Van Air Systems Dry-O-Lite User Manual
P a g e | 1
Safety Data Sheet
Dry-O-Lite®
GAS DRY PRIME
Chemical Desiccant
Section 1 – Product and Company Information Date: March 14, 2014 Rev. C
Product Name: Dry-O-Lite® / Gas Dry Prime Chemical Desiccant
Chemical Family: Inorganic Salt
Catalog Numbers: 33-0203, 33-0284, 33-028, 33-0311, 33-0313, 33-0340, & 33-0287-XXX
(XXX represents any alpha characters)
Product Use: Industrial: Deliquescent desiccant to reduce moisture content
of Compressed Natural Gas, Compressed Air and other Compressed Gasses
Company Identification: Van Air Systems / Van Gas Technologies
2950 Mechanic Street, Lake City, PA USA
16423-2095
E-mail: info@vanairsystems.com
www.vanairsystems.com / www.vangastech.com
Emergency Telephone Number: 800-840-9906
Customer Service Telephone Number: 814-774-2631
Section 2 – Hazard Identification
Color: White to gray-white
Physical state: Solid Tablets
Odor: Odorless
Emergency Overview: Avoid contact with skin and eyes. Avoid breathing dust. Wash thoroughly with soap and
water after handling.
Signal Word: Warning!
Hazard Pictogram:
Potential Health Effects: May cause mild skin, eye and/or respiratory irritation.
Health Hazards (acute and chronic): None known.
Carcinogenicity: Not available
NTP: Not available
IARC Monographs: Not available
Signs and Symptoms of Exposure: Skin dryness due to desiccant action. Ingestion of large amounts may
cause vomiting, diarrhea and prostration.
Section 3 – Composition / Information on Ingredients
Alkali chloride salt (Sodium Chloride) > 75%
1) The ingredients and percentage of ingredients in Dry-O-Lite® / Gas Dry Prime is a trade secret.
2) Dry-O-Lite® / Gas Dry Prime does not contain hazardous ingredients.
3) Dry-O-Lite® / Gas Dry Prime does not contain any substances found on the following EPA regulations:
a. “Extremely Hazardous Substances”
b. “CERCLA Hazardous Substances”
c. “Toxic Substances”
P a g e | 2
Section 4 - First Aid Measures
Eyes: Flush with water for at least 15 minutes.
Skin: Remove contaminated clothing / shoes. Wash with soap and water. Treat for dry skin.
Inhalation: Move person to fresh air. If irritation persists, consult a Physician.
Ingestion: DO NOT induce vomiting. If victim is conscious and alert, give 2-4 cups of milk or water, consult a
Physician.
Note to Physician: Treat symptomatically and supportively.
Section 5 – Fire Fighting Measures
Flammable Properties: Non-flammable
Flash Point: Not applicable.
Method Used: Not applicable
Flammability Limits: Not applicable.
LEL: Not applicable.
UEL: Not applicable.
Fire Fighting Instructions: Non-combustible.
Extinguishing Media: Not applicable.
Unusual Fire and Explosion Hazards: Under extreme heat and fire conditions, possibility of metal oxide fumes
produced.
Section 6 – Accidental Release Measures
Small/Large Spills: Sweep, shovel or vacuum for disposal or reuse.
Waste Disposal Method: Treat tablets as ordinary non-combustible solid waste. Solution is non-
toxic and will not support plant or marine life.
Section 7 – Handling and Storage
Handling: Tablets are non-toxic. Minimize dust generation and use with adequate
ventilation. NIOSH respiratory protection as needed for nuisance dust.
Wash thoroughly after handling.
Storage: Store in cool dry place. Keep containers tightly closed since material is
hygroscopic. Repair damaged containers.
Section 8 – Exposure Controls and Personal Protection
Engineering controls: Provide good general ventilation. Immediate work area should be
equipped with eye wash station.
Exposure Limits: None listed
Personal Protective Equipment (PPE)
Respirators: Use NIOSH or EN 149 approved respirator if dust cannot be controlled.
Hands and Feet: Rubber gloves and chemical / slip resistant safety shoes. recommended
Eye Protection: Safety glasses with side shields or chemical safety goggles.
Other Protective Clothing & Equipment: Clean, body-covering skin protecting clothing is recommended.
Work/Hygienic Practices: Wash thoroughly with soap and water after handling.
Section 9 – Physical and Chemical Properties
Appearance and Odor: White to gray-white solid tablet, size – 3/4” X 5/8”, odorless.
Bulk Density: 72 lbs/cubic foot
Vapor Pressure (mm Hg): Not applicable.
Melting Point: Loses water of hydration @ 241-244oF
Vapor Density (Air=1): Not applicable.
Loading...