INSTRUCTION MANUAL
Colour Television
CE28FWN4-B CE32FWN4-B
Please read this Instruction book before using your television. We wish you many hours of pleasure from your new television.
|
TV Specifications |
Front AV terminal |
|
|
||
Common specification |
|
|
AV3: |
RCA jacks |
||
|
|
Input: |
Composite video and audio-L/R |
|||
Power source |
AC 220~240V 50Hz |
|
||||
|
|
|
||||
Television system |
System I |
Heaphone socket |
Mini Jack |
|
||
Colour system |
PAL/NTSC4.43 |
|
||||
|
|
|
||||
|
|
(PAL/NTSC4.43/NTSC3.58 in AV mode) |
|
|
|
|
Channel coverage |
UHF: 21-69. |
|
CE28FWN4-B |
CE32FWN4-B |
||
Aerial input impedance |
75 ohm |
Sound output |
||||
|
|
|||||
(Continuous) |
2 x 10W |
2 x 10W |
||||
AV terminal |
|
|||||
|
|
|
|
|||
|
AV1: |
CENELEC Standard |
Picture tubes |
|
|
|
|
Input: Composite video, RGB and audio-L/R |
|
|
|||
|
(inches) |
28 |
32 |
|||
|
|
|
||||
|
Output: TV-output with composite video and |
|
|
|
||
|
|
audio-L/R |
Dimensions |
|
|
|
|
AV2: |
CENELEC Standard |
(WxHxD mm) |
786 x 519 x 504 |
880 x 575 x 549 |
|
|
|
|
|
|||
|
Input: Composite video, RGB, S-VHS and |
Weight (kg) |
34.5 |
46.3 |
||
|
|
|
||||
audio-L/R
Output: Monitor-output with composite video and audio-L/R
SAFETY PRECAUTIONS
CAUTION: Please read and retain for your safety. This unit has been engineered and manufactured to assure your personal safety. But improper use can result in potential electric shock or fire hazards. In order not to defeat the safeguards incorporated in this receiver observe the following basic rules for its installation, use and servicing.
Installation |
|
Use |
|
|
|
Do not allow anything to rest on the power cord. Do not locate this television receiver where the cord will be damaged by people walking on it.
Do not overload wall outlets and extension cords as this can result in fire or electric shock.
Slots and openings in the cabinet and in the back or bottom are provided for ventilation to ensure reliable operation and to protect it from overheating. These openings must not be blocked or covered. The opening should never be covered with a cloth or other material, and the bottom openings should not be blocked by placing the television receiver on a bed, sofa, rug, or other similar surface. This television receiver should never be placed near or over a radiator or heater.
This television receiver should not be placed in a built-in installation such as a bookcase unless proper ventilation is provided.
Do not place your television receiver on an unstable stand, shelf or table. Serious injury to an individual, and damage to the television may result if it should fall. Your sales person can recommend approved stands or shelf and wall mounting instructions.
|
|
MINIMUM DISTANCES |
|
5cm |
||
10cm |
|
10cm |
|
|||
|
|
|
|
|
|
|
20cm
If the television is built into a unit, or enclosed, the minimum distances for ventilation must be maintained. Heat build up can reduce the life of your television, and can be dangerous.
Servicing
Your television is fully transistorised and does not contain any user serviceable components.
You must not remove the rear cover of the TV by yourself. The apparatus is working with high voltages and could damage objects or even endanger people. Leave all required repair and service jobs to an authorised service technician. He will exclusively use such spare parts that are complying with the same safety standards as appliciable to the original parts. The use of original spare parts can prevent fire, shock and other hazards.
Unplug the television receiver from the wall outlet and refer servicing to qualified service personnel under the following conditions:
■ If the power cord or plug is damaged.
■ If liquid has been spilt into the television |
! |
receiver. |
■If television receiver has been exposed to rain or water.
■If the television receiver has been dropped or the cabinet has been damaged.
■If the television receiver exhibits a distinct change in performance.
■If the television receiver does not operate normally by following the operating instructions.
Adjust only those controls that are covered in the operating instructions as improper adjustment of other controls may result in damage. This will often require extensive work by a qualified technician to restore the television receiver to normal operation.
This television receiver should be operated only from the type of power source indicated on the television or as indicated in the Operating Instructions. If you are not sure of the type of power supply in your home, consult your sales person or your local power company.
Never add accessories that have not been specifically designed for this television.
Do not drop or push objects into the television cabinet slots or openings. Some internal parts carry hazardous voltages and contact may result in an electric shock hazard. Never spill liquids of any kind on the television receiver. Do not place items such as vases containing liquid on top of the TV set.
Do not expose the television receiver to rain or use near water. For example, near a bathtub, kitchen sink, in a wet basement, etc. Before cleaning, unplug the television receiver from the wall socket.
Never stand on, lean on or push the television or its stand. Never allow children to play with the television or its stand. Serious injury may result if it should fall.
Do not apply liquid cleaners or aerosol cleaners directly onto the television receiver. Use a damp cloth for cleaning.
Do not place candles or hot objects upon the TV, next to it or behind it. Open flames must never be used near the TV set.
Important:
This equipment is fitted with an approved non rewireable UK mains plug. To change a fuse in this type of plug proceed as follows:
1.Remove the fuse cover and fuse.
2.Fit a new fuse which should be a BS1362 5Amp A.S.T.A. or BSI approved type.
3.Ensure that the fuse cover is correctly refitted.
If the fuse cover is lost or damaged the plug must NOT be used but replaced with a serviceable plug.
If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a rating of 5 Amp, ensure the fuse cover is correctly fitted. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp.
Note: The severed plug must be destroyed to avoid a possible shock hazard should it be inserted into a 13Amp socket elsewhere.
The wires in this mains lead are coloured in accordance with the following code:
Blue ------- |
> |
Neutral |
Brown ---- |
> |
Live |
1.The Blue wire must be connected to the terminal which is marked with the letter “N” or coloured BLACK.
2.The Brown wire must be connected to the terminal with the letter “L” or coloured RED.
3.Do not connect either wire to the earth terminal in the symbol or coloured GREEN or GREEN and YELLOW.
Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the wires.
2
INSTALLATION
Step : 1 Connections ( Essential)
Connect your aerial cable socket to the back of the TV set.
AV2 |
AV1 |
ANT.75Ω
Connect the power cord of the TV set to a wall outlet.
AC Mains Outlet
The TV set is prepared for a mains voltage AC220~240V, 50Hz. When the TV set is not to be used for an extended period of time, it is advisable to disconnect the power cord from the power outlet.
For all aerial problems please consult your local dealer.
WARNING! High voltages are used in the operation of this set. Refer service to qualified service personnel.
● Connecting DVD / VCR player/ Satellite receiver or Set top box.
We recommend that you connect all other equipment before Plug and Play. The following examples are our recommended standard connection. For further information please consult your local dealer.
TV
AV2 |
AV1 |
|
ANT.75Ω |
Option if no DVD
VCR |
OUT |
|
IN |
Set top box |
|
DISH |
OUT |
|
or |
|
IN |
||
VCR |
TV IN |
|||
Satellite |
||||
|
|
|
For Satellite only
DVD
Please refer to individual Instruction Manuals for each piece of equipment for their connection suggestions.
Step : 2 Remote control battery installation
Install two "AA" 1.5 volt batteries so that the "+" and "-" marks on the batteries match the "+" and "-" marks inside the unit into the remote control handset.
Step : 3 Switching on / Plug & Play
Press the Mains on off switch on the front of the TV set.
This TV set provides a selfautomatic
tuning function called Plug and Play which 
P
automatically searches and stores all of the available TV stations in your reception area.
A welcome message will appear, once this has finished the following screen appears.
01 |
Thank you for purchasing your |
|
SANYO TV. |
|
Now I am searching and storing all |
|
programmes. |
Please wait. |
|
Auto set-up completed. Happy viewing! |
To remove the completed message press the 5, 6or 1, 2 buttons.
Now the installation is complete!
After Plug & Play the TV set automatically allocates the following major stations in the UK.
Position 1 : BBC1
Position 2 : BBC2
Position 3 : ITV
Position 4 : CH4
Position 5 : CH5
Position 6 : SKY, BBC-World, or BBC-Prime.
If any other channels are available in your reception area, the remaining stations will be stored from programme position 7 in sequence as found.
If you move to another city or cable is installed, please follow the description “TUNING”. (on page 6).
This procedure only appears the first time you switch on.
TV front controls / Terminals
P
5 and 6increases or decreases the programme position.
1 or 2increases or decreases the sound volume.
Front terminals
Headphone |
|
AV3 Video/ Audio-input Jacks |
||||||
|
|
|
|
|||||
Jack |
|
|
|
|
||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
From Camcorder 
Camcorder or video game
equipment Game 
equipment
To select the AV3 mode press the vbutton repeatedly.
When the headphones are inserted the sound from the TV speakers is muted.
3
Loading...