![](/html/c4/c4f0/c4f00d37747fb7951610b737599a27d699f43ac990e71adac0edc9125a303755/bg1.png)
RISCO 8 Zone Expander
(RP432EZ8)
The RISCO 8 Zone Expander (RP432EZ8) enables to expand the number of wired zones in the LightSYS
and ProSYS Plus.
Switch 1-5 Defines the Zone Expander ID
number.
Switch 6-7 Not Applicable
Switch 8:
Tamper Bypass
Zone Termination
Instead of a short between the
TMP/COM terminal block)
Note: :
The RP432EZ8 enables to define the end-of-line resistance of its zones. Selection is done through the software with the
following available options. The TEOL configuration is applicable for all versions of ProSYS Plus and LightSYS
Version 3 or later.
0 Customized 5 3.74K 6.98K 10 3.3K 3.3K
1 2.2K 2.2K (Dflt) 6 2.7K 2.7K 11 5.6K 5.6K
2 4.7K 6.8K 7 4.7K 4.7K 12 2.2K 1.1K
3 6.8K 2.2K 8 3.3K 4.7K 13 2.2K 4.7K
4 10K 10K 9 1K 1K 14 4.7K 6.8K 12K
Technical Information
≤
![](/html/c4/c4f0/c4f00d37747fb7951610b737599a27d699f43ac990e71adac0edc9125a303755/bg2.png)
Impostazione microinterruttori
Collegamento con la centrale
fili BUS, cablaggio max. 300 metri
10.5 cm x 6.6 cm x 1.8 cm
Espansione 8 Zone
(RP432EZ8)
L’espansione 8 zone per LightSYS e ProSYS Plus (RP432EZ8) permette di aumentare il numero di zone
della centrale.
Microint. 1-5 Definiscono il numero ID
dell’espansione zone.
Microint. 6-7 Non Usati
Microint. 8:
Esclusione
tamper
Terminazione delle zone
Esclude / disabilita l’ingresso
tamper.
Nota:
L’ espansione RP432EZ8 permette di impostare il valore delle resistenze di fine linea sulle sue zone. La
selezione avviene tramite la centrale scegliendo tra le seguenti opzioni quella desiderata: La
configurazione TEOL è applicabile per tutte le versioni di ProSYS Plus e LightSYS versione 3 o successiva.
0 Personalizzabile 5 3.74K 6.98K 10 3.3K 3.3K
1 2.2K 2.2K (Default) 6 2.7K 2.7K 11 5.6K 5.6K
2 4.7K 6.8K 7 4.7K 4.7K 12 2.2K 1.1K
3 6.8K 2.2K 8 3.3K 4.7K 13 2.2k 4.7K
4 10K 10K 9 1K 1K 14 4.7K 6.8K 12K
Specifiche Tecniche: