DYWS4 Wine Dispensing System |
QUICK START |
|
GUIDE |
||
|
WARNING |
● Read all instructions in the use and care manual before |
|
operation. |
●EXCESSIVE WEIGHT WARNING: Two people are required to safely move this appliance.
●Use only the gas regulator and argon gas cylinders included with the system.
Instructions:
STEP 1 Move the wine dispensing system to a location with a
electrical tion.
STEP 2 |
Plug one |
|
inert gas |
|
(see below) |
STEP 3 |
Make sure |
|
supply (black |
|
connected |
|
back of the |
Proper Air Flow
120 Vac power cord connects to power supply
Plastic gas tubing connects here
Power supply
Connect to 120 Vac, 60
Hz. electrical outlet
Gas and Electrical Connections
Part No. 107499 Rev. A
Wine Dispensing System
STEP 4 Open the door on the front of the
system. Swing the spout cover to the Spout cover
up position.
STEP 5 Make sure the power switch, located on the left side of the bottle bay, is slid all the way down, to the OFF
position.
ON SERVICE MODE RESERVED OFF
STEP 6 |
Find the |
|
|
that comes |
|
|
sure the |
|
|
is turned all |
|
|
direction. |
|
STEP 7 |
Connect |
|
|
the wine |
|
|
gas connector |
|
|
sembly. |
|
STEP 8 |
Remove |
|
|
top of the |
|
STEP 9 |
Insert the |
|
|
into the |
|
|
tor assembly |
|
|
by hand, |
|
|
use a wrench or overtighten. |
Argon |
STEP 10 |
Turn the regulator knob in the ON |
gas |
cylinder |
||
|
direction until it stops. |
|
Regulator adjustment knob
Gas supply line from wine dispensing system
The required argon is not shipped with and must be ordered
. Order on-line at www. everythingdacor.com or by calling Dacor Customer Service at (800) 793-0093 ex. 2822. Your first gas argon gas cylinder is provided free of charge.
STEP 11 Plug the power cord into the grounded 120 Vac., 60 Hz. electrical outlet.
STEP 12 Slide the power switch all the way up to the ON position. When powering on, the system will run through a series of diagnostics, which will take several seconds. If the control panel is locked, perform the following steps:
•Slide the power switch down one notch to the SERVICE MODE position (see diagram at top of page).
•Push WineStation Service next to any of the displays.
•Push Exit.
•Slide the power switch up to the ON position.
Page 2