Quick Installation Guide
Wireless Dual Band Router
Images may differ from actual products.
1 Connect the Hardware
If your internet is from an Ethernet outlet, connect the router’s Internet port to the Ethernet outlet, then follow Step 4 and 5.
If you already have a router and want to configure this new router as an access point to extend your network, refer to the Access Point Mode section on the back page.
Internet
Power adapter
Power adapter
1Turn off the modem, and remove the backup battery if it has one.
2Connect the modem to the router’s Internet port with an Ethernet cable.
3Turn on the modem, and then wait about 2 minutes for it to restart.
Internet
Power
4 Connect the power
adapter to the router and |
|
turn on the router. |
On / Off |
|
5Verify that the following LEDs are solid on to confirm the hardware is connected correctly.
Power |
2.4GHz |
5GHz |
Internet |
On |
On |
On |
On |
Note: If the 2.4GHz LED and 5GHz LED are off, press and hold the WPS/Wi-Fi On/Off button on the back for about 3 seconds, then release the button. Both LEDs will turn on.