1F1 THRU 1F7
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTIC
FA ST SWITCHING PLASTIC RECTIFIER
VOLTAGE - 50 to 1000 Volts CURRENT - 1.0 Ampere
l
High current capability
l
Plastic package has Underwriters Laboratory
Flammability Classification 94V-O Utilizing
Flame Retardant Epoxy Molding Compound
l 1.0 ampere operation at TA=55 ¢J with no thermal runaway
l
Fast switching for high efficiency
l
Exceeds environmental standards of MIL-S-19500/228
l
Low leakage
Case: Molded plastic, R-1
Terminals: Plated axial leads, solderable per MIL-STD-202,
Method 208
Polarity: Color band denotes cathode
Mounting Position: Any
Weight: 0.0064 ounce, 0.181 gram
Ratings at 25¢J ambient temperature unless otherwise specified.
Single phase, half wave, 60Hz, resistive or inductive load.
For capacitive load, derate current by 20%.
UNITS
Maximum Recurrent Peak Reverse Voltage 50 100 200 400 600 800 1000 V
Maximum RMS Voltage 35 70 140 280 420 560 700 V
Maximum DC Blocking Voltage 50 100 200 400 600 800 1000 V
Maximum Average Forward Rectified
Current .375"(9.5mm) lead length at TA=55 ¢J
Peak Forward Surge Current 8.3ms single half sine
wave superimposed on rated load(JECEC method)
Maximum Forward Voltage at 1.0A DC 1.3 V
Maximum Reverse Current TJ=25 ¢J
at Rated DC Blocking Voltage TJ=100 ¢J
Typical Junction capacitance (Note 1) CJ 12
Typical Thermal Resistance (Note 3) R £KJA 67 ¢J/W
Maximum Reverse Recovery Time(Note 2) 150 150 150 150 250 500 500 ns
Operating and Storage Temperature Range TJ,T
NOTES:
1. Measured at 1 MHz and applied reverse voltage of 4.0 VDC
2. Reverse Recovery T est Conditions: IF=.5A, IR=1A, Irr=.25A
3. Thermal resistance from junction to ambient and from junction to lead at 0.375"(9.5mm) lead length P.C.B.
mounted with 0.22×0.22"(5.5×5.5mm) copper pads
1.0 A
30 A
5.0
500
-55 to +150 ¢J
£g A
£g A
F