, etc.) away from paper entry.
• Keep children and pets away from the shredder.
When not in use
•Always turn off and unplug shredder.
•Unplug before emptying basket.
•Do not open shredder head: Danger of electric shock. Opening shredder head will void the warranty.
NOTE: Do not use flammable synthetic oil, petroleum-based products or aerosols of any kind on or near product at any time.
ENGLISH
3
ENGLISH
Set-Up
•Open the cabinet door and pull the waste basket (D) completely out of the cabinet.
•Put plastic waste bag in basket (sample bags provided). Allow bag edges to overhang. Contact Fellowes to order more bags (part # 36055).
•Slide the waste basket into the cabinet and shut the cabinet door (A).
•Plug the power cord into a convenient outlet.
•Store this use and care manual in slot (M) inside cabinet door (A).
Operation
Control Switches
I |
J |
K |
Control Switch (H) |
||
I |
AUTOMATIC |
||||
|
|
|
|||
|
|
|
|
Turns on the automatic-start |
|
|
|
|
|
sensor and the green Ready |
|
F |
|
|
|
light. |
|
|
|
O |
OFF |
||
|
|
|
|||
|
|
|
|
Turns off the automatic-start |
|
|
|
|
|
sensor and the green Ready |
|
|
|
|
|
light. |
|
G |
|
|
R |
REVERSE |
|
|
|
|
Runs shredder in reverse |
||
|
|
|
|
Hmode. Press and hold to activate.
Manual Forward Button (F)
Runs shredder when button is held down.
Troubleshooting Lights
Ready Light (G) |
Paper Jam (I) |
Basket Full (J) |
Door Ajar (K) |
(Green) |
(Red) |
(Red) |
(Red) |
Shredder is in auto- |
Shredder is jammed |
Waste basket is full or |
Cabinet door is open. |
matic start mode. |
(e.g., too much paper |
paper has collected |
|
|
fed at one time). |
under cutting cylin- |
|
|
|
ders. |
|
For convenience and energy savings, your shredder is equipped with an automatic-start sensor (P). This means that when the control switch (H) is in the automatic [I] position, the shredder will start running when you put paper into it and stop a few seconds after the paper has passed through.
CAUTION: The automatic-start sensor cannot tell the difference between paper and other objects. This feature can also be a hazard. Always turn off the shredder when it is not in
use. Unplug the shredder if it will not be used for an extended period.
To shred paper
•Press the automatic [I] button. The green ready light (G) should turn on.
•Feed paper straight into paper entry (B) releasing when the shredder begins shredding.
To shred CDs or DVDs
•Hold CD or DVD at the edge and feed one at a time, straight into CD entry (E), releasing when shredding begins. Shredder will stop when media has passed through entry. The media will be shred into small
particles.
CAUTION: Do not hold CD or DVD with finger through the center ring while feeding into shredder.
4
To empty waste basket
If basket full light (J) is on, follow these steps until light turns off.
•Press manual forward button (F) to finish shredding any paper in the paper entry.
•Press the off [O] button.
•Open the cabinet door (A) and pull out the waste basket (D).
•Remove the full bag and replace with a new bag.
•Slide the waste basket (D) into the cabinet and shut the cabinet door (A).
To clear a paper jam
If paper jam light (I) is on, follow these steps until light turns off.
•Check the waste basket (D) and empty the bag if full.
•Press and hold the reverse [R] button to back paper out of the paper entry (B). Try pulling gently on the paper to remove it from the shredder.
•Alternate between forward and reverse, as needed, until the jam clears:
–Press and hold the manual forward button (F) for a few seconds.
–Press and hold the reverse [R] button for a few seconds.
•Continue alternating between forward and reverse until the jam clears.
CAUTION: The shredder may be damaged if you alternate too rapidly between forward and reverse.
•Unplug shredder, open cabinet door (A) and remove wastebasket (D).
•Carefully clear any paper shreds that have collected on under side of paper entry (B).
CAUTION: Model 380C-2 (confetti cut model) has exposed blades on underside of paper entry. Use care when removing paper shreds.
Maintenance
Empty waste basket regularly to ensure the smooth functioning of the cutting cylinders. The shredder will not operate when the basket is full.
Oil confetti-cut model (380C-2) regularly to ensure proper operation.
If used at or near daily capacity, apply oil every time you empty the basket.
Use Fellowes Powershred Lubricant #35250 or other non-aerosol vegetable-based oil in a longnozzle container (sample oil provided).
CAUTION: Do not use flammable synthetic oil, petroleum-based products, or aerosol lubricants of any kind.
To oil the cutting cylinders
• Lift paper entry flap (N) and apply oil over full width of cutting cylinders through the paper entry (B).
•Press and hold the manual forward button (F) for at least 3 seconds.
•Press and hold the reverse [R] button for at least 3 seconds.
•Repeat the forward/reverse sequence 3 or more times.
•Store oil bottle in slot (L) inside cabinet door (A).
ENGLISH
5
ENGLISH
Troubleshooting
If there is a problem with your shredder, check these symptoms and remedies. If you cannot solve the problem, call your local dealer or contact Fellowes directly. Do not open shredder head to attempt repair. You could be exposed to serious electric shock and will void the warranty.
|
Symptom |
Remedy |
|
|
Ready Light (G) will not light |
Make sure shredder is plugged in. |
|
|
|
Press the automatic button [I]. |
|
|
|
|
|
|
Shredder does not start or stops |
• Make sure shredder is plugged in. |
|
|
while shredding |
Check Troubleshooting lights. |
|
|
|
• Clear paper jam. Follow the |
|
|
|
instructions under Operation. |
|
|
|
|
|
|
Door ajar light (K) is on |
Make sure the cabinet door (A) is closed. |
|
|
|
|
|
|
Basket full light (J) is on |
Empty the waste basket. Follow the instructions |
|
|
|
under Operation. |
|
|
|
|
|
|
Paper jam light (I) is on |
Clear paper jam. Follow the |
|
|
|
instructions under Operation. |
|
|
|
|
|
|
Confetti-cut shredder (380C-2): Shredder sheet |
Oil the cutting cylinders. Follow the instructions |
|
|
capacity decreases, noise level increases, or cut- |
under Maintenance. |
|
|
ting cylinders stop with a squeak or rubbing |
|
|
|
sound |
|
|
|
|
|
|
|
Shredder runs for a few seconds after the paper |
No action required. This is a self-cleaning |
|
|
has cleared the cutters |
function. |
|
|
|
|
|
Supplies
The following items for the 380-2 and 380C-2 shredders are available from Fellowes:
Item |
Quantity |
Part Number |
Waste bags (in dispenser) |
50/roll |
36055 |
Waste basket (box) |
1 box |
205396 |
Powershred Lubricant (380C-2 only) |
12 oz. bottle |
35250 |
To purchase supplies, contact Fellowes at the appropriate location listed on the back page of this instruction manual, or visit us at www.fellowes.com.
6