Installation Instructions
GT1TM LED Pedestrian 16x18’’ Incandescent Look
Signal Modules / PS7-CFF1-46A-J & PS7-CFF1-26A-J
Full Hand/Person Overlay/Countdown
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Prepare Electrical Wiring
Electrical Requirements
Do not use in wet locations
Follow all National Electric Codes (NEC) and local codes.
Installation Steps:
1.Verify input voltage is within specified range on the back of the LED signal module before installation. Failure to do so will cause lamp to fail.
2.Open front cover of (customer supplied) traffic signal housing.
3.Connect the wires to the appropriate terminal block within customer supplied signal housing. (Orange wire (+ for Hand), Blue Wire (+ for Person) and White wire (for the neutral).
4.Close front cover of (customer supplied) traffic signal housing ensuring that the module gasket is tight within the housing.
16 x 18 inch Overlay / Countdown
Risk of Electric Shock
Install unit in enclosure tested to be suitable for wet locations only.
Back of 16 x 18 inch Pedestrian Module
Blue Wire |
White Wire |
Orange Wire |
Voltage Rating |
Countdown Option
Jumpers …Page 2 (See next page)