Siemens 277IWLAN-V211, 277IWLAN-V210 User Manual

Commissioning the plant

9.4 RFID tag system

Mobile Panel 277F IWLAN V2, Mobile Panel 277F IWLAN (RFID Tag)

250 Operating Instructions, 09/2010, A5E02766325-01

3. Press the "RFID Config" icon.

The following dialog appears:

4. Select the effective range ID in the "Effective range" selection box and the ID of the

defective RFID tag in the "Tag" selection box.

5. Bring the HMI device into the effective range of the RFID tag.

6. Press "Save ID".

The HMI device transmits the ID to the RFID tag. The new RFID tag has the ID of the

previously used RFID tags.

7. Click "Exit" to close the dialog.

8. Close the Control Panel and start the project.

9. Log the HMI device onto a machine to check the new RFID tag.

– When the logon is successful, you can continue working in the project.

– If logon is not possible close the dialog and repeat steps 2 to 8.

REVIEW ENGLISH

27.07.2010

Commissioning the plant

9.5 Diagnostics

Mobile Panel 277F IWLAN V2, Mobile Panel 277F IWLAN (RFID Tag)

Operating Instructions, 09/2010, A5E02766325-01

251

9.5 Diagnostics

Use the diagnostics function to determine the following:

● Does signal acquisition function without errors on the HMI device?

● Does the safety-related module of the HMI device work properly?

Diagnostic function of the HMI device in STEP 7

The HMI device provides diagnostics conforming to PROFINET IO standard IEC 61784-1,

Ed1, CP 3/3 for standard application.

The diagnostics function cannot be parameterized. The diagnostics are always enabled and

information is provided automatically by the HMI device in STEP 7 in the event of an error.

The diagnostic function also passes the "Communication error" message, if at all possible,

for the safety-related component.

The communication between the HMI device as an input and output device, and the F-CPU

and IO controller is disrupted. This situation can be caused, for example, by an incorrect

PROFIsafe address or the lack of a wireless network.

Reading diagnostics information

Open the module diagnostics in STEP 7 to determine the cause of the error. For additional

information, refer to the online help for STEP 7.

You also have the option of reading the diagnostic information using SFB 52 or SFB 54 in

the standard user program. For additional information, refer to the "System and Standard

Functions" reference manual.

REVIEW ENGLISH

27.07.2010