Performance
BSP 46.5 : 5 trays 400 x 600 mmBSP 46.9 : 9 trays 400 x 600 mmBSP 46.15 : 15 trays 400 x 600 mmElectromechanical control panel
Door handle side on the left
The advantages
3 models
Fast freezing mode
“special cold” ventilation fanRefrigerating fluid R 404 A which preserves the ozone
layer
Stainless steel interior panels for an easy cleaning
Right or left door handle sideEasy to move
Easy to remove single-piece tray slide rack
According to 
standards
BSP
Reach-In Blast freezer
Use
The blast freezing BSP is designed to blast chill and blast freeze the product before conservation mode.
Operating principle
With its electromechanical control which autonomously controls the temperature and time needed to freeze products, the BSP is capable of controlling cold production to reach -18°C at core, as rapidly as possible (7 kg to 20 kg of raw baguettes per hour, depending on the model). Once this temperature has been reached, it regulates it for 24 hours and automatically switches to storage mode at the end of cycle.
BSP features :
Opticom control panel (option)Ventilation stops at door openingConnecting power 230 V.
Manual defrosting through ventilation with door open
Blast freezing or blast chilling with pin type sensor or timerBuzzer at the end of cycle (timer)
Construction
Built-in compressor
Refrigerating fluid R 404 A which preserves the ozone layer
Isothermal panel (80 mm thick) made of injected polyurethane foam 40 Kg/m3
Stainless steel interior panels, pre-lacquered, painted and coated with a protective polyethylene covering on the outside
Sheet panels of evaporators in stainless steelPanels assembled by eccentric hooks
Spacing of 75 mm
Doors equipped with magnetic gasket with closing feature by spring pivot, easy to remove without tools
Easy accessible heated seals around doors
Important remarks
The drainage is located at the rear of cabinet.
The blast freezer must be placed in a ventilated area and within a positive room temperature (between +13°C to +30°C)
|
|
|
109 |
Bongard reserves the right to alter the characteristics of the models without prior notice - 12/2011 |
|
|
||
|
|
|
Loading...