Sunbeam SM9000 User Guide

MASTER SERIES

SM9000

StickMaster®

Platinum

User Guide

Contents

Sunbeam’s Safety Precautions	1
Features of your Sunbeam StickMaster®
Platinum SM9000	2
Using your StickMaster®	5
A Guide to your StickMaster®	8
Care and Cleaning	9
Recipes	10

Important instructions – retain for future use.

Sunbeam’s Safety Precautions

	SAFETY PRECAUTIONS FOR YOUR SUNBEAM	• Hold the stick mixer firmly and up right while
	STICKMASTER.		using it.
•	Do not handle appliance with wet hands.	•	Care should be taken when handling sharp cutting
•	Avoid contact with moving parts.		blades, emptying the bowl and during cleaning.
•	Do not touch the blade while it is operating, as	•	Injury may occur if the stick mixer is not used as
	it is very sharp. After the appliance has been		intended.
	switched off the blade will continue to rotate a	•	Do not operate the appliance without a workload.
	moment longer.	•	When using extremely heavy loads, the appliance
•	Turn the power off and disconnect from supply		should not be operated for more than 4 seconds.
	before changing accessories or approaching parts		This does not apply to the recipes detailed in this
	that move in use.		booklet.
•	Do not use the appliance with hot liquids, as	•	Never insert metal or other utensils, such as
	there is a risk of burns due to splashing.		knives or forks, into the inside of the blade
	Allow hot liquids to be cool enough to touch.		system while the appliance is operating.
	Sunbeam is very safety conscious when	•	Do not use an appliance for any purpose other
	designing and manufacturing consumer products,		than its intended use.
	but it is essential that the product user also exercise	•	Do not place an appliance on or near a hot gas
	care when using an electrical appliance. Listed		flame, electric element or on a heated oven.
	below are precautions which are essential for the	•	Do not place on top of any other appliance.
	safe use of an electrical appliance:	•	Do not let the power cord of an appliance hang
•	Read carefully and save all the instructions		over the edge of a table or bench top or touch any
	provided with an appliance.		hot surface.
•	Always turn the power off at the power outlet	•	Do not operate any electrical appliance with a
	before you insert or remove a plug. Remove		damaged cord or after the appliance has been
	by grasping the plug - do not pull on the cord.		damaged in any manner. If damage is suspected,
•	Turn the power off and remove the plug when		return the appliance to the nearest Sunbeam
	the appliance unattended, before assembling,		Appointed Service Centre for examination,
	disassembling or cleaning.		repair or adjustment.
•	Do not use your appliance with an extension cord	•	For additional protection, Sunbeam recommend
	unless this cord has been checked and tested by		the use of a residual current device (RCD)
	a qualified technician or service person.		with a tripping current not exceeding 30mA in
•	Always use your appliance from a power outlet of		the electrical circuit supplying power to your
	the voltage (A.C. only) marked on the appliance.		appliances.
•	This appliance is not intended for use by persons	•	Do not immerse the appliance in water or any
	(including children) with reduced physical,		other liquid unless recommended.
	sensory or mental capabilities, or lack of	•	Appliances are not intended to be operated by
	experience and knowledge, unless they have been		means of an external timer or separate remote
	given supervision or instruction concerning use		control system.
	of the appliance by a person responsible for their	•	This appliance is intended to be used in
	safety.		household and similar applications such as: staff
•	Children should be supervised to ensure that they		kitchen areas in shops, offices and other working
	do not play with the appliance.		environments; farm houses; by clients in hotels,
•	The temperature of accessible surfaces may be		motels and other residential type environments;
	high when the appliance is operating.		bed and breakfast type environments.

•Never leave an appliance unattended while in use.

If you have any concerns regarding the performance and use of your appliance,
please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line.	1
Ensure the above safety precautions are understood.

Features of your Sunbeam StickMaster® Platinum

Power buttons

Preselect speed 1-9 on the large LCD screen then press the speed button ( ).

For instant power select the () speed setting.

Powerful 700 watt motor

High powered 700 watt motor for the most demanding blending tasks.

Chopper attachment

750ml chopper attachment conveniently attaches to the StickMaster® to chop a variety of food including meats, vegetables, nuts and herbs.

Patent Pending 3 x 3 blade system

Three-way horizontal blades create a horizontal slicing motion to maintain the integrity of the food by slicing and not mashing.

The unique design of the ice crushing blades create vertical crushing and are ideal for hard foods such as ice and nuts.

The combination of horizontal slicing & vertical crushing offers the ultimate in blending performance.

Non-slip mat / storage cap

Keeps the chopper secure on the bench during use and acts as a storage cap when not in use.

2

Detachable stainless wand

The stainless steel wand detaches with a twist and lock design that is intuitive and easy to use.

Dishwasher-safe components

The detachable shaft, chopper bowl, chopping blade, whisk attachment, beaker and non-slip mat/storage caps are dishwasher-safe for easy cleaning.

Large capacity beaker

Large capacity 1.5 litre beaker is ideal for smoothies and your favourite drinks.

The measurement marking are ideal for measuring out ingredients.

Maximum blending capacity is 1000ml as mentioned on Jug. Do not over-fill.

Beaker handle

Provides maximum control of the beaker when blending.

Whisk attachment

Stainless steel whisk conveniently attaches to the StickMaster®. Ideal for beating egg whites, mixing light batters or whisking cream.

3

Features of your Sunbeam StickMaster® Platinum

Tilt Safety

Prevent splashing of liquid around your kitchen if the stick mixer is accidentally tilted. Once nearing 90 degrees, the motor will automatically turn off, stopping ingredients being splashed around or hands being in contact with the blades

Soft Start

Prevent the initial splash of liquids often experienced when using a stick mixer, with the Soft Start feature. Soft Start slowly ramps up the speed regardless of the initial speed selected.

Speeds 1-9 plus Turbo

Speeds 1-9 can be selected by turning the LCD dial in a clockwise manner. The selected speed will be shown on the LCD screen.

Once a speed is selected, hold in the top control button. Soft Start will be activated.

To select Turbo setting, hold in the bottom control button.

LCD User Interface

The backlit LCD screen provides feedback and lets you know what speed you have selected, when Soft Start is active and when the Tilt safety function has been activated.

4

Using your StickMaster®

It is recommended to wash your StickMaster® shaft, beaker, chopping bowl and whisk in warm soapy water with a soft cloth.

Rinse and dry thoroughly.

Important: Before using your StickMaster® remove any packaging material and promotional labels or tags.

Important: Ensure that the StickMaster® is unplugged from the power outlet before assembling or removing attachments.

1.Insert the motor housing into the wand and twist the wand in a clockwise position until you hear a click. See Figure 1.

Note: All stick mixers are designed to operate only when the power buttons remain depressed.

Note: The power button ( ) should be released when selecting the turbo speed button ().

4.To stop the stick mixer, take your finger off

the power button ( ) or the turbo speed button ().

5.To detach the wand, twist the shaft in an anti clockwise position until the wand unscrews from the motor housing.

See Figure 2.

Figure 2

Figure 1

2.Plug the power cord into a 230-240 volt power outlet and turn the power on.

3.Lower the stick mixer into food and select

from speed 1 through to 9 and depress the

power button ( ) or setting

() at the top of the motor housing.

5

Using your StickMaster® continued

Using the chopper attachment

1.Place the chopper bowl on the non-slip mat, ensuring the surface is clean and level.

2.Fit the stainless steel chopping blade into the chopper bowl.

Note: Care shall be taken when handling sharp cutting blades.

3.Place food into the chopper bowl.

4.Attach the lid onto the chopper bowl and rotate the lid in a clockwise direction until it locks into position.

5.Insert the motor housing into the hole on the top of the chopper attachment and turn in a clockwise direction until you hear a click. See Figure 3.

7.Hold the bowl with one hand while operating the stick mixer. Select from

speed 1 through to 9 and depress the

power button ( ) or setting () at the top of the motor housing

Note: All stick mixers are designed to operate only whilst the power buttons remain depressed.

Note: The power button ( ) should be released when selecting the turbo speed button ().

8.To stop the StickMaster®, take your finger off the power button or turbo speed button.

9.To detach the chopper attachment, twist the motor housing in an anti-clockwise direction until the two pieces separate. See Figure 4.

Note: Care shall be taken when handling sharp cutting blades, emptying the bowl and during cleaning.

Figure 3
6.Plug the power cord into a 230-240 volt	Figure 4
power outlet and turn the power on.

6