Maytag MET8665XW, MET8665XB, MET8665XS, MET8885XW, MET8885XB Dimension Guide

30" (76 cm) Freestanding Electric Range

PRODUCT MODEL NUMBERS

MET8665X MET8885X

MET8775X

Electrical Connection:

●This range is manufactured with the neutral terminal connected to the cabinet. Use a 3-wire, UL listed, 40or 50-amp power supply cord (pigtail) (see the following Range Rating chart). If local codes do not permit ground through the neutral, use a 4-wire power supply cord rated at 250 volts, 40 or 50 amps and investigated for use with ranges.

Range Rating*		Specified Rating of
		Power Supply Cord Kit
		and Circuit Protection
120/240 Volts	120/208 Volts	Amps
8.8 - 16.5 KW	7.8 - 12.5 KW	40 or 50**
16.6 - 22.5 KW	12.6 - 18.5 KW	50

** The NEC calculated load is less than the total connected load listed on the model/serial rating plate.

**If connecting to a 50-amp circuit, use a 50-amp rated cord with kit. For 50-amp rated cord kits, use kits that specify use with a nominal 1³⁄ " (34.9 mm) diameter connection opening.

●A circuit breaker is recommended.

●The range can be connected directly to the circuit breaker box (or fused disconnect) through flexible or nonmetallic sheathed, copper or aluminum cable. See the “Electrical Connection - U.S.A Only” section.

CABINET OPENING DIMENSIONS

Cabinet opening dimensions shown are for:

25" (63.5 cm) countertop depth, 24" (61 cm) base cabinet depth, 36" (91.4 cm) countertop height

PRODUCT DIMENSIONS

B**

C*

A*

	F	D
		E***
	A. 35³⁄ " ± ¹⁄ " (90.8 cm ± 0.3 cm)	D. 28¹⁄ " ± ¹⁄ " (72.4 cm ± 0.6 cm)
	cooktop height (minimum) with	depth with handle
	leveling legs screwed all the	E. 26¹⁄ " ± ¹⁄ " (66.4 cm ± 0.3 cm)***
	way in*	F. 29¹ ⁄ " ± ¹⁄ " (76.0 cm ± 0.2 cm)
	B. Model/serial/rating plates
		width
	(located behind the control
	panel)**

C.47¹⁄ " ± ¹⁄ " (119.7 cm ± 0.3 cm) overall height (minimum) with leveling legs screwed all the way in*

*Range can be raised approximately 1" (2.5 cm) by adjusting the leveling legs.

**Model/serial/rating plates may be rotated up from behind the control panel for viewing from the front of the range.

***Excludes handle. Dimension given is from wall to front of oven door and will vary based on electric outlet receptacle installation.

								A. 18" (45.7 cm) upper cabinet	F. Cabinet door or hinge should
		B						to countertop	not extend into cutout*
								B. 13" (33.0 cm) upper cabinet	G. 1 " (3.8 cm) min. from right
				D
		C						depth	side cabinet
								C. 30" (76.2 cm) min. opening	H. 2" (5.1 cm) min. from floor
								width.	I. 7" (17.8 cm) min. from floor
A
			E					D. For minimum clearance to the	J. 8" (20.3 cm) width
								top of the cooktop, see
									K. 3 " (8.91 cm) min. from floor
								NOTE.
								E. 30" (76.2 cm) min. opening
		J						width
			G					Proper positioning of outlet shown above.
	I	H					F	Nothing located in shaded areas can extend more than 1 " (3.8 cm)
								from wall or range will not slide all the way back.
								NOTE: 24" (61.0 cm) minimum when bottom of wood or metal cabinet is
								covered by not less than ¹⁄ " (0.64 cm) flame retardant millboard covered
								with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel,
								0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.
								30" (76.2 cm) minimum clearance between the top of the cooking platform
				K
								and the bottom of an uncovered wood or metal cabinet.

Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation	Ref. W10289536A
Instructions packed with product. Specifications subject to change without notice.	8/18/10