Compatible with 315 MHz or 390 MHz garage door openers manufactured after January 1, 1993. Make sure the garage door opener has a working light bulb because it is a programming indicator.
3-BUTTON REMOTE CONTROL MODEL 139.30499
To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:
•ALWAYS keep remote controls out of reach of children. NEVER permit children to operate or play with remote controls.
•Activate gate or door ONLY when it can be seen clearly, is properly adjusted and there are no obstructions to door travel.
•ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to cross path of moving gate or door.
Learn |
|
OR |
|
|
|
LED |
|
Learn |
Green or |
|
LED |
|
||
|
Purple |
|
|
||
Red/Orange |
|
|
Locate the Learn button on the garage door opener.
NOTE: Your garage door opener may look different.
OR
Learn
LED
Yellow
Locate the Program button on the remote control.
Program Button
1To enter programming mode, press the Program button until the LED on the front of the remote control turns on.
Safety Pin or
Paper Clip
2Press and release the Learn button on
the garage door opner.
The Learn LED will light.
Within 30 seconds...
3Press and release the remote control button you want to use...
Check to see if the garage door opener light bulb blinks. If not, wait for the remote control LED to light solid then slowly press and release the remote control button again. Repeat until the light bulb blinks.
DO NOT press the button after the light bulb blinks.
4 |
To exit programming mode, press |
5 |
To test, press the programmed button on the remote control... |
|
any remote control button except |
|
|
|
the button that was just programmed. |
|
|
The garage door opener will activate.
The LED on your remote will stop flashing when the battery is low and needs to be replaced.
To replace battery, open the case as shown. Insert battery positive side up (+). Replace the battery with only 3V2032 coin cell batteries. Dispose of old battery properly.
To prevent possible SERIOUS INJURY or DEATH:
•NEVER allow small children near batteries.
•If battery is swallowed, immediately notify doctor.
To reduce risk of fire, explosion or chemical burn:
•Replace ONLY with 3V2032 coin batteries.
•DO NOT recharge, disassemble, heat above 212° F (100° C) or incinerate.
NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery
THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards for Home or office use. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10A20