D
SIZE
OF
SHT
DRAWING NUMBER
NOTICE OF PROPRIETARY PROPERTY
I TO MAINTAIN THE DOCUMENT IN CONFIDENCE
III NOT TO REVEAL OR PUBLISH IN WHOLE OR PART
II NOT TO REPRODUCE OR COPY IT
AGREES TO THE FOLLOWING
PROPERTY OF APPLE COMPUTER, INC. THE POSSESSOR
THE INFORMATION CONTAINED HEREIN IS THE PROPRIETARY
1
2
3
4
5
67
8
12
3
4
5
6
78
B
C
D
A
B
C
D
A
REV.
APPLE COMPUTER INC.
SCALE
NONE
03/20/07 -- GPU Vcore: Updated setpoints for GPU Vcore based upon Nvidia Vmin (i.e. 1.05V,1.05V,1.05V,1.125V)
See Perforce change notes for updates before Proto Release
12/22/06 -- Released for Proto (Schem Rev 08, PCB Rev 01)
PROTO
DVT (cont’d)
DVT
01/19/07 -- Power Sequencing: Added C7859 to create RC delay for 1.5 and 1.05V S0 rails
01/19/07 -- GPU GPIOs: Added 2 TPs on GPIOs to make G-state externally visible
01/22/07 -- LIO Conn: Removed unnecessary aliases as T9 reference design now matches M75 (T9_noME change 40998)
01/23/07 -- BOM: Changed FB memories to new Samsung and Hynix APNs (also added new BOMOPTIONs to GPU straps)
01/24/07 -- PATA Conn: Changed =PP5V_S0_ODDPWREN to =PP3V3_S0_ODDPWREN for minor power savings
02/26/07 -- GPU Vcore: NO STUFFed all PWRCTL related components (feature not to be supported)
02/28/07 -- Power Aliases: Moving PP1V8_GPU FET source to PP1V8_S3 rather than PP1V8_S3_ISNS to improve power delivery to GPU (rdar://5021462)
03/01/07 -- NB GFX Decoupling: Added R2260 (0.3 ohm, 0603) to bring ESR of regulator output cap in spec (rdar://5000272)
03/06/07 -- FireWire Ports: Changed D4260 to PDS340 for lower height
03/12/07 -- Power Control: Corrected alias connections for 5V/3V3 S5 enable signals
13.1.0:
03/13/07 -- BOM Options: Removed HDCP BOM option from stuffing list (feature removed)
12.8.0:
02/19/07 -- Power Sequencing: NO STUFFed U7885 to remove GPU PGOOD from PWROK chain
03/06/07 -- FireWire Ports: Changed D4260 to PDS540 for higher current capacity
01/12/07 -- Power Supplies: Minor power supply feedback connection changes from M76
01/23/07 -- BOM: Changed C3860/61 to 22pF from 27 pF based on -R characterization (T9_noME change 41248)
01/25/07 -- BOM: Updated all Intel APNs to use QS parts
02/19/07 -- GPU Reset: Changed C2885 to 0.047uF to reduce reset delay on powerup
02/19/07 -- Power Sequencing Rework: Short pins 2 and 4 of U7885 to complete PWROK chain
12.1.0:
12.0.0:
12.6.0:
03/06/07 -- Power FETs: Changed Q7080 to RJK0301 which provides much lower Rds(on)
01/22/07 -- BOM: Selected P1V8S3_1V825 BOMOPTION to lift voltage at FB memories
01/25/07 -- BOM: Updated gain of PP1V25_ENET current sense amplifier to 165 (R5432 to 165K)
12.4.0:
12.3.0:
01/17/07 -- SMBus: Changed R5260 & R5261 from 4.7K to 3.3K
01/23/07 -- Released for EVT (Schem Rev 10, PCB Rev 02)
EVT_SE
11.0.0:
10.2.0:
EVT
9.5.0:
9.2.0:
9.4.0:
9.3.0:
8.1.0:
10.1.0:
9.1.0:
02/28/07 -- NB GFX Core: Changed Vcore controller to ISL6263B (part consolidation effort between Apple/Intersil - rdar://5009109)
12.2.0:
12.5.0:
9.0.0:
8.2.0:
12.7.0:
03/06/07 -- SB GPIOs: Changed R2514 from pulldown to pullup to correct auto power-on issue (Linda card detect GPIO)
02/28/07 -- Power Supplies: Replaced APN 152S0511 with 152S0368 (duplicate APNs for same part - rdar://5009109)
02/21/07 -- Power Sequencing: Removed U7885/C7885 to take GFX_PGOOD out of PWR_OK chain (rdar://4974927)
02/26/07 -- Thermal Sensors: Updated topology of EMC1033 filter caps (added C5515 next to IC, moved other caps to connectors - rdar://5025773)
03/01/07 -- NB GFX Decoupling/Power Aliases: Connected VCCD_CRT of NB to GND per CRT disable guidelines
03/06/07 -- DDR2 Regulator: Changed FB resistors to 0.1% to raise guaranteed lowest output voltage
13.0.0:
02/26/07 -- SB GPIOs: Sync’d page25.csa to T9_MLB to get pullup updates
02/20/07 -- GPU FB: Changed unterminated-mode reference voltage to 40% (R8297 -> 1.02K, R8432/82, R8532/82 -> 2.21K)
01/22/07 -- Clock Termination: Added R3051 for Silego 537/101 compatibility
02/20/07 -- GPU FB: Changed cal resistors per Nvidia PUN (R8290 to 45.3 ohm and R8291 to 24.9 ohm)
01/25/07 -- PATA Conn: Replaced PCIREQ pass FET with OD buffer to correct a corner case during PLTRST
01/24/07 -- PATA Conn: Added pass FET Q4430 to allow PCIREQ3 (ODD reset GPIO) to pullup to S0
10.0.0:
01/22/07 -- BOM: Added BOMOPTIONs for SLG2AP101 (primary) and SLG8LP537 (backup)
01/18/07 -- Testpoints: Added NO_TEST property to LVDS_L_DATA_N<1>, _N<2>, _P<2> due to lack of layout space for TP
01/17/07 -- Power Aliases: Deleted alias that accidentally eliminated filtering on PP1V5_S0_SB_VCC1_5_B
01/17/07 -- BOM: Consolidated 3 caps on page 59 from 132S0120 to 132S0131
01/17/07 -- Power Sequencing: Added RC delay on PP1V8_S3 switcher enable
01/17/07 -- Power FETs: Corrected BOM values for 5V/3.3V S3/S0 FETs
01/17/07 -- Power Aliases: Moved LCD panel FET to PP3V3_S5 from S0
01/09/07 -- Temp Sensors: NO STUFFed C5520 (circuit should have only 1 cap)
03/08/07 -- Thermal Sensors: Added R5515/R5516 in case low pass filter is needed for EMC1033
13.3.0:
03/06/07 -- Ethernet Connector: Removed RX shorts on Ethernet MDI lines per EMC request
03/02/07 -- Power/Signal Aliases: Added XW0900 to PP5V_S5 to enable layout improvements
03/01/07 -- LVDS Connector: Changed pin 5 of connector from NC to PP3V3_SW_LCD (in case we add extra cable for power - rdar://5024882)
03/01/07 -- Thermal Sensors: Updated topology of EMC1033 sensors (removed shorts, changed connector caps to 18pF)
02/28/07 -- Left Clutch IC: Updated both I-PEX connectors to new APN (part update for shell plating)
02/27/07 -- ODD Conn: Changed ODD power FET to FDC606P (from FDC638P) for reduced Rds(on) (rdar://4993378)
02/26/07 -- GPU Vcore: Updated voltage setpoints to 1.000/1.070/1.125V (rdar://5021453)
02/21/07 -- FireWire: Changed to Rev C of TI FireWire MCM (APN: 338S0435)
02/19/07 -- Released post-EVT to document what was built (Schem Rev 12)
02/19/07 -- GPU PGOOD: Changed C9595 to 330pF to reduce PGOOD delay on powerup
01/25/07 -- Released for EVT (Schem Rev 11, PCB Rev 03)
01/25/07 -- Power Aliases: Updated PP5V_S0 aliases to support above changes
01/24/07 -- Power Aliases: Updated PP3V3_S0 aliases to support above changes
01/22/07 -- Clocks: Changed U2900 to SLG2AP101 as primary clock chip (T9_noME change 40975)
01/19/07 -- SB GPIOs: Changed SB_GPIO42 to WOW_EN and changed pullup to pulldown (T9_noME change 40787)
01/19/07 -- Power Sequencing: Changed power rail for U7850 to PP3V3_S5 to eliminate a leakage path
01/19/07 -- Clock Termination: Changed R3050 and R3055 to bypass discrete muxes for pending change to SLG2AP101
01/19/07 -- Ethernet Conn: Changed resistor short reference designators from R392x to RX392x
01/19/07 -- SB Decoupling: Removed filtering for PP1V5_S0_SB_VCCGLANPLL to enable PP1V5_S0 corrections at SB
01/18/07 -- ODD Conn: Reconnected ODD power FET gate control circuitry to properly implement soft start (added one cap)
01/18/07 -- IMVP: Updated BOMOPTIONs and values for ISL9504B
01/18/07 -- Clock Termination: Changed series termination on all single ended clocks to 33 ohms
01/17/07 -- BOM: Added Hynix BOM configurations
01/17/07 -- Testpoints: Removed FUNC_TEST from NB_RESET_L and FSB_DPWR_L per PCB request
01/17/07 -- Sync with T9 noME (6.1.4) to pull in WOL_EN and Wake-on-Wireless support
01/12/07 -- Power Aliases: Moved Ethernet to PP3V3_S3 from S5 (layout improvements)
01/08/07 -- GPU FB: Added VREF support for unterminated memory mode (added FETs and pulldown Rs)
01/05/07 -- GPU FB: Corrected FB CLK termination (added cap and removed connection to VDDQ)
01/05/07 -- Clock Termination: Removed NO STUFF property from R3067
13.4.0:
13.5.0:
14.0.0:
03/19/07 -- Power Control: Tied all 4 5V/3.3V enables (EN1, EN2, EN3, EN5) together as part of PM_G2_EN
03/19/07 -- Power Supplies: For 1.8, 3.3 and 5V, increased cap size to 0603/0805 on VBST caps (rdar://5070179)
03/19/07 -- Power Supplies: For 1.8, 3.3 and 5V, removed VBST 0-ohm series R (rdar://5070179)
03/19/07 -- Power Control: Added U7858 to level shift PM_G2_EN from 3.42V to 5V
03/19/07 -- Thermal Sensors: Updated U5500 power alias to indicate device should be on S3 rail
03/16/07 -- Thermal Sensors: Moved remote sensor U5500 to SMC SMBus "A" and S3 power rail to clear I2C addr clash
03/16/07 -- Yukon Power Control: Crystal caps changed to 18pF (rdar://4946795 and rdar://4945362)
03/16/07 -- NB GFX: LVDS_VREFL/VREFH changed to single pin nets to prevent LVDS glitches per Intel
03/16/07 -- Thermal Sensors: Replaced EMC1033 with second EMC1043 for improved noise filtering
03/14/07 -- Constraints: Constrained WWAN_SIM signals to 50 ohms
03/14/07 -- Thermal Sensors/Aliases: Changed mounting pads of Th2H sensor connector to left clutch chassis gnd
13.2.0:
03/20/07 -- FB: Changed FB VREF caps to 2x0.0047uF as required in Nvidia PUN 02736-001-v07 (which requests 1x0.01uF)
14.0.0
SYNC_DATE=N/A
SYNC_MASTER=N/A
Revision History
051-7225
88
6