BI WDHG 861484 UK
EN
Quick Guide
THANK YOU FOR PURCHASING A HOTPOINT PRODUCT.
To receive more comprehensive assistance, register the
appliance on
www.hotpoint.eu/register
Before using the appliance carefully read the Health and Safety guide.
Before using the machine, it is imperative that the transport bolts are removed. For more
detailed instructions on how to remove them, see the Installation Guide.
CONTROL PANEL
WASH CYCLE TABLE
For all testing institutes:
2) Long cotton cycle: set programme 5 at temperature 40°C.
3) Long synthetics cycle: set cycle 6 at a temperature of 40°C.
* By selecting the cycle and excluding the spin cycle, the washer-dryer will drain only.
** The duration of the programme is shown on the display.
*** After programme end and spinning with maximum selectable spin speed, in default
programme setting.
4) Eco Cotton -
Test wash cycle in compliance with regulations 1061/2010. Set “
5” wash cycle
at a temperature of 60°C to access this cycles.
For wash programmes with temperatures above 50°C, we recommend using powder detergent
rather than liquid, and following the directions given on the detergent package.
This data may dier in your home due to changing conditions in inlet water temperature,
water pressure etc. Approximate programme duration values refer to the default setting of
the programmes, without options.
The values given for programmes other than the Eco 40-60
programme are indicative only.
For all Test Institutes
1)
Eco 40 -60 (Wash)- Test wash c ycle in compliance w ith EU Ecodesign regu lation 2019/2014. The most
eff icient programm e in terms of energy an d water consumption f or washing normall y soiled cotton
laundry.
Eco 40 -60 (Dry ing)-
Test wash cycle in compliance with EU Ecodesign regulation
2019/2014
. To
access “wash and dry” cycle select “Eco 40-60” wash programme and set “Drying” option leval
to
“ ”.
The most ecient programme in terms of energy and water consumption for washing
and drying normally soiled cotton laundry.
Note: spin spe ed values shown on th e display can slightl y differs fro m the values state d in the table.
Maximum load 8 kg
Power input in o mode 0.5 W / in left-on mode 8 W
Detergents and
Additives
Recommended
detergent
Residual
dampness %
(***)
Energy
consumption
kWh
Total water lt
Laundry
temperature
°C
Wash cycle
Temperature
Maximum
spin
(r.p.m.)
Max.
load
(kg)
Dura-
tion
(h : m)
Drying
Wash
Fabric
softener
Powder Liquid
Setting Range 2 3
1 Mixed Wash&Dry 40 °C
- 40 °C 800 3,5 **
–
– – – –
2 Shirts and T-shirts 40 °C - 40 °C 1000 2,0 **
–
– – – –
3 Pre Iron – – – 2,0 ** – – – – –
– – – –
4 Steam Refresh – – – 2,0 ** – – – – –
– – – –
5 Cotton (2) 40 °C - 60 °C 1400 8,0 3:55
49 1 90 40
6 Synthetics (3) 40 °C
- 60 °C 1200 4,0 2:55
35 0,75 55 43
7 Anti Stain Quick 40 °C
- 40 °C 1200 4,5 **
–
– – – –
8 Anti Stain 40° 40 °C - 40 °C 1400 8,0 **
–
– – – –
9 White 60 °C - 90 °C 1400 8,0 2:45
49 0,9 90 55
10 Eco 40-60 (1) 40 °C 40°C
1351 8,0 3:30
53 0,77 54 33
1351 4,0 2:45
53 0,65 52 36
1351 2,0 2:10
53 0,45 37 33
11 20°C 20 °C
- 20 °C 1400 8,0 1:50
–
49 0,16 90 22
12 Delicates 30 °C
- 30 °C 0 1 **
–
– – – –
13 Wool 40 °C - 40 °C 800 2 **
–
– – – –
14 Rapid 30‘ 30 °C - 30 °C 800 4,5 0:30 –
–
71 0,2 45 27
Rinse & Spin – – 1400 8,0
–
–
– –
– – – –
Spin & Drain * – – 1400 8,0
–
– – – –
– – – –
Required dosage Optional dosage
5 Eco Cotton (4)
60 °C 60 °C 1400 8,0
3:45
53 1,04 60
–
1. ON/OFF button
2. START/PAUSE button
3. TEMPERATURE button
4. ENERGY SAVER button
5. DRY ONLY button / Lock
button
6. DRYING SETTINGS button
7. START DELAY button
8. SPIN SPEED button
9. WASH CYCLE SELECTOR KNOB
1 2
5
6
7
8
4
3
9
DISPLAY INDICATORS
Washing phase
Indicates washing phase of the cycle
Drying phase
Energy Saver activated
Key lock activated
Drying only
Time drying mode
Drying automatic levels
Start delay activated
Door locked
PRODUCT DESCRIPTION
1. Worktop
2. Detergent dispenser
3. Control panel
4. Door handle
5. Door
6. Water lter
7. Adjustable feet (4)
DETERGENT DISPENSER
Compartment 1:
Do not insert detergent in this compartment.
Compartment 2: Washing detergent
(powder or liquid)
Compartment 3: Additives (fabric softeners,
etc.)
The fabric softener must not exceed the “MAX”
level.
! Use powder detergent for white cotton
garments, for pre-washing, and for washing at
temperatures over 60°C.
! Follow the instructions given on the detergent packaging.
1
2
3
1.
3.
2.
5.
4.
6.
7.
WASH CYCLES
Follow the instructions on the symbols of the garment’s wash
care label. The value indicated in the symbol is the maximum
recommended temperature for washing the garment.
Mixed Wash&Dry
use programme 1 to wash and dry mixed garments (cotton and
synthetics). This cycle may be used to wash and dry loads of up to 3,5 kg;
we recommend the use of liquid detergent.
The use of the steam in this programme is optimised to reduce the
formation of creases on garments, making them easier to iron.
Shirts and T-shirts
Use programme 2 to wash and dry shirts and T-shirts in dierent fabrics
and colours to ensure maximum care. This cycle may be used to wash
and dry loads of up to 2 kg. To achieve optimum results, use liquid
detergent and pre-treat cus, collars and stains. The use of the steam in
this programme is optimised to reduce the formation of creases on
garments, making them easier to iron.
Pre Iron
Use this programme immediately before ironing; max. 1,5 kg load. The
use of the steam in this programme is optimised to reduce the formation
of creases on garments, making them easier to iron.
Steam Refresh
For refreshing garments, neutralised unpleasant odours and relaxing the
bres by delivering steam into the drum. The garments will be damp at
the end of the cycle.
Cotton
Suitable for washing towels, underwear, table cloths, etc. made of
resistant linen and cotton that are moderately to heavily soiled.
Synthetics
Suitable for washing moderately soiled garments made of synthetic
bres (e.g. polyester, polyacrylic, viscose, etc.) or mixed synthetic-cotton
bres.
Anti Stain Quick
this programme is ideal for washing the most dicult daily stains in 1
hour. It is ideal for mixed fabrics and coloured garments, caring for your
clothes as it washes.
If the drying function is selected, a drying cycle automatically activates at
the end of the wash cycle that resembles open-air drying, with the added
advantages of preserving garments from yellowing due to sunlight
exposure and preventing loss of whiteness caused by the possible
presence of dust in the air. Dryness level “ ” recommended.
Anti Stain 40°
the programme is suitable to heavily-soiled garments with resistant
colours. It ensures a washing class that is higher than the standard class (A
class). When running the programme, do not mix garments of dierent
colours. We recommend the use of powder detergent. Pre-treatment with
special additives is recommended if there are obstinate stains.
If the drying function is selected, a drying cycle automatically activates at
the end of the wash cycle that resembles open-air drying, with the added
advantages of preserving garments from yellowing due to sunlight
exposure and preventing loss of whiteness caused by the possible
presence of dust in the air. Dryness level “ ” recommended.
White
For heavily soiled whites and resistant colours.
Eco 40-60
For washing normally soiled cotton garments declared to be washable at 40 °C
or 60 °C, together in the same cycle. This is the standard cotton programme
and the most ecient in terms of water and energy consumption.
20°C
For washing lightly soiled cotton garments, at a temperature of 20 °C.
Delicates
For washing very delicate garments. It is advisable to turn the garments
inside out before washing them. For best results, use liquid detergent on
delicate garments.
We recommend turning the garments inside out before washing and
placing small items into the special bag for washing delicates. Use liquid
detergent on delicate garments for best results.
When selecting an exclusively time-based drying function, a drying cycle is
performed at the end of the wash cycle that is particularly delicate, thanks
to light handling and appropriate temperature control of the water jet.
The recommended durations are:
1 kg of synthetic garments --> 150 min
1 kg of synthetic and cotton garments --> 180 min
1 kg of cotton garments --> 180 min
The degree of dryness depends on the load and fabric composition.
Wool - Woolmark Apparel Care - Green:
the wool wash cycle of this machine has been approved by
The Woolmark Company for the washing of wool garments
labelled as “hand wash” provided that the products are
washed according to the instructions on the garment label
and those issued by the manufacturer of this washer-dryer.
(M1318)
Rapid 30‘
For washing lightly soiled garments in a short time. Not suitable for wool,
silk and garments to be washed by hand.
Rinse & Spin
Designed for rinsing and spinning.
Spin & Drain
Designed for spinning and draining the water.
Eco Cotton
For washing normally soiled cotton garments at 60°C.
Door locked indicator
if the symbol is o the door is locked. To prevent any damage, wait
until the symbol turns on before opening the door.
To open the door while a cycle is in progress, press the START/PAUSE
button ; if the symbol is lit, the door can be opened.
FIRSTTIME USE
Once the appliance has been installed, and before it is used for the rst
time, run a wash cycle with detergent and no laundry, by setting the cycle
9(60°C).
DAILY USE
Prepare the laundry by following the suggestions appearing under the
“TIPS AND SUGGESTIONS” section.
- Press the ON/OFF button ; the indicator light relative to START/PAUSE
will ash slowly.
- Open the door. Load the laundry while making sure not to exceed the
maximum load quantity indicated in the wash cycle table.
- Pull out the detergent dispenser drawer and pour the detergent into the
relevant compartments, as described in the “DETERGENT DISPENSER
DRAWER” section.
- Close the door.
- The machine automatically displays the default temperature and spin
speed values for the selected cycle, or the most recently used settings if
they are compatible with the selected cycle.
- Select the desired wash cycle.
- Select the desired options.
- Press the START/PAUSE button to start the wash cycle; the relative
indicator light will light up steady and the door will lock ( symbol o).
PAUSING A CYCLE
To pause the wash cycle, press the START/PAUSE button again; the
indicator light will ash. If the symbol is lit, the door may be opened. To
start the wash cycle from the point at which it was interrupted, press the
START/PAUSE button again.
OPENING THE DOOR, IF NECESSARY
Once a cycle starts, the symbol turns o to signal that the door cannot
be opened. While a wash cycle is running, the door remains locked. To
open the door while a cycle is under way, for example, to add or remove
garments, press the START/PAUSE button to pause the cycle; the
indicator light will ash. If the symbol is lit, the door may be opened.
Press the START/PAUSE button again to continue the cycle.
CHANGING A RUNNING WASH CYCLE
To change a wash cycle while it is in progress, pause the washer-dryer using
the START/PAUSE button (the relative indicator light will ash), then
select the desired cycle and press the START/PAUSE button again.
! To cancel a cycle that has already begun, press and hold the ON/OFF
button. The cycle will be stopped and the machine will switch o.
AT THE END OF THE WASH CYCLE
This will be indicated by the word “END” on the display; when the
symbol switches on, the door may be opened. Open the door, unload the
laundry and switch o the machine. If you do not press “ON/OFF”
button, the washing machine will switch o automatically after about a
10 minutes. Close the water tap, open the door and unload the washing
machine. Leave the door ajar to allow the drum to dry.
OPTIONS
! If the selected option is incompatible with the programme set, the
incompatibility will be signalled by a buzzer and the corresponding
indicator light will ash.
! If the selected option is incompatible with another previously set
option, only the most recent selection will remain active.
Energy saver
This option saves energy by not heating the water used to wash your
laundry – an advantage both to the environment and to your energy bill.
Instead, intensied wash action and water optimisation ensure great
wash results in the same average time of a standard cycle.
For the best washing results we recommend the usage of a liquid
detergent.
Start Delay
To set the selected programme to start at a later time, press the button to
set the desired delay time. The
h.
symbol lights on the display when this
function is enabled. To cancel the delayed start, press the button again
until the value “0” is shown on the display.
Temperature
Each wash cycle has a pre-dened temperature. To modify the
temperature, press the “Temp.” button. The value will appear on the
display.
Spin
Each wash cycle has a pre-dened spin speed. To modify the spin speed,
press the “Spin Speed” button. The value will appear on the display.
Setting the drying cycle
The rst time the button “Drying Settings” is pressed, the machine will
automatically select the maximum drying cycle which is compatible with
Loading...