website http://www.lgservice.com
LG
LG
Room Air Conditioner
INSTALLATION MANUAL
ESPAÑOL FRANÇAIS ENGLISH
IMPORTANT
•Please read this instruction manual completely before installing the product.
•When the power cord is damaged, replacement should be performed by authorized personnel only.
•Installation work must be performed in accordance with the national wiring standards by authorized personnel only.
•Please retain this installation manual for future reference after reading it thoroughly.
Room Air Conditioner Installation Manual
TABLE OF CONTENTS
Installation
Required Parts
Requirements
Safety Precautions............................ |
4 |
Introduction........................................ |
7 |
Symbols used in this manual.......... |
7 |
Features ........................................... |
7 |
Installation .......................................... |
8 |
Installation parts............................... |
8 |
Installation tools ............................... |
8 |
Installation map................................ |
9 |
Selecting the best location ........... |
10 |
Piping length and elevation........... |
11 |
Fixing installation plate.................. |
12 |
Drilling a hole in the wall ............... |
12 |
Flaring work ................................... |
13 |
Connecting the piping .................. |
14 |
Connecting the cables .................. |
20 |
Checking the drainage .................. |
23 |
Forming the piping......................... |
24 |
Air purging...................................... |
25 |
Test running ................................... |
27 |
Installation guide at the seaside ... |
29 |
Four type "A" screws & plastic anchors
Connecting cable
Installation guide map
Pipes: Gas side
Liquid side
Insulation materials
Additional drain pipe
[Outer diameter......15.5mm(0.61in)]
Two type "B" screws
Required Tools
Level gauge
Screw driver
Electric drill
Hole core drill [ø70mm(2.76in)]
Horizontal meter
Flaring tool set
Specified torque wrenches 1.8kg.m, 4.2kg.m, 5.5kg.m, 6.6kg.m
(different depending on model No.)
Spanner ........................Half union
A glass of water
Screw driver
Hexagonal wrench(4mm)
Gas-leak detector
Vacuum pump
Gauge manifold
Owner's manual
Thermometer
Remote control holder
2 Room Air Conditioner
Wall Mounted Mini-Split System
Single Zone
INSTALLATION INSTRUCTIONS
IMPORTANT! |
|
Please read this instruction |
installing the product. |
This air conditioning system meets strict |
. As the installer or service person, |
it is an important part of your job to install or |
operates safely and efficiently. |
WARNING
•Installation or repairs made by unqualified persons can result in hazards to you and others.
Installation MUST conform with local building codes or, in the absence of local codes, with the National Electrical Code NFPA 70/ANSI C1-1993 or current edition and Canadian Electrical Code Part1 CSA C.22.1.
•The information contained in the manual is intended for use by a qualified service technician familiar with safety procedures and equipped with the proper tools and test instruments.
•Failure to carefully read and follow all instructions in this manual can result in equipment malfunction, property damage, personal injury and/or death.
CAUTION: Improper installation, adjustment, |
can void the warranty. |
The weight of the condensing |
proper handling procedures when lifting |
or moving to avoid personal injury |
with sharp or pointed edges. |
Safety Precautions |
|
• Always wear safety eye wear |
installing equipment. |
• Never assume electrical power |
with meter and equipment. |
• Keep hands out of fan areas |
to equipment. |
• R-410A causes frostbite burns. |
|
• R-410A is toxic when burned. |
|
NOTE TO INSTALLING DEALER: The |
Warranty are to be given to the owner |
or |
the indoor Furnace/Air Handler Unit. |
WARNING
When wiring:
Electrical shock can cause severe personal injury or death. Only a qualified, experienced electrician should attempt to wire this system.
•Do not supply power to the unit until all wiring and tubing are completed or reconnected and checked.
•Highly dangerous electrical voltages are used in this system. Carefully refer to the wiring diagram and these instructions when wiring. Improper connections and inadequate grounding can cause accidental injury or death.
•Ground the unit following local electrical codes.
•Connect all wiring tightly. Loose wiring may cause overheating at connection points and a possible fire hazard.
When transporting:
Be careful when picking up and moving the indoor and outdoor units. Get a partner to help, and bend your knees when lifting to reduce strain on your back. Sharp edges or thin aluminum fins on the air conditioner can cut your finger.
When installing...
... in a wall: Make sure the wall is strong enough to hold the unit's weight.
It may be necessary to construct a strong wood or metal frame to provide added support.
... in a room: Properly insulate any tubing run inside a room to prevent "sweating" that can cause dripping and water damage to wall and floors.
... in moist or uneven locatinons: Use a raised concrete pad or concrete blocks provide a solid, level foundation for the outdoor unit. This prevents water damage and abnormal vibration.
... in an area with high winds: Securely anchor the outdoor unit down with bolts and a metal frame. Provide a suitable air baffle.
... in a snowy area(for Heat Pump Model): Install the outdoor unit on a raised platform that is higher than drifting snow. Provide snow vents.
When connecting refrigerant tubing
•Keep all tubing runs as short as possible.
•Use the flare method for connecting tubing.
•Check carefully for leaks before starting the test run.
When servicing
•Turn the power OFF at the main power box(mains) before opening the unit to check or repair electrical parts and wiring.
•Keep your fingers and clothing away from any moving parts.
•Clean up the site after you finish, remembering to check that no metal scraps or bits of wiring have been left inside the unit being serviced.
ENGLISH
Installation Manual 3
Safety Precautions
Safety Precautions
or other people and property damage, the following instructions
the air conditioner.
specified here as they include important items related to safety. instruction will cause harm or damage. The seriousness is
.
indicates the possibility of death or serious injury.
indicates the possibility of injury or damage to properties only.
used in this manual are as shown below.
Be sure not to do.
Be sure to follow the instruction.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Always perform grounding. |
Don’t use a power cord, a |
||
|
|
plug or a loose socket which |
|
|
|
is damaged. |
|
• Otherwise, it may cause |
• Otherwise, it may cause a fire |
||
electrical shock. |
or electrical shock. |
Securely attach the electrical part cover to the indoor unit and the service panel to the outdoor unit.
•If the electrical part cover of the indoor unit and the service
Always install an air leakage breaker and a dedicated switching board.
•No installation may cause a fire and electrical shock.
For installation of the product, always contact the service center or a professional installation agency.
•Otherwise, it may cause a fire, electrical shock, explosion or injury.
Do not keep or use flammable gases or combustibles near the air conditioner.
•Otherwise, it may cause a fire or the failure of product.
Ensure that an installation frame of the outdoor unit is not damaged due to use for a long time.
• It may cause injury or an accident.
Do not disassemble or repair the product randomly.
• It will cause a fire or electrical shock.
4 Room Air Conditioner
|
Safety Precautions |
|
|
Do not install the product at a place that there |
Use caution when unpacking and installing. |
is concern of falling down. |
|
• Otherwise, it may result in personal injury. |
• Sharp edges may cause injury. |
■ Operation
Do not share the outlet with other appliances.
•It will cause an electric shock or a fire due to heat
Take care so that the power cord may not be pulled during operation.
•Otherwise, it may cause a fire or electrical shock.
Do not use the damaged power cord.
•Otherwise, it may cause a fire or electrical shock.
Unplug the unit if strange sounds, smell, or smoke comes from it.
•Otherwise, it may cause electrical shock
Do not modify or extend the power cord randomly.
•Otherwise, it may cause a fire or electrical shock.
Keep the flames away.
•Otherwise, it may cause a fire.
Do not use the near the heating
•Otherwise, it and electrical
Hold the plug when taking it
•It may cause and damage.
shock.
Do not step on the indoor/outdoor unit and |
Do not place a heavy object on the power |
do not put anything on it. |
cord. |
• It may cause an injury through dropping of the |
• Otherwise, it may cause a fire or electrical |
unit or falling down. |
shock. |
When the product is submerged into water, |
Take care so that children may not step on |
always contact the service center. |
the outdoor unit. |
• Otherwise, it may cause a fire or electrical |
• Otherwise, children may be seriously injured |
shock. |
due to falling down. |
ENGLISH
Installation Manual 5
Safety Precautions
■ Installation
Install the drain hose to ensure that drain can be securely done.
• Otherwise, it may cause water leakage.
Install the product so that the noise or hot wind from the outdoor unit may not cause any damage to the neighbors.
•Otherwise, it may cause dispute with the neighbors.
Always inspect gas leakage after the installation and repair of product.
• Otherwise, it may cause the failure of product.
Keep level parallel in installing the product.
•Otherwise, it may cause vibration or water leakage.
■ Operation
Avoid excessive cooling and perform ventilation sometimes.
• Otherwise, it may do harm to your health.
Use a soft cloth to clean. Do not use wax, thinner, or a strong detergent.
•The appearance of the air conditioner may deteriorate, change color, or develop surface flaws.
Do not use an appliance for special purposes such as preserving animals vegetables, precision machine, or art articles.
Do not place obstacles around the flow inlet or outlet.
• Otherwise, it may damage your properties.
•Otherwise, it may cause the failure of appliance or an accident.
6 Room Air Conditioner
Introduction
Introduction
SymbolsusedinthisManual
This symbol alerts you to the risk of electric shock.
This symbol alerts you to hazards that may cause harm to the air conditioner.
NOTICE This symbol indicates special notes.
Features
ENGLISH
Air Inlet
Plasma Filter
Air Filter
Front Panel
Signal Receptor
Air Intake Vents |
Connecting |
|
Wires |
Air Outlet Vents
Drain Hose
Base Plate
Installation Manual 7
Installation
Installation
Read carefully, and then follow step by step.
InstallationParts
Type 1
Installation plate
Type 2
Installation plate
Type "B" screw |
Type "B" screw |
Type "A" screw (6 EA) |
Type "A" screw (8 EA) |
Remote control holder |
Remote control holder |
InstallationTools
Figure |
Name |
Figure |
Name |
|
Screw driver |
|
Ohmmeter |
|
Electric drill |
|
Hexagonal wrench |
|
Measuring tape, Knife |
|
Ammeter |
|
Hole core drill |
|
Gas-leak detector |
|
Spanner |
|
Thermometer, |
|
|
Horizontal meter |
|
|
|
|
|
|
Torque wrench |
|
Flaring tool set |
8 Room Air Conditioner
Installation
InstallationMap
NOTICE
Installation parts you should purchase.
|
Installation plate |
|
|
Sleeve |
|
|
Bushing-Sleeve |
|
|
Putty(Gum Type Sealer) |
|
|
Bend the pipe as closely |
|
|
on the wall as possible, |
|
|
but be careful that it |
|
|
doesn't break. |
|
Air Discarge |
|
|
Vertical Air deflector |
|
|
Operation Indication Lamps/ |
Vinyl tape (Wide) |
|
Signal Receptor |
||
• Apply after carrying out a |
||
|
||
Forced Operation Button |
drainage test. |
|
|
• To carry out the drainage |
|
Saddle |
test, remove the air filters |
|
and pour water into the heat |
||
|
exchanger. |
ENGLISH
Air Inlet Vents
Air Outlet Vents
Base Plate
Gas side piping (Optional Parts)
Liquid side piping (Optional Parts)
Additional drain pipe
Vinyl tape (Narrow) Drain Hose
Connecting cable (Optional Parts)
Installation Manual 9
Installation
SelectthebestLocation
Indoor unit
1.Do not have any heat or steam near the unit.
2.Select a place where there are no obstacles in front of the unit.
3.Make sure that condensation drainage can be conveniently routed away.
4.Do not install near a doorway.
5.Ensure that the interval between a wall and the left (or right) of the unit is more than 10cm(3.9in). The unit should be installed as high as possible on the wall, allowing a minimum of 20cm(7.9in) from ceiling.
More than |
|
10cm(3.9in) |
than |
|
|
|
.9in) |
|
More than |
|
10cm(3.9in) |
2 |
|
6.Use a metal detector or metal scanner to locate studs to prevent unnecessary damage to the wall.
Outdoor unit
1.If an awning is built over the unit to prevent direct sunlight or rain exposure, make sure that heat radiation from the condenser is not restricted.
2.Ensure that the space around the back and sides is more than 30cm(11.8in). The front of the unit should have more than 70cm(27.6in) of space.
3.Do not place animals and plants in the path of the warm air.
4.Take the weight of the air conditioner into account and select a place where noise and vibration are minimum.
5.Select a place where the warm air and noise from the air conditioner do not disturb neighbors.
More than 60cm(23.6in)
More than More than 30cm(11.8in) 30cm(11.8in)
More than |
More than |
70cm(27.6in) |
60cm(23.6in) |
10 Room Air Conditioner