LTC 9113/00
Instruction Manual
EN Rack-mount Kits
LTC 9113/00, LTC 9114/00, LTC 9115/00,
LTC 9017/00, LTC 9117/00
1DESCRIPTION
These kits are designed to mount the following
monitors in a standard EIA 19in. rack using either
Universal or Wide Spacing.
Rack Kit Monitor Model
LTC 9113 / 0 0 LTC 2813/ 9 0, & LTC 2914 / 91
LTC 9114 / 0 0 LTC 2 814 /90
LTC 9115 / 0 0 LTC 2 915 /90
LTC 9 017/00 LTC 2017/5 0 & LTC 2 017/ 6 0
LTC 9117/00 LTC 2917/91
2UNPACKING
This mechanical equipment should be unpacked and
handled with care.
Check for the following items:
Qty. Item
1Base Tray
2 Rack Sides
1Cover Bezel
1 Hardware Kit containing the following items:
4 4-40 Machine Screws (Cover Bezel)
6 8-32 Machine Screws (Rack Sides)
4 10-32 Machine Screws (Rack Installation)
4 10-32 U-type Nut Fasteners (Rack
Installation)
If an item appears to have been damaged in shipment,
replace it properly in its carton and notify the shipper.
If any items are missing, notify your Bosch Security
Systems Inc. Sales Representative or Customer Service.
The shipping carton is the safest container in which the
unit may be transported. Save it for possible future use.
3SERVICE
If the unit ever needs repair service, the customer
should contact the nearest Bosch Security Systems, Inc.
Service Center for return authorization and shipping
instructions.
Service Centers
USA
Phone: 800-366-2283 or 717-735-6638
fax: 800-366-1329 or 717-735-6639
CCTV Spare Parts
Phone: 800-894-5215 or 408-956-3853 or 3854
fax: 408-957-3198
e-mail: BoschCCTVparts@ca.slr.com
Canada
Phone: 514-738-2434
Europe, Middle East & Asia Pacific Region
Phone: 32-1-440-0711
For additional information, see
www
.boschsecuritysystems.com.
4INSTALLATI ON
4.1 ASSEMBLY
4.1.1 Tools Required
Small Phillips screwdriver.
Assembly
1. Position the monitor so that it is upside down,
with its feet (where applicable) on top, and the
front of the monitor toward you. Remove and
retain each replacement foot and mounting
screw from the monitor. Install the base tray
onto the monitor with the flat side of the base
tray toward the monitor; the edges of the base
tray should face up. The square hole of the base
tray should now be at the lower left-hand edge
of the tray. Align the removable foot mounting
holes with the appropriate holes in the base tray.
Secure the monitor to the base tray using the
reserved mounting screws from the removable
feet.
EN|2
Bosch Security Systems | 19 August 2004
LTC 9113/00, LTC 9114/00, LTC 9115/00, LTC 9017/00, LTC 9117/00 | Instruction Manual | Description
Loading...