|
1N5926B THRU 1N5956B |
|
|
|
GLASS PASSIVATED JUNCTION SILICON ZENER DIODE |
||
|
VOLTAGE - 11 TO 200 Volts Power - 1.5 Watts |
||
FEATURES |
DO-41 |
||
• |
Low profile package |
||
|
|||
• Built-in strain relief |
|
||
• |
Glass passivated junction |
|
|
• |
Low inductance |
|
|
• |
Typical IR less than 1 £gA above 11V |
|
• High temperature soldering : 260 ¢J /10 seconds at terminals
•Plastic package has Underwriters Laboratory Flammability Classification 94V-O
MECHANICAL DATA
Case: JEDEC DO-41 Molded plastic over passivated junction
Terminals: Solder plated, solderable per MIL-STD-750,
method 2026
Polarity: Color band denotes positive end (cathode)
Standard Packaging: 52mm tape
Weight: 0.012 ounce, 0.3 gram
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Ratings at 25 ¢J ambient temperature unless otherwise specified.
|
SYMBOL |
VALUE |
UNITS |
DC Power Dissipation @ TL=75 ¢J , Measure at Zero Lead Length(Note 1, Fig. 1) |
PD |
1.5 |
Watts |
Derate above 75 ¢J |
|
15 |
mW/¢J |
Peak forward Surge Current 8.3ms single half sine-wave superimposed on rated |
IFSM |
10 |
Amps |
load(JEDEC Method) (Note 1,2) |
|
|
|
Operating Junction and Storage Temperature Range |
TJ,TSTG |
-55 to +150 |
¢J |
NOTES:
1.Mounted on 5.0mm2(.013mm thick) land areas.
2.Measured on 8.3ms, single half sine-wave or equivalent square wave, duty cycle = 4 pulses per minute maximum.
3.ZENER VOLTAGE (Vz) MEASUREMENT Nominal zener voltage is measured with the device function in thermal equilibrium with ambient temperature at 25 ¢J .
4.ZENER IMPEDANCE (Zz) DERIVATION ZZT are measured by dividing the ac voltage drop across
the device by the accurrent applied. The specified limits are for IZ(ac) = 0.1 IZ, (dc) with the ac freqency = 60Hz.