Xylem SH-BLOX-ST30 Series, BLOX BRIDGE BR-BLOX-12 Series, BLOX V-BLOX-SH-20 series, BLOX BRIDGE BR-BLOX-20 Series, SH-BLOX-ST24 Series Installation Instructions Manual

TM

THANK YOU FOR CHOOSING XYLEM

Please take a few minutes to review this manual before you start installation. If you
encounter any installation problems, please don’t hesitate to contact us.

Before you begin, please observe all local building codes. Unpack the new product and
inspect for damage. The appearance of your vanity may differ from the illustrations in this
guide. This instructions still apply.

Please ensure the finished wall is straight and plumb and the floor is flat and perpendicular
to the finished wall.

SUGGESTED TOOLS AND MATERIALS

INSTALLATION INSTRUCTIONS

TM

BLOX

VANITY

V-BLOX-SH-20xx

10'

Philips Screwdriver Level Drill Tape Measure Safety Glasses

ROUGH-IN DIMENSIONS

20” (508mm)

SUGGESTED HEIGHT:

Application

Undermount

Vessel

20” (508mm) 21-1/2” (546mm)

Y (inch)
14”

11”

3-7/8” (100mm)

FINISHED

WALL

Y (inch)

FLOOR

WALL PREPARATION

Notch studs 1-1/2" (38mm) to
provide support for header.
Extend the header beyond the
countertop to the nearest stud.

SUGGESTED HEIGHT:

Application Z (inch)

Undermount

Vessel

35”
32”

2” x 12”
Header

Z

Finished Wall

INSTALLATION INSTRUCTIONS

1. 2.

Remove wood supports from the back of vanity.