D-Link DMP-220 User Manual

Review Package Contents

Make sure that the package contains the following items. If any items are
missing, contact the reseller.

§ DMP-210/220 Player

§ Drivers and Software on CD-ROM

§ Earphone

§ USB Cable

§ User’s Manual

§ Quick Install Guide

§ 1 x AA Alkaline Ba ttery

Driver and Manager Installation

The driver enables the Manager software to communicate with the
DMP-210/220. When you install the Manager software, the drivers will
automatically be copied to the Windows system directory.

!

Note:

Install the Manager program before connecting your
DMP-210/220 to the USB port. The Manager program

loads the appropriate drivers necessary to complete the
installation. If the device is connected before installing the
Manager program, disconnect the DMP-210/220 from the
USB port, exit the “Add New Hardware Wizard” screen and
restart your computer.

Driver and Manager Installation Continued…

§ Make sure your computer is turned on.

§ Insert the DMP-210/220 Driver CD into the CD-ROM.

§ The Autorun screen will appear automatically.

§ Click on the button labeled “Install Manager”

Note: If the Autorun screen does not appear, click on Start and select

Run. In the run dialog box, type "drive:\autorun.exe" and click
OK. Where “drive” is the letter of your CD-ROM drive.

§ Follow the on-screen instructions to complete the Manager

installation.

§ Reboot the computer.

Connect the DMP-210/220 to the PC

§ Open the battery compartment and insert the battery supplied with

this package. Be sure to match the correct polarity.

§ Press the Play button to turn on the DMP-210/220. The

DMP-210/220 must be powered on before connecting to the computer
via the USB port.

§ Connect the type “A”

end of the USB cable to
the USB port on your
computer. (This is the
flatter, rectangular end of
the USB cable)

§ Connect the other end of

the USB connector on
the DMP-210/220. (This
is the smaller, square end
of the USB cable)

§ Windows will detect and

load all necessary drivers
when the DMP-210/220 is
connected to the USB port
for the first time.

Note: Windows 2000 users may be prompted by a “Digital Signature

Not Found” screen. Click “Yes” on each screen to allow the
installation to continue.