NC450
Wall Mounting
Place the paper drill guide where you want
1
the camera. Check the alignment using
a level. Using a 0.24 inch (6mm) drill bit, drill
holes through the two circles on the guide.
Remove the paper.
Insert the two anchors into the holes and
2
place the camera mount over the anchor.
Attach the camera and use the screws to
3
secure it.
1 2 3
Drill Holes
Mount Base Secure Camera
Ceiling Mounting
Place the paper drill guide where you want
1
the camera*. Using a 0.24 inch (6mm) drill
bit, drill holes through the two circles
on the guide. Remove the paper.
* Camera placement can aect viewing angle. For best
results, place the camera near a wall or corner.
Attach the camera mount using the
2
screws, washers and wingnuts.
Attach the camera and use the screws to
3
secure it.
1 2 3
Drill Holes
Mount Base Secure Camera
Quick Installation Guide
1 2 3 4
Connect Register Relocate View and Enjoy
Connect the NC450 and your smartphone
to the same router, then connect the power
cord and internet cord to the NC450. If the
cord is long enough, please use Method A
below. If not, use a Passive PoE Injector to
connect, as shown in Method B.
Smartphone
A B
Camera
Internet
LANWAN
Outlet
Outlet
System LED
Flashing red: System starting
Solid red: Network not connected
Solid green: Network connected
Wireless Router
Passive
POE
Injector
Camera
More functions with tpCamera
Download the tpCamera app. Once installed,
open it and follow the instructions to add
the camera to your TP-Link ID.
OR
Place the camera where you want it. You can
place it on a at surface, or mount it as shown
on the back of this guide.
The WPS/Reset Button Mounting Kit
View live video using the tpCamera
app or TP-Link Cloud website.
Via tpCamera: On the "My Cam" screen,
tap your camera to view video. Change the
camera angle using the pan and tilt
controls.
Via TP-Link Cloud website: Log in at
https://www.tplinkcloud.com and select
your camera to view live video.
Support
For technical support and other information,
please visit http://www.tp-link.com/support.
Get notications when motion is
detected, and view alerts history.
Stay in touch with 2-way audio.
View all of your cameras on one screen by
downloading the TP-Link Camera Control
utility. See the Camera Control User Guide
for more details. Or visit us online at
www.tp-link.com for Camera Control utility,
Firmware, and other support.
WPS (Wi-Fi Protected Setup): If your Wi-Fi
router supports WPS, you can connect the
camera to your Wi-Fi network using WPS.
For details, see the camera’s User Guide.
WPS/
RESET
Short Press to trigger WPS; Press and
hold for 5 seconds to trigger Reset.
Camera
Base
Wall mount kit
Ceiling mount kit
©2017 TP-Link
Loading...