The parts with no reference number or no parts number
in the exploded views are not supplied.
As regards the resistors and capacitors, refer to the
circuit diagrams contained in this manual.
!
Parts marked with this sign are safety critical
components. they must be replaced with identical
components - refer to the appropriate parts list and
ensure exact replacement.
Parts of [ ] mark can be used only with the version designated.
1 SPECIFICATIONS
2 ADJUSTMENT AND CHECKS
3 EXPLODED VIEW AND PARTS LIST
4 PC BOARDS AND PARTS LISTS
5 WIRING DIAGRAM
6 INCLUDED ACCESSORIES
2
3
5
8
16
18
MC-DX25
Amplifier Section
Output Power (L+R)
Output Power Subwoofer:
Input Sensitivity
Frequency Response :
Tuner Section (FM)
Frequency Range
Sensitivity (S/N30dB)
Tuner Section (AM)
Frequency Range
Sensitivity (S/N20dB)
CD Player Section
Frequency Responce
Signa-to-Noise Ratio
Wow and Flutter
1 SPECIFICATIONS
5W + 5W
15 W
300mV
50 to 20,000 Hz
87.5 MHz to 108.0 MHz
20dBuV
522 to 1620 kHz
54dBuV/m
20 to 20,000 Hz (+/-1dB)
55 dB
Unmeasurable
SPEAKER SYSTEM Section
L & R speaker :
Type :
Impedance :
Subwoofer:
Impedance :
Full range flat type
4 ohms
8 ohms
GENERAL
Power Requirements:
Power Consumption:
Dimension (W x H x D ):
Weight: (net)
Standard Accessories:
AC230V, 50 Hz
80 W (standby: less than 1.4W)
Main Unit 160 x 226 x 86 mm
L & R Speaker 140 x 226 x 61mm
Subwoofer 160 x 234 x 330mm
Main Unit 1.15 kg
L & R Speaker 0.6 kg(each)
Subwoofer 5.4 kg
Remote Control Unit x 1
Subwoofer Cable x 1
Speaker Cable x 2
FM Antenna x 1
AM Antenna x 1
Battery for Remote Control x 1
Wall Mount Adaptor x 3
Wall Mount screw x 10
Tape Plastic Wall Anchor x 10
Template for Wall Mounting x 1
Owner s Manual x 1
Warranty Card x 1
Design and specifications are subject to change without notice.
Illustrations may differ slightly from production models.
Weight and dimensions are approximate.
2
2 ADJUSTMENTS AND CHECKS
2-1 TUNER SECTION
Use a screwdriver with a plastic or ceramic grip for all adjustment.
2-1-1 FM adjustment
1. Set the function switch to the FM position.
2. Connect the signal generator output through a 75 ohm dummy
antenna to "ANT" on MAIN PCB.
3. Connect the oscilloscope to the speaker terminal.
4. Set the signal generator as listed in the alignment chart.
2-1-2 AM adjustment
1. Set the function switch to the AM position.
2. Connect the test loop antenna across the output of the signal generator.
3. Connect the oscilloscope to the speaker terminal.
4. Set the signal generator as listed in the alignment chart.