Xerox WORKCENTRE 450CP, WORKCENTRE 450C Manual

CUSTOMER SELF SERVICE

Feed Roll Cleaning Kit

Xerox - DOCUMENT WorkCentre 450c / 450cp

The purpose of the instructions is to provide a step by step procedure to correct a paper feed problem. Read all the instructions before performing this procedure.

Contents of kit: ∙ Feed Roll Cleaning Pad ∙ Repair Instructions

CUSTOMER PREPARATION:

∙Unpack the repair kit and read the Repair Instructions.

	F NOTE: Good lighting is required in order to	Step 1:
		Remove all
	see inside the WorkCentre 450c / 450cp	paper and the
	ü	clear plastic
		Printer Output
		Tray
	q Check off the box after each Step is completed.

Printer Output 1. q Remove all paper and the clear plastic Printer Tray

Output Tray in front of the paper tray. (See Figure 1)

2. q Insert approximately a ¼ inch thick stack of
20 lb. paper (measure it) into the Paper Tray.	¼ inch Paper
3. q Insert the Feed Roll Cleaning Pad (provided in	Stack
Kit) in front of the paper stack (Long-Edge-Down) with
		Feed Roll
the green side (coarse side) facing out.
		Cleaning Pad
		with the green
		side facing out

Step 2:

Insert approximately a ¼ inch thick stack of paper into the Paper Tray and insert the Feed Roll Cleaning Pad in front of the paper stack with the green side facing out

(continued)
		Bottom of		3 Feed Rolls are in
		Paper Tray		front of the Pad

	709P00850 Rev A	March 2000
					Figure 1. Inserting the Feed Roll Cleaning Pad
		DRB-FILE			into the Paper Tray

Page 1 of 2