TP-Link TL-SG1005D, TL-SG1008D Installation Guide

LED Explanation

7106507667 REV7.0.1

Installation Guide

5/8-Port Gigabit Desktop Switch

TL-SG1005D/TL-SG1008D

Note: For simplicity, we will take TL-SG1005D for example throughout this Guide.

Connection

TL-SG1005D

On: Power on

O: Power o

1 2 3 4 5

Link/ActPower

On: Link present but no activity Flashing: Transmitting/receiving data

O: No link

Internet

Ethernet Ports (1-5)

Router

LAN PortWAN Port

5 4 3 2 1 POWER

Power Cord

Frequently Asked Questions (FAQ) Specications

Q1. The Power LED is not lit.

The Power LED should be lit when the power system is working normally. If the Power LED is not lit, please check as follows:

A1: Make sure the power cord is connected to the switch with power

source properly.

A2: Make sure the voltage of the power supply meets the

requirements of the input voltage of the switch.

A3: Make sure the power source is ON.

Q2. The Link/Act LED is not lit when a device is connected to the corresponding port.

It is recommended that you check the following items:

A1: Make sure that the cable connectors are rmly plugged into the

switch and the device.

A2: Make sure the connected device is turned on and working well. A3: The cable must be less than 100 meters long (328 feet).

For more information, please visit our website:

http://www.tp-link.com

General Specications

Standard

Protocol

Interface

Network Media (Cable)

LED Indicators

Data Transfer Rate

Advanced Features

Transfer Method

MAC Address Learning

Frame Forward Rate

IEEE802.3, IEEE802.3i, IEEE802.3u, IEEE802.3ab, IEEE802.1p

CSMA/CD

5/8 10/100/1000Mbps Auto-Negotiation RJ45 Ports

10BASE-T: UTP category 3, 4, 5 cable (maximum 100m)

EIA/TIA-568 100

STP (maximum 100m)

100BASE-TX: UTP category 5, 5e cable (maximum 100m) EIA/TIA-568 100

STP (maximum 100m)

1000Base-T: UTP category 5e cable (maximum 100m) EIA/TIA-568

STP (maximum 100m)

100

Power, Link/Act LEDs

Ethernet: 10Mbps (Half Duplex), 20Mbps (Full Duplex) Fast Ethernet: 100Mbps (Half Duplex), 200Mbps (Full Duplex) Gigabit Ethernet: 2000Mbps (Full Duplex)

QoS (802.1p/DSCP Priority)

Store-and-Forward

Automatically learning, automatically aging

10Base-T: 14880pps/Port 100Base-Tx: 148800pps/Port 1000Base-T: 1488000pps/Port

Environmental and Physical Specications

Operating Temperature

Storage Temperature

Operating Humidity

Storage Humidity

0˚C to 40˚C (32˚F to 104˚F)

-40˚C to 70˚C (-40˚F to 158˚F)

10% to 90% RH non-condensing

5% to 90% RH non-condensing

For technical support and other information, please visit

http://www.tp-link.com/support, or simply scan the QR code.

Explanation of the symbols on the product label

BSMI Notice

安全諮詢及注意事項請使用原裝電源供應器或只能按照本產品注明的電源類型使用本產品。清潔本產品之前請先拔掉電源線。請勿使用液體、噴霧清潔劑或濕布進行清潔。注意防潮，請勿將水或其他液體潑灑到本產品上。插槽與開口供通風使用，以確保本產品的操作可靠並防止過熱，請勿堵塞或覆蓋開口。請勿將本產品置放於靠近熱源的地方。除非有正常的通風，否則不可放在密閉位置中。請不要私自打開機殼，不要嘗試自行維修本產品，請由授權的專業人士進行此項工作。

限用物質含有情況標示聲明書

產品元件名稱

PCB

外殼

備考： "○"系指該項限用物質之百分比含量未超出百分比含量基準值。

DC voltage

RECYCLING This product bears the selective sorting symbol for Waste electrical and electronic equipment (WEEE). This means that this product must be handled pursuant to European directive 2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment. User has the choice to give his product to a competent recycling organization or to the retailer when he buys a new electrical or electronic equipment.

限用物質及其化學符號

鉛 Pb

○

鎘

○

汞 Hg

○

六價鉻

CrVI

○

多溴聯苯

PBB

○

多

溴二苯醚

PBDE

Safety Information

Use only power supplies which are provided by manufacturer and in the original packing of this product.

CE Mark Warning

This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

Industry Canada Statement

CAN ICES-3 (B)/NMB-3(B)

SAFETY NOTICES

Cautions

Do not use this product near water, for example, in a wet basement or near a swimming pool. Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.

EU declaration of conformity

TP-Link hereby declares that the device is in compliance with the essential requirements and other relevant provisions of directives 2014/30/EU, 2014/35/EU, 2009/125/EC and 2011/65/EU. The original EU declaration of conformity may be found at http://www.tp-link.com/en/ce

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

○

1) This device may not cause harmful interference.

2) This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modications not expressly approved by the party responsible for compliance could void the user’s authority

to operate the equipment.