hp LaserJet 1000
important !/
1
getting started guide
Important: Install Software First
1. To install the software, load the CD-ROM and follow
the instructions on the screen.
2. After the software installation is complete, set up the
printer.
See steps 2 through 7 in the graphical instructions.
2
4
3
5
6
7
New Hardware Found
In Microsoft Windows, if you get a message that
states "New Hardware Found...," you can let
windows install the necessary software. From the
"New Hardware Found..." dialog, browse to the
installation file (.inf file) on the CD. For additional
assistance with your printer, see the online user
guide on the CD or on the Web at
www.hp.com/support/lj1000. If you need to
contact HP, see the online user guide or the Web for
support phone numbers.
Troubleshooting
- Refer to Chapter 6 of your Electronic User Guide
For More:
- Regulatory Information
- Important Safety Notices
- Detailed Installation and User Instructions
Refer to the HPLJ1000 electronic User Guide; or
www.hp.com/support/lj1000
Copyright Information
© Copyright Hewlett-Packard Company 2002
All Rights Reserved. Reproduction,
adaptation, or translation without prior written
permission is prohibited, except as allowed
under the copyright laws.
Part number: Q1342A-90921
First Edition: March 2002
FCC Regulations
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy. If this equipment is
not installed and used in accordance with the
instructions, it may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase separation between equipment and
receiver.
Connect equipment to an outlet on a circuit
different from that to which the receiver is
located.
Consult your dealer or an experienced radio/
TV technician.
Any changes or modifications to the printer
that are not expressly approved by HP could
void the user’s authority to operate this
equipment.
Use of a shielded interface cable is required
to comply with the Class B limits of Part 15 of
FCC rules.
Warran ty
The information contained in this document is
subject to change without notice.
Hewlett-Packard makes no warranty of any
kind with respect to this information.
HEWLETT-PACKARD SPECIFICALLY
DISCLAIMS THE IMPLIED WARRANTY OF
MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE.
Hewlett-Packard shall not be liable for any
direct, indirect, incidental, consequential, or
other damage alleged in connection with the
furnishing or use of this information.
Trademark Credits
Microsoft ® , Windows ® , and Windows NT ®
are U.S. registered trademarks of Microsoft
Corporation. All other products mentioned
herein may be trademarks of their respective
companies.
copyright © 2002
Hewlett-Packard Company
www.hp.com/support/lj1000
*Q1342-90921*
*Q1342-90921*
Q1342-90921
Loading...