Symmetra® LX
Start-Up Guide
Extended Run Cabinets
For use with Symmetra LX UPS models:
200V, 4–8 kVA |
200V, 4–16 kVA |
208/240V, 4–8 kVA |
208/240V, 4–16 kVA |
220/230/240V, 4–8 kVA |
220/230/240V, 4–16 kVA |
READ FIRST
Important Safety and Installation Instructions
This guide is applicable for the Symmetra LX tower and rack-mount extended run cabinet models. These units provide extended run time for the Symmetra LX tower or rack-mount UPS models.
See and retain the product documentation shipped with your system for other important installation, operation, and maintenance instructions.
Illustrations are representative. The Symmetra LX configuration, including components and optional APC equipment, may be different from the models shown in this guide.
Entire contents copyright 2005 by American Power Conversion Corporation. All rights reserved. Reproduction in whole or in part without permission is prohibited.
APC, the APC logo, InfraStruXure, PowerChute, Smart-UPS and Symmetra are registered trademarks of American Power Conversion Corporation. All other trademarks are the property of their respective owners.
9-Battery Rack-mount Extended Run
3-Battery Rack-mount Extended Run
9-Battery Tower Extended Run
990-1873-001 04/2005
Overview
1. Read Safety and General Information Instructions
•Read, understand and follow ALL safety instructions contained in the Symmetra LX Safety
|
Instructions and General Information Guide. |
Electrical • |
Failure to follow safety instructions and warnings |
Hazard |
could result in equipment damage, serious injury, |
|
or death. |
2. Refer to the UPS Documentation
If installing the Symmetra LX and the Extended Run Cabinet(s), install according to the instructions in the Symmetra LX Start-Up Guide shipped with the UPS.
3. Install the Extended Run Cabinet(s)
Perform the physical installation for the extended run cabinet(s). See the included Symmetra LX Physical Installation Guide.
4. Follow the proceeding Start-Up Instructions
See these instructions once the physical installation for the Extended Run Cabinet(s) is complete. This section contains information on how to connect, test, and start the unit.
Start-Up Instructions
The illustrations shown in this section are applicable for the
tower and rack-mount extended run cabinets.
Note
1.Connect the first Extended Run Cabinet
1.1Remove the screw and battery connector cover from the back of the UPS.
1.2Connect the power cable of the first extended run cabinet to the UPS battery connector .
1.3Set the dial of the extended run cabinet to ‘2’.
If connecting to a UPS with integrated extended run, set the
dial of the first extended run cabinet to ‘3’ instead of ‘2’.
Note
1.4Connect the communications cable from the extended run communications connector on the UPS to the connector on the extended run cabinet .