Bottom Mount Refrigerator |
|
|
||
PRODUCT MODEL NUMBERS |
PRODUCT DIMENSIONS |
|
|
|
JFC2089W |
|
|
|
|
Electrical: A 115-volt, 60-Hz, AC-only, 15or |
H |
|
|
|
|
|
|
||
20-amp fused, grounded electrical supply is |
G |
|
|
|
required. It is recommended that a separate |
|
|
||
cabinet |
|
I |
||
circuit serving only your refrigerator be |
|
|
||
provided. Use an outlet that cannot be turned |
F |
|
C |
|
off by a switch. Do not use an extension |
not incl. |
|
||
|
|
|||
cord. |
handle |
|
|
|
NOTE: Before performing any type of |
E |
90˚ |
90˚ |
|
installation, cleaning, or removing a light |
||||
incl. |
A |
|
||
bulb, turn the control (Thermostat, |
overall |
|
||
handle |
|
|||
Refrigerator or Freezer Control depending on |
B |
|
|
|
the model) to OFF and then disconnect the |
top of |
|
|
|
refrigerator from the electrical source. When |
cabinet |
|
|
|
you are finished, reconnect the refrigerator to |
|
|
|
|
the electrical source and reset the control |
|
|
|
|
(Thermostat, Refrigerator or Freezer Control |
|
|
|
|
depending on the model) to the desired |
|
|
|
|
setting. See “Using the Controls.” |
|
|
|
|
Water: A cold water supply with water
pressure between 30 and 120 psi (207 and D 827 kPa) is required to operate ice maker
and water dispenser. If you have questions about your water pressure, call a licensed, qualified plumber.
IMPORTANT: The pressure of the water |
|
|
|
|
|
|
|
|
|
|
|
coming out of a reverse osmosis system |
|
|
|
|
|
|
|
|
|
|
|
going to the water inlet valve of the |
|
|
|
|
|
|
|
|
|
|
|
|
|
Height - |
Depth - |
Depth - |
Depth - |
Depth - |
Depth - |
|
Width - |
||
refrigerator needs to be between 30 and |
|
Height - |
Width - |
||||||||
120 psi (207 and 827 kPa). |
|
Top of |
Doors Open |
Drawer |
With |
Without |
Cabinet |
Door Open |
|||
|
Overall |
Cabinet |
90° |
Open |
Handles |
Handles |
Only |
Cabinet |
90° |
||
Reverse Osmosis Water Supply: If a |
|
||||||||||
Model Size |
“A” |
“B” |
“C” |
“D” |
“E” |
“F” |
“G” |
“H” |
“I” |
||
reverse osmosis water filtration system is |
|
|
|
|
|
|
|
|
|
|
|
|
70" |
681⁄2" |
43" |
453⁄8" |
293⁄8" |
267⁄8" |
241⁄8" |
355⁄8" |
361⁄2" |
||
connected to your cold water supply, the |
19.6 cu.ft. |
||||||||||
(177.8 cm) |
(174.0 cm) |
(109.2 cm) |
(115.3 cm) |
(74.6 cm) |
(68.3 cm) |
(61.3 cm) |
(90.5 cm) |
(92.7 cm) |
|||
water pressure to the reverse osmosis |
|
|
|
|
|
|
|
|
|
|
|
system needs to be a minimum of 40 to |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
60 psi (276 to 414 kPa). |
|
|
|
|
|
|
|
|
|
|
LOCATION REQUIREMENTS
To ensure proper ventilation for your refrigerator, allow for a 1⁄2" (1.25 cm) space on each side and at the top. Allow for 1" (2.54 cm) of space behind the refrigerator. If your refrigerator has an ice maker, make sure you leave some extra space at the back for the water line connections.
|
|
¹⁄" (1.25 cm) |
If you are installing your refrigerator next to a fixed wall, leave 21⁄2" (6.3 cm) |
|
|
|
|
|
minimum on the hinge side (depending on your model) to allow for the door to |
|
|
|
|
swing open. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
NOTE: It is recommended that you do not install the refrigerator near an oven, radiator, or other heat source, nor in a location where the temperature will fall below 55°F (13°C).
2¹⁄" (6.3 cm)
Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation |
Ref. W10277506A |
Instructions packed with product. Specifications subject to change without notice. |
9/21/12 |
Loading...