Rockwell Automation 25-COMM-E2P User Manual

Installation Instructions

DeviceNet

25-COMM-D

PROFIBUS DP

25-COMM-P

EtherNet/IP Dual Port

25-COMM-E2P

Interface connector for all
communcation adapters

1

L1 L2 L3

O

I

DC+ DC–

0V

0V

Wait three minutes
after shutdown for
capacitors to discharge
to safe voltage levels.

3

Install the Communication Adapter Inter face Connector

For PowerFlex 525For PowerFlex 523

PowerFlex 520-Series Communication Adapters

Catalog Numbers: 25-COMM-D, 25-COMM-P, 25-COMM-E2P

2

Publication 520COM-IN001C-EN-P - July 2014

PowerFlex 520-Series Communication Adapters

5
4
3
2
1

Red
White
Bare
Blue
Black

4

5

Terminal Color Signal Function

5 Red V+ Power Supply

4 White CAN_H Signal High

3BareSHIELDShield

2 Blue CAN_L Signal Low

1 Black V- Common

Maximum Wire Size Minimum Wire Size Torque

3.33 mm

2

(12 AWG) 0.08 mm2 (28 AWG) 0.44...0.54 Nm (3.9...4.8 lb-in)

Wiring the DeviceNet Adapter How to Remove the Control Module Back Cover if Required

25-COMM-D
25-COMM-P
25-COMM-E2P

Install the Communication Adapter

DeviceNet adapter with optional 25-ENC-1
Incremental Encoder Input shown

Communication adapter label
(pre-attached)

Space for optional Incremental
Encoder Input label

Note: Incremental Encoder Input is for PowerFlex 525 only.
You can install both the communication adapter and optional
Incremental Encoder Input on the same Control Module Back Cover.

U.S. Allen-Bradley Drives Technical Support - Tel: [phone], Fax: [phone], E-mail: [e-mail]
Online: www.ab.com/support/abdrives

Allen-Bradley, Rockwell Software, Rockwell Automation, PowerFlex, and TechConnect are trademarks of Rockwell Automation, Inc.

Trademarks not belonging to Rockwell Automation are property of their respective companies.

Publication 520COM-IN001C-EN-P - July 2014

Supersedes Publication 520COM-IN001B-EN-P - September 2013 Copyright © 2014 Rockwell Automation, Inc. All rights reserved.