Please read these instructionscarefully before using your cleaner.
Let us help you put your vacuum together or answer any questions, call:
1-877-REGINA6
(USA & Canada)
Cleaner assembly may include small parts.
Small parts can present
For quick reference, please record your vacuum information below.
Model #:
Mfg. Code:
a choking hazard.
(Mfg. code located on the lower backside of cleaner)
THlS CLEANER IS INTENDED FOR HOUSEHOLDUSE ONLY.
IMPORTANT SAFETY INSTRUCTIONS
When you use an appliance, basic precautions should be followed, including the following:
READ ALL INSTRUCTIONSBEFORE USING THE APPLIANCE.
ALWAYS FOLLOWTHESE SAFETY INSTRUCTIONS.
BRING CLEANER TO UPRIGHT POSITIONWHEN USING THE HOSEAND ATTACHMENTS.
DO NOT LEAVE CLEANER UNA'ITENDEDWHEN PLUGGED IN.
REGULARLY CHECK THE FILTERSTO CLEAN OR REPLACE.
WARNING: DO NOT USE SHARP OBJECTS TO CLEAN OUT THE HOSE SINCE
THEY COULD CAUSE DAMAGE.
OCCASIONALLY REMOVE BRUSH AND CLEAN DEBRIS FROM END CAPS TO
KEEP BRUSH ROTATING SMOOTHLY.
WARNING: THE CORDS, WIRES, AND/OR CABLES SUPPLIEDWITH THlS PRODUCT CONTAINS CHEMICALS, INCLUDING LEAD OR LEAD COMPOUNDS, KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER AND BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM. WASH HANDS AFTER USING.
READALL INSTRUCTIONSBEFOREUSINGTHEAPPLIANCE,
WARNING: TO REDUCETHE RISK OF FIRE,
ELECTRIC SHOCK OR INJURY:
Do not leave appliance when plugged in. Unplugfrom outlet when not in use
and before servicing.
Do not use outdoors or on wet surfaces. Electrical shock could occur.
Do not allow to be used as a toy. Close attention is necessary when used by
or near children.
Use only as described in this manual. Use only manufacturer'srecom-
mended attachments.
Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service centerfor inspection. Call 1-877-REGINA6for the nearest service center.
Do not pull or carry by cord, use cord as handle, close a door on cord, or pull cord around sharp edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.
Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
Do not handle plug or appliance with wet hands.
Do not put any objects into openings. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce air flow.
2
Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
Do not use without dirt container and filters in place. Turn off all controls before unplugging.
Use extra care when cleaning on stairs.
Do not use to pick up flammable or combustible liquids, such as gasoline, or use in areas where they may be present.
Keep the vacuum cleaner on the floor. Only the hand-held vacuum cleaners may be set on furniture.
Cleaner must be in the upright position to lift the rotating brush off the carpet when doing above floor cleaning.
Do not use an extension cord with this vacuum cleaner.
Store the vacuum cleaner indoors. Put the vacuum cleaner away after use to prevent tripping accidents.
Using improper voltage may result in damage to the motor and possible injury to the user. Proper voltage is listed on the cleaner plate.
SAVE THESE INSTRUCTIONS
WARNING:
To reducethe risk of electric shock, this appliance has a polarizedplug (one blade wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.
II
II
CONGRATULATIONS
You are now the proud owner of a Reginaa. We trust your new purchase will bring you many years of satisfaction.
Our company designedand developedthis product with you in mind.
We are very proud of our products and hope that you are equally satisfied with their quality and performance.
Thank you for your support of Regina' products.
TABLE OF CONTENTS
Safety Instructions............................................ |
Page 2, 3 |
Feature Descriptions........................................ |
Page 5 |
How to Assemble............................................. |
Page 6 |
Body to Nozzle Assembly........................... |
Page 6 |
Tool Caddy Assembly................................ |
Page 6 |
Handle to Body Assembly........................... |
Page 6 |
How To Operate............................................... |
Page 7, 8 |
FloorICarpetCleaning......................... |
-.....Page 7 |
Above Floor Cleaning................................. |
Page 8 |
Dirt Container & Filtration: Removal |
Page 9 |
and Replacement ...................................... |
|
Belt or Brush: Removal & Replacement.......... |
Page 10 |
Troubleshooting Guide..................................... |
Page 11 |
LIMITED WARRANTY
To the consumer, RoyalAppliance Mfg. Co. warrants this vacuum cleanerto befree of defects in material or workmanship commencing upon the date of the original purchase. Refer to your vacuum cleaner carton for the length of warranty and save your originalsales receiptto validate start of warranty period.
If the vacuum cleaner should becomedefectivewithin the warranty period, we will repair or replaceany
defective parts free of charge. The complete machine must be delivered to any ROYALm Authorized Sales & Warranty Sewice St?tion. Please includecomplete descriptionof the problem, day of purchase, copy of orlglnal sales recelpt and your name, address and telephone number. If you are not near a Warranty Station, call the factory for assistanceat USA & Canada:
1-877-REGINA6. Use only genuine Royal* replacementparts.
The warranty does not include unusual wear, damage resulting from accident or unreasonable use of the vacuum cleaner. This warranty does not cover brushes, flat belts, filters and bulbs. This warranty does not cover unauthorized repairs. This warranty gives you specific legal rights and you may also have other rights (Other rights may vary from state to state in the USA).
FRONT VlEW |
BACK VlEW |
|
FRONT VlEW |
|
BACK VlEW |
|
|
9. |
Cord Guide |
||
1. |
Handle |
|||
10. |
Hose |
|||
2. |
Dirt Container Release Latch |
|||
11. |
2-in-1 Tool-Dust Brush I |
|||
3. |
Dirt Cup Lid |
|||
|
Upholstery Tool |
|||
4. See Through Dirt Container |
|
|||
12. |
Crevice Tool |
|||
5. |
Dirt Cup Filter |
|||
13. Carrying Handle/Upper Cord Wrap |
||||
6. |
Bumper |
|||
14. |
Long Power Cord |
|||
7. |
'ClearDirt Window |
|||
15. Cord Wrap with Quick Cord Release |
||||
8. |
Lower Hose |
|||
16. |
Handle Release Pedal |
|||
|
|
|||
|
|
17. |
OnlDff Pedal |
|
|
|
18. |
Extension Wand |
|
|
|
19. |
Hose Clip |
|
~ ~I ~ ' ~ l : ~ ~
TOOL REQUIRED: PHILLIPSOR FLAT HEAD SCREWDRIVER
Assemble the body to the base so that the lower hose is on the right side.
Align Tool Caddy holes with holes on handle.
To secure, insert one (1) screw into the back of the cleaner, above the onloff switch.
Insert two (2) screws into the holes and tighten until secure.
Push back dirt window flap. Align tabs on clear dirt passage window with the slots oithe lower hose cuff. Push and turn to lock into place (inset).
Place upper handle onto |
Push upper handle down |
Insert one (1) screw (sup- |
upright. |
onto upright. |
plied) into the back of the |
|
|
cleaner to secure handle. |
Insert the short end of the hose onto the tool caddy holder. .on the right side.
Tip bottom of dirt cup into cleaner and push forward. Dirt cup lid will snap into handle.
HANDLE RELEASE
To release the handle, push the handle release pedal located on the lower left side of the cleaner.
Insert hose handle into the left side of the cleaner. Press downfirmly. Presshose into top and sides of tool caddy.
TOOL STORAGE
Attachtools: (a) Slidethe2-in- 1tool onto post on the back panel. (b) Slide the crevice tool into mund slot on right sideoftoolcaddy. (c) Slidethe extension wand into mund slot on left side of tool caddy.
CORD RELEASE
Use the cord guides to store the cord out of the way while vacuuming.
Assemble dirt cup lid to the dirt cup.
ONIOFF PEDAL
Plug cord into electrical outlet. Turn cleaner on by depressing foot pedallocated on the back left side of the cleaner.
FLOORICARPn
CLEANING
Movethe handleand adjust it to the desired positionfor (a) storingthe upright, (b)operating the cleaner, and (c) depressthe handlereleasepedal againto clean underfurniture.
Cleaner must be in the upright positionto liflthe rotation brush off the carpet when cleaning abovethe floor.
ABOVE FLOOR CLEANING
Cleaner must be in its upright position. Remove lower hose from the side of the cleaner by twisting to the right and then pull off.
Remove the hose from the |
Slide the tool hose into the |
tool caddy. |
lower dirt hose with the |
|
notch facing up. Push |
|
togetherand twist to secure. |
EXTENSION WAND |
CARRY HANDLE |
Choose any of the handy accessories or use the hose alone. Simply push the attachment firmly onto the end of thewand or hose handle. To removetool, twistand pull apart gently.
If additionallengthis needed, usethe extensionwand.
Use the carry handle on the back of the cleaner to move the cleaner from room to room.
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE SERVICING. For filter replacement (uses Dirt Devila Part # 2400280-000). Please call 1-877-REGINA6to locate a dealer nearest you.
NOTE: Unplug cleaner before changing filter. NOTE: For best performance, replace filter yearly.
EMPTY AND CLEAN DIRT CONTAINER
Depress latch to remove dirt container from cleaner.
Twist and pull the filter up and out.
Remove lid by grasping both handles and turning lid counterclockwise.
Cleanfilter andemptydirtcontainer completely. See "Regular Maintenance" note below for instructions on cleaningthe filter.
Hold the dirt container and grasp the top of filter.
Return filter to dirt container. Pushfilter intoplaceto prevent dirt leakage. Return dirt container to cleaner.
'REGULAR MAINTENANCE: Each time the dirt container is emptied, the filter should be cleaned. Tap the filter firmly against the inside of a trash can until the dirt stops falling from the filter. ((Fier will be discolored after use, this will not affect the filter's performance.) Do not brush the filter. The cleaning instructions may vary depending on the dirt conditions. In some cases, more or less cleaning of the filer may be required.
TOOL REQUIRED: PHILLIPSSCREWDRIVER
WARNING: TO REDUCETHE RISK OF INJURY FROM MOVING PARTS -
UNPLUG CLEANER BEFORE CHANGING BELT OR BRUSHROLL. |
USES DIRT |
|
TO REMOVE BELT
Lay cleaner flat and flip cleanLift nozzle guard off. Slide belt off motor shaft.
erto expose nonle base. Base |
|
|
shouldlay tlat and face up. To |
|
|
remove node guard, use |
|
|
Phillipsscrewdriverto remove |
. |
|
the four (4) screws. Arrows |
||
|
||
show loeation of screws. |
TO REPLACE BELT OR BRUSHROLL |
|
|
Lift and remove brushroll. Dispose of old belt.
Wm new belt in place, pull and slide brushrollinto nozzle makingsure thatthe brushroll end caps are in the correct orientation (7a inset). Rotate brushroll manually to make sure belt is properlyaligned.
Place new belt in area of brushroll without bristles.
Reattachnozzle guard.
Slide belt onto motorshaft.
Secure by aligning the three
(3)tabs in the base slots. Be sure to replace all four
(4)screws.
10
Loading...