BY296 THRU BY299
SOFT RECOVERY PLASTIC RECTIFIER
VOLTAGE - 100 to 800 Volts CURRENT - 2.0 Amperes
FEATURES
•High surge current capability
DO-201AD
• The plastic package carries Underwriters Laboratory Flammability Classification 94V-O
• Void-free plastic package • 2.0 Ampere operation
at TA=55 ¢J with no thermal runaway • Fast switching for high efficiency
• Exceeds environmental standards of MIL-S-19500/228
MECHANICAL DATA
Case: Molded plastic, DO-201AD
Terminals: Axial leads, solderable per
MIL-STD-202, Method 208
Polarity: Band denotes end
Mounting Position: Any
Weight: .04 ounce, 1.1gran
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Ratings at 25 ¢J ambient temperature unless otherwise specified.
Single phase, half wave, 60 Hz, resistive or inductive load.
For capacitive load, derate current by 20%.
|
SYMBOLS |
BY296 |
BY297 |
BY298 |
BY299 |
UNITS |
Maximum Recurrent Peak Reverse Voltage |
VRRM |
100 |
200 |
400 |
800 |
Volts |
Maximum RMS Voltage |
VRMS |
70 |
140 |
280 |
560 |
Volts |
Maximum DC Blocking Voltage |
VDC |
100 |
200 |
400 |
800 |
Volts |
Maximum Average Forward Rectified Current |
1(AV) |
|
2.0 |
|
Amps |
|
.375"(9.5mm) lead lengths at TA=55 ¢J |
|
|
|
|
|
|
Peak Forward Surge Current 10ms single half sine- |
1FSM |
|
70.0 |
|
Amps |
|
wave superimposed on rated load |
|
|
|
|
|
|
Maximum Repetitive Peak Forward Surge (Note 1) |
1FRM |
|
10.0 |
|
Amps |
|
Maximum Instantaneous Forward Voltage at 3.0A |
VF |
|
1.3 |
|
Volts |
|
Maximum DC Reverse Current TA=25 ¢J |
IR |
|
10.0 |
|
£g A |
|
At Rated DC Blocking Voltage TA=100 ¢J |
|
|
500 |
|
|
|
Maximum Reverse Recovery Time (Note 3) TJ=25 ¢J |
TRR |
|
150 |
|
ns |
|
Typical Junction Capacitance (Note 2) TJ=25 ¢J |
CJ |
|
28.0 |
|
pf |
|
Typical Thermal Resistance (Note 4) |
R £KJA |
|
15.0 |
|
¢J /W |
|
|
|
|
|
|
|
|
Operating Temperature Range |
TJ |
|
-50 to +125 |
|
¢J |
|
Storage Temperature Range |
TSTG |
|
-50 to -150 |
|
¢J |
|
NOTES:
1.Repetitive Peak Forward Surge Current at f<15HKz.
2.Measured at 1 MHz. And applied reverse voltage of 4.0 volts.
3.Reverse Recovery Test Conditions; IF=0.5A,IR=1.0A,Irr=0.25A.
4.Thermal Resistance from Junction to Ambient at .375"(9.5mm) lead lengths with both leads to heat sink.
Loading...