Opticom BFA-BFC
Electronic controls
Use
Visual information on displayManual mode
Possible manual change in the program during useAutomatic mode, possible to save up to 30 cyclesEasy programming of each stage of the cycle
The use of the “unloading procedure” key stops the ventilators before the door opening, to avoid outside air intake to avoid frost build-up
Automatic management of end of cycle dayFault management
Antishock, watertight & smooth surface key board
The advantages
Automatic management of proofing cycles
Temperature managementManual and automatic mode30 cycles pre-memorized
Automatic management of the end of cycle day
Fault management
According to standards
Bongard reserves the right to alter the characteristics of the models without prior notice - 06/2010