Sanyo CE17LC4-B, CE17LC4BK-B, CE17LC4W-B, CE23LC4-B, CE23LC4BK-B Instruction Manual

INSTRUCTION MANUAL

Colour Television

CE17LC4-B CE17LC4BK-B CE17LC4W-B CE23LC4-B CE23LC4BK-B CE23LC4W-B

				Side AV terminal
			Specification
				AV3: RCA jacks
				Input: Composite video and audio-L/R
	Common specification
				Headphone socket	Mini Jack
	Power source		AC 110~120V, 220~240V 50Hz
					CE17LC4-B	CE23LC4-B
	Television system		System I
					CE17LC4BK-B	CE23LC4BK-B
	Colour system		PAL (PAL/NTSC3.58 in AV mode)		CE17LC4W-B	CE23LC4W-B
				Sound output
	Channel coverage		UHF: 21-69,
				(Continuous)	2 x 2W	2 x 5W
	Aerial input impedance		75 ohm	Contrast Ratio	600:1	800:1
	AV terminal			Screen(inches)	17	23
		AV1: CENELEC Standard
				(viewing measured diagonally)
		Input: Composite video, RGB and audio-L/R
		Output: TV-output with composite video and audio-L/R		Display Resolution	1280 x 768 (WXGA)	1280 X 720 (WXGA)
		AV2: CENELEC Standard		Viewing angles	H:176°, V:176°	H:176°, V:176°
		Input: Composite video, RGB, S-VHS and audio-L/R		Dimensions (WxHxDmm) 452 x 409 x 237		580 x 480 x 257
		Output: Monitor-output with composite video and		(including stand)
			audio-L/R	Weight (kg)	6.5	8.4

Please read this Instruction book before using your television. We wish you many hours of pleasure from your new television.

SAFETY PRECAUTIONS / SERVICING

CAUTION: Please read and retain for your safety. This unit has been engineered and manufactured to assure your personal safety, but improper use can result in potential electric shock or fire hazards. In order not to defeat the safeguards incorporated in this receiver observe the following basic rules for its installation, use and servicing.

Installation

Use

Do not allow anything to rest on the power cord. Do not locate this television receiver where the cord will be damaged by people walking on it.

Do not overload wall outlets and extension cords as this can result in fire or electric shock.

Slots and openings in the cabinet and in the back or bottom are provided for ventilation to ensure reliable operation and to protect it from overheating. These openings must not be blocked or covered. The opening should never be covered with a cloth or other material, and the bottom openings should not be blocked by placing the television receiver on a bed, sofa, rug, or other similar surface.

Do not place this television near any heat sources such as radiators, heaters, stoves and other heat-generating products (including amplifiers).

Do not place the television in direct sunlight.

Do not place your television receiver on an unstable stand, shelf or table. Serious injury to an individual, and damage to the television may result if it should fall. Your sales person can recommend approved stands or shelf and wall mounting instructions. A special wall mounting kit is available for this model.

MINIMUM DISTANCES

5cm

	10cm
10cm	10cm

If the television is built into a unit, or enclosed, the minimum distances for ventilation must be maintained. Heat build up can reduce the life of your television, and can be dangerous.

This television receiver should be operated only from the type of power source indicated on the television or as indicated in the Operating Instructions. If you are not sure of the type of power supply in your home, consult your sales person or your local power company.

Never add accessories that have not been specifically designed for this television.

Do not drop or push objects into the television cabinet slots or openings. Some internal parts carry hazardous voltages and contact may result in an electric shock hazard. Never spill liquids of any kind on the television receiver. Do not place items such as vases containing liquid on top of the TV set.

Do not expose the television receiver to rain or use near water. For example, near a bathtub, kitchen sink, in a wet basement, etc. Do not use immediately after moving the television from a low temperature to a high temperature environment, as this causes condensation, which may result in fire, electric shock, or other hazards. Before cleaning, unplug the television receiver from the wall socket.

Never stand on, lean on or push the television or its stand. Never allow children to play with the television or its stand. Serious injury may result if it should fall.

Do not apply liquid cleaners or aerosol cleaners directly onto the television receiver. Use a soft cloth for cleaning.

Do not place candles or hot objects upon the TV, next to it or behind it. Open flames must never be used near the TV set.

Important recycling information.

Your SANYO product is designed and manufactured with high quality materials and components which can be recycled and reused.

This symbol means that electrical and electronic equipment, at their end-of-life, should be disposed of separately from your household waste.

Please dispose of this equipment at your local community waste collection/recycling centre.

In the European Union there are separate collection systems for used electrical and electronic products.

Please help us to conserve the environment we live in!

Note: This symbol mark and recycle system are applied only to EU countries are not applied to other countries of the world.

2

SAFETY PRECAUTIONS

Important:

This equipment is fitted with an approved non rewireable UK mains plug. To change a fuse in this type of plug proceed as follows:

1.Remove the fuse cover and fuse.

2.Fit a new fuse which should be a BS1362 3Amp A.S.T.A. or BSI approved type.

3.Ensure that the fuse cover is correctly refitted.

If the fuse cover is lost or damaged the plug must NOT be used but replaced with a serviceable plug.

If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a rating of 3 Amp, ensure the fuse cover is correctly fitted. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp.

Note: The severed plug must be destroyed to avoid a possible shock hazard should it be inserted into a 13Amp socket elsewhere.

The wires in this mains lead are coloured in accordance with the following code:

Blue -------	>	Neutral
Brown ----	>	Live

1.The Blue wire must be connected to the terminal whichis marked with the letter “N” or coloured BLACK.

2.The Brown wire must be connected to the terminal with the letter “L” or coloured RED.

3.Do not connect either wire to the earth terminal in the symbol or coloured GREEN or GREEN and YELLOW.

Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the wires.

THIS UNIT IS NOT DISCONNECTED FROM THE MAINS UNLESS THE MAINS LEAD IS UNPLUGGED.

Care of your product

● Cleaning your LCD screen.

Your LCD screen is coated in a non reflective film. Damage to this film will result in possible discolouration. Any scratches will not be repairable.

Clean your screen with a soft cloth, only rub lightly, do not use detergents.

Do not stick anything to the screen, use solvent or alcohol based cleaners, hit the screen with a hard object or rub the surface hard.

● Placement of your LCD TV.

Table top stand

This LCD TV is supplied with a table top stand fitted. The stand can rotate 360° to the left or right.

To rotate your TV hold the base and gently push the edge of the TV.

Wall mounting bracket

An optional wall bracket is available for your LCD TV. Before you consider wall mounting this TV, check that you have an appropriate wall made from solid materials such as concrete or bricks.

You will have to remove the table top stand to use this.

Servicing

Your television is fully transistorised and does not contain any user serviceable components.

You must not remove the rear cover of the TV by yourself. The apparatus is working with high voltages and could damage objects or even endanger people. Leave all required repair and service jobs to an authorised service technician. He will exclusively use such spare parts that are complying with the same safety standards as applicable to the original parts. The use of original spare parts can prevent fire, shock and other hazards.

Unplug the television receiver from the wall outlet and refer servicing to qualified service personnel under the following conditions:

■If the power cord or plug is damaged.

■If liquid has been spilt into the television receiver.

■If television receiver has been exposed to rain or water.

■If the television receiver has been dropped or the cabinet has been damaged.

■If the television receiver exhibits a distinct change in performance.

■If the television receiver does not operate normally by following the operating instructions.

Adjust only those controls that are covered in the operating instructions as improper adjustment of other controls may result in damage. This will often require extensive work by a qualified technician to restore the television receiver to normal operation.

3

INSTALLATION

Step : 1 Connections (Essential)

1.Connect your aerial cable socket to the back of the TV set. Fit the aerial cable as shown or as shown below when AV equipment is connected.

DC 24V

● Connecting DVD / VCR player/ Satellite receiver or

Set top box.

We recommend that you connect all other equipment before Plug and Play. The following examples are our recommended standard connection. For further information please consult your local dealer.

LCD TV

AV2

AV1

24V

VCR	OUT
	IN

Set top box				OUT
or			DISH
Satellite	VCR	TV	IN	IN
				For satellite
				only
DVD

2.Connect the DC power supply adaptor to the LCD TV set. (supplied with the set).

DC 19V

DC 24V

CE17LC4-B	CE23LC4-B
CE17LC4BK-B	CE23LC4BK-B
CE17LC4W-B	CE23LC4W-B

3. Connect the power cord of the LCD TV adaptor to a wall outlet.

AC Mains Outlet

The TV set adaptor is prepared for a mains voltage AC220~240V,

50Hz. To completely switch off the mains, or when the TV set is not to be used for an extended period of time, it is advisable to disconnect the adaptor power cord from the power outlet.

For all aerial problems please consult your local dealer.

WARNING! High voltages are used in the operation of this set. Refer service to qualified service personnel.

Push the catch downwards to open the door. Place leads behind the door to keep them tidy, and push the door closed.

Step : 2 Remote control battery installation

Install two "AA" 1.5 volt batteries so that the "+" and "-" marks on the batteries match the "+" and "-" marks inside the unit into the remote control handset.

4