HP SCANJET 8390 User Manual

hp scanjet 2200c scanner

Setup

Setting up your scanner

Your scanner comes with a CD-ROM, a USB cable, and a power supply.

1. Install the software (BEFORE installing the hardware)

a. Quit all open programs (except Windows). b. Insert the CD-ROM. If the installation program does not start automatically, open

the Windows Start menu, click Run, and then type x:setup.exe (where x is the letter of the CD-ROM drive).

c. Follow the directions onscreen.

2. Unlock the scanner

Unlock the scanner by removing the plastic key from the bottom of the scanner. a. Turn the scanner so the bottom is up. b. Turn the green key to the left 1/4 turn and remove it from the scanner.

Note: Store the key in a safe place to re-lock the scanner if it is transported.

3. Connect the scanner (AFTER installing the software) Caution: Only use the power supply, cables, and accessories supplied with this

equipment or expressly approved by Hewlett-Packard Company. a. Connect the USB cable to the USB port on the back of the scanner. b. Connect the other end of the USB cable to one of the USB ports on your PC.

4. Connect the power supply

a. Connect the power supply to the scanner. b. Plug the power cord into an electrical outlet. This turns on power to the scanner

(there is no on/off switch).

Congratulations! Your scanner is now installed.

Note: When your computer detects new hardware, you might see a message indicating a file was not found. To resolve this message, click Browse in the dialog box, locate the CD-ROM drive, and then click OK. Click OK again to close the dialog box.

5. Before you scan

a. Open the scanner lid. b. Place the item to be scanned face-down on the scanner glass. The item must be

centered on the glass, with the top of the graphic or text closest to the front of the scanner.

6. Begin scanning

Choose one of the following:

• Press a button on the scanner:

Scan: Starts the HP scanning software and scans your item. Copy: Scans and prints a copy of your item.

• Double-click the scanner icon on the Windows desktop to open the software and scan manually.

• Click Start, point to Programs, HP PrecisionScan LTX, and then click HP

PrecisionScan LTX to open the software and scan manually.

Find help and support

• For help using your HP ScanJet scanner, open the HP PrecisionScan LTX software and click Help.

• For installation help, support, and specifications either:

- click HP Online Support Supplement from the Help menu.

- open the folder for your language on the CD-ROM and double-click

hpscanjt.hlp.

Note: The Support Supplement also contains warranty, service, and regulatory

information.

• For technical support and drivers, go to www.hp.com/go/cposupport

• For scanning ideas, tips, and product demonstrations, visit the HP Web site at www.scanjet.hp.com

helpful