Transmitter and Charger for the Apple iPod®. This product
features patented wireless technology and is engineered to
provide easy listening to your favorite tunes while on the
road. The mobile FM transmitter sends high-fidelity stereo
signals from any iPod to your FM car radio or stereo within
15 feet.
Simple and convenient, the mobile FM transmitter and
charger transmits all FM frequencies and simultaneously
charges your iPod.
Aerielle Enabled is a trademark of
Aerielle Technologies, Inc.
Important safety instructions
Read these instructions thoroughly before using your
mobile FM transmitter and charger.
Do not attempt to set up or tune your mobile FM
transmitter while your vehicle is in motion.
Do not attempt to open the casing of the mobile FM
transmitter. Doing so voids your warranty.
Do not allow moisture of any kind to come in contact with
the mobile FM transmitter. Keep away from humidity and
never immerse in water.
Do not drop the mobile FM transmitter. A severe jolt may
cause permanent damage and is not covered by your
warranty.
Follow thi s User Guide carefully and keep it for future
reference. Follow the correct procedures when setting up
the mobile FM transmitter.
3
4
Have the mobile FM transmitter checked by a service
technician if any the following conditions are true:
•The mobile FM transmitter has been exposed to
moisture.
•The mobile FM transmitter has been dropped and
damaged.
•The mobile FM transmitter has obvious signs of
breakage.
•The mobile FM transmitter is not working correctly
or you can’t get it to work according to this User
Guide.
Mobile FM transmitter
and charger components
Station preset buttons
Tune up
button
Tune
down
button
LCD
display
LCD d isplay
Cable to connect
to your iPod
Plugs into your car’s
power or cigarette
lighter socket
5
6
Using the mobile FM
transmitter and charger
To set up and use your mobile FM transmitter and
charger:
1 Insert the mobile FM transmitter firmly into your car’s
cigarette lighter or power socket.
2 Tune your car's FM stereo to an unused FM frequency.
3 Plug the connector on the end of the cable into your
iPod.
Note: To disconnect, unplug it from your iPod.
4 Start your iPod player. Your mobile FM transmitter
turns on when an audio signal is detected.
5 Select the frequency from Step two above using the
up and down arrows on the front of your mobile FM
transmitter.
Tip: The mobile FM transmitter works best
when the iPod volume is set be tween 50%
to 75% of maximum. After you have tuned
to the frequency and begun transmitting,
adjust the volume to a comfortable level.
Tip: Your iPod may not automatically turn
off. Be sure to unplug it to stop playback
and to deactivate charging before exiting
your car.
Tip: The best station for transmitting is one
that may not be perfectly clear but also
has clear or weak stations to either side of
it in the FM band.
Using the mobile FM transmitter
presets
To use the mobile FM transmitter presets:
1 Tune the transmitter to the desired FM frequency
using the tune up and tune down buttons.
Firmly press and hold one of the three preset buttons on
the front of the mobile FM transmitter for two seconds.
This stores the station in memory. The display will blink
briefly. A small indicator bar appears on the display
opposite the newly programmed preset button.
Caution: Do not watch the display while
driving.
2 Repeat steps one and two to store two additional
stations with the two remaining buttons.
Tip: When the mobile FM transmitter is
turned off and restarted, it tunes to the
last frequency used and the preset stations
are in memory.
7
8
Using your mobile FM transmitter
with an RDS-enabled radio
receiver
To set up and use your mobile FM transmitter with
an RDS-enabled radio receiver:
1 Tune your rece iver to the sa me frequenc y displayed o n
the face of the transmitter (or vice-versa).If your FM
receiver is RDS enabled, the radio automatically
shows 'RDS' in its display (if no song is playing).
2 Enable "AF" mode in your receiver for advanced
functionality. (See your RDS-enabled receiver
instruction manual for directions. Methods may
vary.)
3 Plug the connector on the end of the cable into your
iPod.
4 Start your iPod player. Your mobile FM transmitter
turns on whenever an audio signal is detected.
5 The song title is automatically displayed on the FM
receiver after a few seconds.
Using advanced features of your
mobile FM transmitter
To use advanced features of your mobile FM
transmitter:
•Autoseek: To automatically find the best
available station for use in your area, press
BOTH tune up and tune down buttons
together. The frequency numbers advance
while the unit searches for clear stations.
•Precision Auto-Off : The transmitter turns itself
off 60 seconds after the iPod stops playing or
the last button press. If you are pressing
buttons to find a clear station or program
presets, the Auto-Off period will not
commence until after the last button press.
•Auto-On: When the transm itter is off, start your
iPod and the transmitter turns back on
automatically.
Tip: A button press will also turn the
transmitter back on. The button press
won't alter the frequency settings while
turning on.
9
10
Specifications
Product specifications
Modulation FM Stereo Modulation
Power12 V car cigarette lighter socket
Frequencies Full FM band (88.1-107.9 MHz)
Memory3 Presets
Non-
volatile
memory
Instant-on Turns on when audio signal detected
Auto-offTurns off 60 seconds after the iPod player is turned off
Audio specifications
Signal format Standard FM stereo format, 38 KHz subcarrier
Frequency
response
Signal-to-
noise ratio*
Tot al ha rm oni c
distortion
Remembers previous frequency used
15 Hz - 15 kHz
>55 dB
0.25% typical
Stereo
separation
Channel
balance
>22 dB
+/- 2 dB
*A weighted
Legal notices
FCC Statement:
United States Regulatory Information
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation.
Caution: Changes or modifications not expressly approved by
Aerielle Technologies, Inc. may void the user’s authority to
operate this equipment.
Aerielle Enabled is a trademark of Aerielle Technologies, Inc.
Othe
r brands and product names are trademarks or registered
marks of their respective holders. U.S. Patents 6,671,494,
Aerielle Technologies, Inc. Products (“i2i”) warrants to you, the
original purchaser of this new i2i-RDS (“Product”), that the
Product shall be free of defects in the original manufacture of the
material or workmanship for a period of one (1) year from the date
of your purchase of the Product (“Warranty Period”). This Product
must be purchased from an authorized dealer of Aerielle Technologies, Inc. brand products and packaged with this warranty
statement. This warranty does not cover refurbished Product. If you
notify Aerielle Technologies, Inc. during the Warranty Period of a
defect covered by this warranty that requires service, terms of this
warranty apply.
How long does the coverage last?
The Warranty Period lasts for one year (365 days) from the date you
purchased the Product. The purchase date is printed on the receipt you received with the product.
14
What does this warranty cover?
During the Warranty Period, if the original manufacture of the
material or workmanship of the Product is determined to be
defective by an authorized Aerielle Technologies, Inc. repair center
or store personnel, Aerielle Technologies, Inc. will
(at its sole option): (1) repair the Product with new or rebuilt parts;
place the Product at no charge with new or rebuilt
or (2) re
comparable products or parts. Products and parts replaced under
this warranty become the property of Aerielle Technologies, Inc.
and are not returned to you. If service of Products and parts are
required after the Warranty Period expires, you must pay all labor
and parts charges. This warranty lasts as long as you own your
Aerielle Technologies, Inc. Product during the Warranty Period.
Warranty coverage terminates if you sell or otherwise transfer
the Product.
How to obtain warranty service?
If you purchased the Product at a retail store location, take your
original receipt and the Product to the store you purchased it from.
Make sure that you place the Product in its original packaging or
packaging that provides the same amount of protection as the
original packaging. If you purchased the Product from an online
web site, mail your original receipt and the Product to the address
listed on the web site. Make sure that you put the Product in its
original packaging or packaging that provides the same amount of
protection as the original packaging.
Where is the warranty valid?
This warranty is valid only to the original purchaser of the Product
in the United States and Canada.
What does the warranty not cover?
This warranty does not cover:
•Customer instruction
•Installation
•Set up adjustments
•Cosmetic damage
•Damage due to acts of God, such as lightning strikes
•Accident
•Misuse
•Abuse
•Negligence
•Commercial use
•Modification of any part of the Product
•This warranty also does not cover:
•Damage due to incorrect operation or maintenance
•Connection to an incorrect voltage supply
•Attempted repair by anyone other than a facility
authorized by Aerielle Technologies, Inc. to service
the Product
•Products sold as is or with all faults
•Consumables, such as fuse
•Products where the factory applied serial number has
been altered or removed
s or batteries
15
Loading...
+ 35 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.