Thank you for selecting this Yamaha NS-E80 speaker system.
This model is designed mainly to be used as an effect speaker system.
Read these precautions carefully before operating your speakers.
•When using an amplifier with a rated output power higher than the music input of the speakers, care should be taken never to exceed the speakers’ music input.
•Do not attempt to clean the speakers with chemical solvents as this might damage the finish. To clean, wipe with a dry, soft cloth.
•To prevent the enclosure from warping or discoloring, do not place the speakers where they will be exposed to direct sunlight or excessive humidity.
•Do not place the speakers where they are liable to be knocked over or struck by falling objects. Stable placement will also ensure better sound performance.
•Placing the speakers on the same shelf or rack as the turntable can result in feedback.
•As these speakers contain strong magnets, avoid placing watches, magnetic tapes, etc. near them. Also, placing the speakers near a TV set may impair picture color. If this happens, move the TV set away from the speakers.
•Secure installing is the owner’s responsibility. YAMAHA shall not be liable to any accident caused by a failure in installing at a proper position and by proper installation procedure.
NS-E80
CONNECTION TO
YOUR AMPLIFIER
BEFORE MAKING CONNECTIONS, MAKE SURE THAT THE AMPLIFIER IS SWITCHED OFF.
m CONNECTIONS
•Connect the push-type input terminals at the rear of the speakers to the speaker output terminals of your amplifier with the supplied speaker cables.
•One side of the speaker cable is marked by a white line. Connect the (+) terminals on both the amplifier and the speakers using this white-marked side. Connect the (–) terminals on both components using the unmarked side of the cable.
•Connect the left speaker to the left (marked L) terminals of your amplifier, and the right speaker to the right (marked R) terminals, making sure not to reverse the polarity (+, –). If one speaker is connected with reversed polarity, the sound will be unnatural and lack bass.
Procedures:
1Press the tab on the terminal down, as shown in the figure.
2 Insert the bare wire end properly into the terminal.
Natural Sound Bass-Reflex
Type Effect Speaker System
3Remove your finger from the tab to allow it to lock snugly on the cable’s wire end.
4Test the security of the connection by tugging lightly on the cable at the terminal.
Press tab
Right speaker |
White line |
Left speaker |
|
Speaker output terminals of the amplifier
White line |
White line |