Note: An EXPLODED DRAWING is attached in the center of this manual.
WARNING DECAL PLACEMENT
The decals shown here have been applied
in the locations shown. If a decal is miss-
ing or illegible, call the telephone number on the front cover of this manual and
request a free replacement decal. Apply
the decal in the location shown. Note:
The decals may not be shown at actual size.
GOLD'S GYM is a registered trademark of Gold's Gym International, Inc. This product is manufactured and
distributed under license from Gold's Gym Merchandising, Inc.
2
IMPORTANT PRECAUTIONS
WARNING: To reduce the risk of serious injury, read all important precautions and in-
structions in this manual and all warnings on your treadmill before using your treadmill. ICON assumes no responsibility for personal injury or property damage sustained by or through the use of
this product.
1. Before beginning any exercise program, consult your physician. This is especially important for persons over the age of 35 or persons with pre-existing health problems.
2. It is the responsibility of the owner to ensure
that all users of this treadmill are adequately
informed of all warnings and precautions.
3. Use the treadmill only as described.
4. Place the treadmill on a level surface, with at
least 8 ft. (2.4 m) of clearance behind it and 2
ft. (0.6 m) on each side. Do not place the
treadmill on any surface that blocks air openings. To protect the floor or carpet from damage, place a mat under the treadmill.
5. Keep the treadmill indoors, away from moisture and dust. Do not put the treadmill in a
garage or covered patio, or near water.
6. Do not operate the treadmill where aerosol
products are used or where oxygen is being
administered.
7. Keep children under the age of 12 and pets
away from the treadmill at all times.
8. The treadmill should not be used by persons
weighing more than 350 lbs. (160 kg).
9. Never allow more than one person on the
treadmill at a time.
10. Wear appropriate exercise clothes when
using the treadmill. Do not wear loose
clothes that could become caught in the
treadmill. Athletic support clothes are recommended for both men and women.
Always
wear athletic shoes. Never use the treadmill
with bare feet, wearing only stockings, or in
sandals.
11. When connecting the power cord (see page
13), plug the power cord into a surge suppressor (not included) and plug the surge sup
pressor into a grounded circuit capable of
-
carrying 15 or more amps. No other appliance
should be on the same circuit. Do not use an
extension cord.
12. Use only a single-outlet surge suppressor that
meets all of the specifications described on
page 13. To purchase a surge suppressor, see
your local GOLD’S GYM dealer or call the telephone number on the front cover of this manual and order part number 146148, or see your
local electronics store.
13. Failure to use a properly functioning surge
suppressor could result in damage to the control system of the treadmill. If the control system is damaged, the walking belt may change
speed, accelerate, or stop unexpectedly,
which may result in a fall and serious injury.
14. Keep the power cord and the surge suppressor away from heated surfaces.
15. Never move the walking belt while the power
is turned off. Do not operate the treadmill if
the power cord or plug is damaged, or if the
treadmill is not working properly. (See
TROUBLESHOOTING on page 22 if the treadmill is not working properly.)
16. Read, understand, and test the emergency
stop procedure before using the treadmill (see
HOW TO TURN ON THE POWER on page 15).
17. Never start the treadmill while you are standing on the walking belt. Always hold the
handrails while using the treadmill.
18. The treadmill is capable of high speeds.
Adjust the speed in small increments to
avoid sudden jumps in speed.
19. The pulse sensor is not a medical device.
Various factors, including the user's movement, may affect the accuracy of heart rate
readings. The pulse sensor is intended only
as an exercise aid in determining heart rate
trends in general.
3
20. Never leave the treadmill unattended while it
s running. Always remove the key, unplug
i
he power cord, and switch the reset/off cir-
t
cuit breaker to the “off” position when the
treadmill is not in use. (See the drawing on
page 6 for the location of the reset/off circuit
reaker.)
b
other than the procedures in this manual
hould be performed by an authorized ser-
s
vice representative only.
27. The treadmill is intended for in-home use
only. Do not use the treadmill in any commercial, rental, or institutional setting.
21. Do not attempt to raise, lower, or move the
treadmill until it is properly assembled. (See
ASSEMBLY on page 7, and HOW TO FOLD
AND MOVE THE TREADMILL on page 21.) You
must be able to safely lift 45 lbs. (20 kg) to
raise, lower, or move the treadmill.
22. Do not change the incline of the treadmill by
placing objects under the treadmill.
23. When folding or moving the treadmill, make
sure that the frame is held securely by the
pin on the latch knob.
24.
Inspect and properly tighten all parts of the
treadmill regularly.
25. Never insert or drop any object into any
opening on the treadmill.
DANGER: Always unplug the power
26.
cord immediately after use, before cleaning
the treadmill, and before performing the
maintenance and adjustment procedures described in this manual. Never remove the
motor hood unless instructed to do so by an
authorized service representative. Servicing
28. To reduce the risk of electric shock, do not
remove the cover or the back of the television. There are no user serviceable parts inside. Refer servicing to qualified service personnel.
29. To protect the treadmill and TV during lightning storms, unplug the power cord from the
wall outlet and disconnect the cable system.
This will prevent damage due to lightning and
power line surges.
30. Upon completion of any service or repairs to
the treadmill or the television, ask the service
technician to perform safety checks to confirm that the unit is in proper operating condition.
Note to CATV system installer: This reminder
is provided to call the CATV system installer’s attention to Article 820-40 of the NEC
that provides guidelines for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding
system of the building, as close to the point
of cable entry as practical.
4
Power Lines
Service
Entrance
Conductors
ervice
S
Entrance
Equipment
Power Service Grounding
Electrode System (e.g.
Interior Metal Water Pipe)
SAVE THESE INSTRUCTIONS
75 ohm Terminal
Ground
Clamps
5
BEFORE YOU BEGIN
Thank you for selecting the revolutionary GOLD’S
™
YM
G
treadmill offers an impressive selection of features designed to make your workouts at home more enjoyable
and effective. And when you’re not exercising, the
nique PREVIEW 1500 treadmill can be folded up, re-
u
quiring less than half the floor space of other treadmills.
For your benefit, read this manual carefully before
using the treadmill
REVIEW 1500 treadmill. The PREVIEW 1500
P
. If you have questions after read-
Personal Television/Console
Accessory Tray
Handrail
Pulse Sensor
ing this manual, please see the front cover of this man-
al. To help us assist you, note the product model
u
number and serial number before contacting us. The
model number and the location of the serial number
decal are shown on the front cover of this manual.
Before reading further, please review the drawing
below and familiarize yourself with the labeled parts.
Fan
Book Holder
Key/Clip
Walking Belt
Foot Rail
Rear Roller
Adjustment Bolts
Reset/Off
Circuit Breaker
Power Cord
Cushioned Walking Platform
6
ASSEMBLY
1/2” Silver Screw(48)–1
3/4” Tek Screw (58)–4
S
pacer Screw (60)–2
41/2” Bolt (78)–4
W
asher (96)–8
Upright Star
Washer (90)–10
Upright Bolt (72)–4
3/4" Screw (4)–4
Handrail Bolt (64)–6
ssembly requires two persons.Set the treadmill in a cleared area and remove all packing materials. Do not
A
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking
belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to
the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,
non-abrasive cleaner.
Assembly requires the included hex key and your own Phillips screwdriver .
Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is
the key number of the part, from the PART LIST near the end of the manual. The number after the parentheses
shows the quantity needed for assembly.
tached to one of the parts to be assembled. Extra hardware may be included. To avoid damaging plastic
parts, do not use power tools for assembly.
Note: If a part is not in the parts bag, check to see if it is preat-
1. Make sure that the power cord is unplugged.
With the help of a second person, raise the front
of the treadmill and insert the crossbar on the
Base (83) into the cutout in the cardboard stand
as shown.
treadmill to prevent it from moving forward
or backward until assembly step 2 is completed.
Have the second person hold the
WARNING: Serious injury
may occur if the treadmill moves for
ward or backward and falls off the card
board stand. A second person must
hold the treadmill until assembly step 2
is completed to prevent the treadmill
from moving, tipping, or falling.
-
-
1
83
Cardboard
Stand
7
2. Identify the Left Upright (73) and the Right
Upright (74). Hold the Right Upright near the
ight Base Cover (77) as shown. Insert the
R
Upright Wire Harness (75) up into the rectangu-
ar hole in the bottom of the Right Upright and
l
out of the top of the Right Upright.
Gently pull up on the Upright Wire Harness (75)
as you set the Right Upright (74) on the Base
(83) inside the Right Base Cover (77). Be care-
ful not to pinch the Upright Wire Harness.
Attach the Right Upright (74) to the Base (83)
with two Upright Bolts (72) and two Upright Star
Washers (90). Note: It may be necessary to tip
the upper ends of the Uprights forward slightly
as you thread the Upright Bolts into the
Uprights.
Do not tighten the Upright Bolts yet.
2
97
9
4
5
7
73
74
76
77
Hold the Left Upright (73) near the Left Base
Cover (76), and insert the TV Cable (49) and the
AV Wire (97) up into the rectangular hole in the
bottom of the Left Upright and out of the top of
the Left Upright. Insert the Left Upright into the
Left Base Cover and attach it to the Base (83)
with two Upright Bolts and two Upright Star
Washers
Upright Bolts yet.
With the help of a second person, lower the
treadmill off the cardboard stand.
3. Identify the Right Upright Sleeve (96) and the
Left Upright Sleeve (95). Slide the Right Upright
Sleeve onto the Right Upright (74) and the Left
Upright Sleeve onto the Left Upright (73).
(not shown). Do not tighten the
83
90
72
3
95
73
“Left”
“Right”
96
74
8
4. With the help of a second person, hold the console assembly near the Uprights (73, 74).
Connect the Upright Wire Harness (75) to the
onsole Wire Harness (71). S
C
ing. The connectors should slide together
easily and snap into place.
one connector and try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY,
THE CONSOLE MAY BE DAMAGED WHEN
THE POWER IS TURNED ON.
ee the inset draw-
If they do not, turn
4
75
Console
Assembly
71
73
71
75
74
5. Connect the TV Cable (49) and the AV Wire
(97) to the cables extending from the console
assembly. Then, insert the connectors down into
the Uprights (73, 74).
Next, insert the brackets on the Handrails (99)
into the Right Upright (74) and the Left Upright
(73). Make sure that no wires are pinched.
6. Finger tighten three Handrail Bolts (64) with
three Upright Star Washers (90) into the Right
Upright (74). Next, finger tighten three Handrail
Bolts with three Upright Star Washers (notshown) into the Left Upright (73). Then, firmly
tighten the six Handrail Bolts.
5
99
97
73
6
73
49
99
74
64
90
90
64
74
9
Loading...
+ 21 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.