Omega Juicers O2 Instruction Manual

0 (0)

OMG-230_O2manual_v5.qxd 8/31/04 3:06 PM Page 1

IMPORTANT SAFEGUARDS — SAVE THESE INSTRUCTIONS

Read all instructions.

To protect against risk of electrical shock, do not put motor base or wiring in water or other liquid.

Close supervision is necessary when any appliance is used by or near children.

Unplug your juicer from outlet when not in use, before putting on or taking off parts, and before cleaning.

Avoid contacting moving parts.

DO NOT operate this or any appliance with a damaged cord or plug, or after the appliance malfunctions or it is dropped or damaged in any manner. Return appliance to the nearest authorized service facility for examination, repair or electrical or mechanical adjustment.

The use of attachments not recommended or sold by the manufacturer may cause fire, electrical shock or injury.

DO NOT use outdoors.

DO NOT let cord hang over edge of table or counter, or touch hot surfaces.

DO NOT place near a hot gas or electric burner or in a heated oven.

DO NOT use appliance for other than intended use.

Always make sure juicer cover is clamped securely in place before motor is turned on. DO NOT unfasten clamps while juicer is in operation.

Be sure to turn switch to off position after each use. Make sure the motor stops completely before disassembling.

DO NOT put your fingers or other objects into the juicer opening while it is in operation. If food becomes lodged in opening, use food pusher or another piece of fruit or vegetable to put it down. When this method is not possible, turn the motor off and disassemble juicer to remove the remaining food.

The switch on the bottom of the machine is a thermal protection device. Should the juicer overheat for any reason this switch will cut off the electrical current and the machine will stop, thus saving it from possible damage

or fire. To restart, simply push the switch and the juicer will again function normally.

WARNING: This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not modify the plug in any way.

This juicer is for household use.

OMG-230_O2manual_v5.qxd 8/31/04 3:06 PM Page 2

AN OMEGA WELCOME TO BETTER NUTRITION

Your new Omega Juicer may very well prove to be the most important small appliance purchase you have ever made! With proper care, your Omega Juicer will provide you with years of dependable service, helping to ensure your continued good health and vitality . . . and that of your family.

It is important that you take a few moments to read the following instructions and suggestions to get the most out of your Omega Juicer and to completely understand what it can do. Your Omega Juicer is simple to operate and maintain. It has been constructed with the highest-quality

materials and all stainless steel parts, built to provide a lifetime of delicious, healthful fresh fruit and vegetable drinks.

We feel confident that your Omega Juicer will provide you with many years of satisfaction as you continually extract nature’s most valued and vital nutrients from its most cherished and purest fruits and vegetables.

Should you ever encounter a problem with your Omega Juicer, contact us immediately. We stand behind the juicer to guarantee customer satisfaction completely.

We firmly believe that the Omega Juicer is the most technically advanced, top quality appliance you may ever purchase. Our responsibility doesn’t stop with your purchase of the juicer. It just begins. Your good health is our greatest objective.

With that in mind, go to it! Enjoy a lifetime of nature’s most abundant and freshest juices created by you and your Omega Juicer.

And feel GREAT.

Omega Juicers O2 Instruction Manual

OMG-230_O2manual_v5.qxd 8/31/04 3:06 PM Page 3

KNOW YOUR OMEGA JUICER

TO ASSEMBLE:

STEP 1 Place receptacle behind motor base housing.

STEP 2 Place bowl on motor base housing with spout facing you and in the middle of the two raised projections.

STEP 3 Place coupling on top of bowl with groove in the middle, aligned with spout.

STEP 4 Place strainer basket inside bowl, making certain that it rests flat on platform center hex nut.

STEP 5 Insert cutter blade inside strainer basket with teeth up, centering it over hex nut.

STEP 6 Tighten nut finger tight. Do not over tighten.

STEP 7 Place cover on bowl with ejection chute opening to rear.

STEP 8 Place tabs of latch arms over cover and secure.

STEP 9 Insert plunger in cover opening.

TO DISASSEMBLE:

STEP 1 Remove plunger from cover opening.

STEP 2 Release both side latch arms by inserting fingers into the two side openings at the bottom of the motor base housing and pulling outward and upward.

STEP 3 Remove cover.

STEP 4 Unscrew nut by turning counterclockwise.

STEP 5 Lift out bowl, basket and cutter blade together.

STEP 6 Remove strainer basket, coupling and blade from bowl.

SPECIAL NOTE: The stainless steel basket is a precision-engineered item that should be handled carefully. This will help the juicer run efficiently, smoothly, and for a very long time.

OMG-230_O2manual_v5.qxd 8/31/04 3:06 PM Page 4

HELPFUL HINTS

Make sure the machine is running at full speed before beginning to juice.

Do not force feed the juicer. For most fruits and vegetables a slow, steady push down the chute will work best.

There is no need to cut into sections a fruit or vegetable that will fit whole into the feeder chute. If it must be cut, cut only into large pieces that easily fit down the feeder chute.

When making a drink that uses a combination of more than one fruit or vegetable, we suggest alternating the various fruits or vegetables when placing them in the machine. For example: Carrot Apple Juice — place one or two pieces of carrot in feeder chute, then a piece or two of apple. Keep alternating in this manner.

When juicing leafy greens we suggest that you twist and roll the green into a ball the size of a golf ball. Always place the greens into the juicer first, followed by crisper vegetables such as carrots, celery, etc.

When juicing any very soft fruits and vegetables, such as tomatoes, grapes and peaches, we suggest that you alternate with firmer fruits and vegetables.

Cleaning the Fruits and Vegetables: Before you begin juicing, thoroughly wash all dirt and sprays from the fruits and vegetables. A vegetable brush can be used to clean carrots, celery, etc. Cut away any decaying or diseased portions of the fruits or vegetables.

Preparing the Fruits and Vegetables: It is not necessary to peel your fruits and vegetables as many of the valuable food elements are under the surface near the skin. The only exceptions are cucumbers, pineapples, oranges and grapefruit. These should be peeled.

Loading...
+ 8 hidden pages