SilentKnight SD500-PS User Manual

SD500-PS/SD500-PSDA Addressable Fire Pull Station Installation Instruction

The SD500-PS/PSDA is an addressable fire pull station. The SD500-PS/PSDA is a normally open initiating point compatible with Silent Knight Addressable control panels. The SD500PS/PSDA is designed for indoor use in nonexplosive environments. Used to activate a noncoded alarm instantly.

An on-board status LED is visible from the front of the pull station. The LED flashes to indicate proper communication with the FACP (approximately every 30 seconds).

Operation

To activate the fire pull station:

1. Grab the top of the pull station where it is labeled “PULL”.

2. Pull the cover plate out and down.

To reset the pull station:

1. Insert key into the lock.

2. Turn the key clockwise.

3. Close the cover plate.

4. Turn the key counter clockwise.

Wiring to the SD500-PS/PSDA

Wire the SD500-PS as shown in Figure 1.

Supervised Power Limited

Specifications

Parameter Rating

Max. Line resistance 50Ω

Max. Alarm Current

Max. Voltage 33 V

Operating Temperature 0° to 49° C

Dimensions 5-1/8” H x 3-1/16” W x 1.5” D

One device in alarm 23mA. 46 mA for two devices in alarm.

.5 mA for each additional device in alarm.

(32° to 120° F)

Figure 1: Fire Pull Station Wiring

Mounting the SD500-PS/PSDA

The pull station mounts to a standard single gang electrical switch box or a surface mount back box P/N PS-SMBB (sold separately). See Figure

P/N 151177

SD500-PS/SD500-PSDA Addressable Fire Pull Station Installation Instruction

Single Gang Electrical Switch Box

PS-SMBB

Mounting

Holes

To meet ADA requirements the pull station must be mounted 48" from the floor for wheelchair forward access and no more than 54" from the floor for wheelchair side access

Figure 2: Mounting the Fire Pull Station

Installing The SD500-LK

The SD500-LK is used to convert the SD500-PS (single action pull station) to a SD500-PSDA (Dual action pull station. Refer to Figure 3 to install the SD500-LK Dual Action Conversion Kit.

Figure 3: SD500-LK Installation

Maple Grove, MN 55369-4927

763-493-6455 or 800-328-0103

7550 Meridian Circle

Fax: 763-493-6475

www.silentknight.com