Quick Reference Guide
Guía de referencia rápida
Lower Threading
1Enhebrado del hilo inferior
•Raise the spool pin to its highest position
•Tire del portacarrete completamente
•Pass the thread through the marked areas, being sure to catch thread beneath the pre-tensioning disk
•Pase el hilo a través de las áreas marcadas y
asegúrese de cogerlo por debajo del disco pretensión
Click!
•Align the notch on bobbin to the spring on the shaft
•Haga coincidir la muesca de la bobina con el resorte del eje
•Slide the bobbin winder shaft to the right
•Deslice el eje de la devanadora hacia la derecha
Be sure to use the |
|
|
|
correct bobbin. |
|
Actual |
|
Asegúrese de que |
11.5mm |
||
Size |
|||
utiliza la bobina |
7/16" |
Tamaño |
|
correcta. |
|
real |
Please read “IMPORTANT SAFETY INSTRUCTIONS” and the detailed instructions in the Operation Manual.
Lea “INSTRUCCIONES IMPORTANTES DE SEGURIDAD” y las instrucciones detalladas que aparecen en el Manual de instrucciones.
• 7 – 10 cm (3-4 inches)
• 7 – 10 cm (3-4 pulg.)
• Hold the end of the thread
• Sujete el extremo del hilo
• 5 cm (2 inches)
• 5 cm (2 pulg.)
• Leave 1 cm (1/2 inch) of thread from the hole on the bobbin
• Deje 1 cm (1/2 pulg.) de hilo desde el orificio de la bobina
•Wind the thread a few times around the bobbin
• Enrolle el hilo unas cuantas veces alrededor de la bobina
•Hold the bobbin case by the latch, fully insert the bobbin case into the shuttle race, and then release the latch
•Sujete la caja de la bobina por el cierre, insértela en la pista de la lanzadera y suelte el cierre
•When the bobbin is full, the bobbin will spin more slowly
•Cuando esté llena, la bobina girará más lentamente
See other side for “2. Upper Threading.” • Consulte en la otra cara “2. Enhebrado del hilo superior”.
XF1272-001