DEGH60STF
DE’LONGHI
COOKING
INSTALLATION and SERVICE INSTRUCTIONS
USE and CARE INSTRUCTIONS
DEGH60STF
GAS COOKTOPS
distributed by
DeLonghi Australia Pty Ltd
DeLonghi New Zealand Ltd
2
PRODUCT LABEL
Dear Customer,
Thank you for having purchased and given your preference
to our product.
The safety precautions and recommendations reported
below are for your own safety and that of others. They
will also provide a means by which to make full use of the
features offered by your appliance.
Please keep this booklet in a safe place. It may be useful
in future, either to yourself or to others in the event that
doubts should arise relating to its operation.
This appliance must be used only for the task it
has explicitly been designed for, that is for cooking
foodstuffs. Any other form of usage is to be considered
as inappropriate and therefore dangerous.
The manufacturer declines all responsibility in the
event of damage caused by improper, incorrect or
illogical use of the appliance or be faulty installation.
This cooktop has been designed and constructed in accordance with the following codes
and specications:
AS 5263.0
AS/NZS 5263.1.1
Approval Requirements for Domestic Gas cooking appliances
AS/NZS 60335.1 General Requirements for Domestic electrical appliances
AS/NSZ 60335.2.102
Particular Requirements for Domestic electrical cooking appliances
AS/NZS CISPR 14.1 Electromagnetic Compatibility Requirements
3
IMPORTANT SAFETY PRECAUTIONS AND RECOMMENDATIONS
IMPORTANT: This appliance is designed and manufactured
solely for the cooking of domestic (household) food and is
not suitable for any non domestic application and therefore
should not be used in a commercial environment.
The appliance guarantee will be void if the appliance is used
within a non domestic environment i.e. a semi commercial,
commercial or communal environment.
Read the instructions carefully before installing and using
the appliance.
■ After having unpacked the appliance, check to ensure that it is
not damaged.
In case of doubt, do not use it and consult your supplier or a
professionally qualied technician.
■ Packing elements (i.e. plastic bags, polystyrene foam, nails,
packing straps, etc.) should not be left around within easy reach
of children, as these may cause serious injuries.
■ Some appliances are supplied with a protective lm on steel and
aluminium parts. This lm must be removed before using the
appliance.
■ IMPORTANT: The use of suitable protective clothing/gloves is
recommended when handling or cleaning this appliance.
■ Do not attempt to modify the technical characteristics of
the appliance as this may become dangerous to use. The
manufacturer declines all responsibility for any inconvenience
resulting from the inobservance of this condition.
■ CAUTION: This appIiance must only be installed in a permanently
ventilated room in compliance with the applicable regulations.
■ Do not carry out cleaning or maintenance operations on the
appliance without having previously disconnected it from the
electric power supply.
■ Do not use a steam cleaner because the moisture can get into
the appliance thus make it unsafe.
4
■ Do not touch the appliance with wet or damp hands (or feet).
■ Do not use the appliance whilst in barefoot.
■ If you should decide not to use this appliance any longer (or
decide to substitute another model), before disposing of it, it
is recommended that it be made inoperative in an appropriate
manner in accordance to health and environmental protection
regulations, ensuring in particular that all potentially hazardous
parts be made harmless, especially in relation to children who
could play with unused appliances.
■ The various components of the appliance are recyclable. Dispose
of them in accordance with the regulations in force in your country.
If the appliance is to be scrapped, remove the power cord.
■ After use, ensure that the knobs/controls are in the off position.
■ Children should be supervised to ensure that they do not play
with this appliance.
■ This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
■ The manufacturer declines all liability for injury to persons or
damage to property caused by incorrect or improper use of the
appliance.
■ WARNING: During use the appliance and its accessible parts
become hot; they remain hot for some time after use.
– Care should be taken to avoid touching heating elements on
the hob.
– To avoid burns and scalds, young children should be kept away.
■ Make sure that electrical cables connecting other appliances in
the proximity of the cooktop cannot come into contact with the
hob.
■ WARNING: Unattended cooking on a hob with fat or oil can be
dangerous and may result in re. NEVER try to extinguish a re
with water, but switch off the appliance and then cover ame e.g.
with a lid or a re blanket.
5
■ CAUTION: The cooking process has to be supervised. A short
term cooking process has to be supervised continuously.
■ WARNING: Danger of re: do not store items on the cooking
surfaces.
■ WARNING: If the hob is cracked or otherwise damaged by falling
objects etc., disconnect the appliance from the electrical power
supply to avoid the possibility of electric shock and call Customer
Service.
■ WARNING: When correctly installed, your product meets all
safety requirements laid down for this type of product category.
However special care should be taken around the underneath
of the appliance as this area is not designed or intended to be
touched and may contain sharp or rough edges, that may cause
injury.
■ CAUTION: The cooking process has to be supervised. A short
term cooking process has to be supervised continuously.
■ If the power supply cable is damaged, it must be replaced only
by an authorized service agent in order to avoid a hazard.
■ DO NOT USE OR STORE FLAMMABLE MATERIALS NEAR
THIS APPLIANCE.
■ DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS
APPLIANCE WHILE IT IS IN OPERATION.
■ DO NOT MODIFY THIS APPLIANCE.
■ THIS APPLIANCE SHALL NOT BE USED AS A SPACE HEATER.
■ WHERE THIS APPLIANCE IS INSTALLED IN MARINE CRAFT
OR IN CARAVANS, IT SHALL
NOT
BE USED AS A SPACE
HEATER.
6
INSTALLATION
CAUTION:
■ Important: The use of suitable protective clothing/gloves is recommended when
handling or cleaning of this appliance.
■ This appliance must be installed in accordance with these installation
instructions, local gas tting regulations, municipal building codes, water
supply regulations, electrical wiring regulations, - Gas Installations and ony
other relevant statutory regulations.
■ The appliance must be housed in heat-resistant units.
■ We would point out that the adhesive which bonds the plastic laminate to the
furniture must withstand temperatures not less than 150°C to avoid delamination.
■ Do not instal the appliance near inammable materials (eg. curtains).
■ This appliance is to be installed only by an authorised person.
■ This appliance shall be only be serviced by authorized personnel.
■ Incorrect installation, for which the manufacturer accepts no responsibility, may
cause personal injury of damage.
■ Always disconnect the appliance from mains power supply before carrying out
any maintenance operations or repairs.
■ In the room where the appliance is installed, there must be enough air to allow
the gas to burn correctly, according to the current local regulations.
WARNING!
When correctly installed, your product meets all safety requirements laid down for
this type of product category. However special care should be taken around the
underneath of the appliance as this area is not designed or intended to be touched
and may contain sharp or rough edges, that may cause injury.
ELECTRICAL REQUIREMENTS
■ The appliance must be connected to the mains checking that the voltage corresponds
to the value given in the rating plate and that the electrical cable sections can withstand
the load specied on the plate.
■ The plug must be connected to an earthed socket in compliance with safety standards.
■ If the appliance is supplied without plug, t a standard plug which is suitable for the
power consumed by the appliance.
■ The wires in the power cable are coloured in accordance with the following code:
Green/Yellow = Earth, Blue = Neutral, Brown = Active.
If the colours of the wires in the power cable to the appliance do not correspond with
the coloured markings identifying the terminals in the junction terminal, proceed as
follows:
1. The wire which is coloured green and yellow must be connected to the terminal
marked “E” (Earth) or “ ” coloured Green.
2. The wire which is coloured blue must be connected to the terminal marked “N”
(Neutral) or coloured Black.
7
3. The wire which is coloured brown must be connected to the terminal marked “L”
(Live) or “A” (Active) or coloured Red.
■ A suitable isolating switch providing full disconnection from the mains power supply
(under overvoltage category III conditions) shall be incorporated in the permanent
wiring, mounted and positioned to comply with the local wiring rules and regulations.
The isolating switch must be of an approved type and provide a 3 mm air gap contact
separation in all poles (or in all active [phase] conductors if the local wiring rules allow
for this variation of the requirements).
■ The power supply cable must not touch the hot parts and must be positioned so that it
does not exceed 50°C above ambient.
■ Once the appliance has been installed, the switch or socket must always be accessible.
■ If the supply cord is damaged it must be replaced by the manufacturer or it’s Service
Agent or a similarly qualied person in order to avoid a hazard.
N.B. The connection of the appliance to earth is mandatory.
If the installation requires alterations to the domestic electrical system call a qualied
electrician.
He should also check that the socket cable section is suitable for the power drawn by the
appliance.
Replacing the power cord must be done by a qualied electrician in accordance
with the instructions supplied by the manufacturer and in compliance with
established electrical regulations.
ELECTRIC DIAGRAM KEY
A Ignition coil
PA Ignition switches group
CA Spark electrodes
M Terminal block
Figure 1
N L
M
A
PA
CA
8
CLEARANCES
Installation clearances and protection of combustible surfaces shall comply with the current
local regulations e.g. AS/NZS5601 - Gas Installations code.
Measures (mm)
A B C D E F
(minimum)
G
(minimum)
580 500 40 (*) 550 470 35 (**) 100 (***)
650 mm
500 mm
450 mm
E
F
D
G
B
A
C
Cooktop
installed
G
100 mm
Space for
connections
Clearance
Door
Thermal
protection
barrier
The thermal protection (to be tted
if the cupboard is to be used for
storage) barrier must be:
• removable with the use of a
tool for installation and service;
• heat-resistant;
• made from low thermal
conductivity material.
Figure 2cFigure 2b
Figure 2a
750 mm
450 mm
9
(*) From top of countertop
(**) Between the back edge of the cut-out and the back of the countertop.
(***) From the side edge of the cut-out to any vertical combustible surface (see also ‘Side clearances’
here below).
IMPORTANT NOTES:
■ THIS APPLIANCE SHALL NOT BE USED AS A SPACE HEATER.
■ WHERE THIS APPLIANCE IS INSTALLED IN MARINE CRAFT OR IN CARAVANS, IT
SHALL NOT BE USED AS A SPACE HEATER.
The installation shall comply with the dimensions in gs.2a, 2b, 2c, 2d bearing in mind that:
■ A minimum clearance of 20 mm has to be kept between the bottom of the cooking
hob and the top of an appliance or a shelf. To ensure this clearance mount the spacers,
supplied with the appliance, as shown in the gure below.
■ A partition between the base of the hob and the cupboard below should be tted 100
mm below the workbench surface if the cupboard is to be used for storage.
■ Overhead clearances - In no case shall the clearance between the highest part of
the hob and a range hood be less than 600 mm or, for an overhead exhaust fan, 750
mm. Any other downward facing combustible surface less than 600 mm above the
highest part of the hob shall be protected for the full width and depth of the cooking
surface area in accordance with local regulations in force. However, in no case shall
this clearance to any surface be less than 450 mm.
■ Side clearances - Where the dimension from the periphery of the nearest burner to
any vertical combustible surface is less than 200 mm, the surface shall be protected
in accordance with with local regulations in force to a height of not less than 150 mm
above the hob for the full dimension (width or depth) of the cooking surface area.
Where the dimensions from the periphery of the nearest burner to any horizontal
combustible surface is less than 200 mm, the horizontal surface shall be greater than
10 mm below the surface of the hob, or the horizontal surface shall be above the trivet
(see requirement for vertical combustible surfaces above).
■ Protection of combustible surfaces - Local regulations in force specify that where
required protection shall ensure that the surface temperature of the combustible
surface does not exceed 65 °C above ambient. The xing of 5 mm thick ceramic tiles
to the surface or attaching re resistant material to the surface and covering with sheet
metal with minimum thickness of 0.4 mm should be satisfactory.
20 mm
Figure 2d
Loading...