Before using the dishwasher, read the user instructions!
GSI 6999 |
Quick Reference Guide |
|
GB |
||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Programme selector knob
On / Off button
Start button
Switches “on” when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.
Indicators
Add regeneration salt
Only add regeneration salt immediately before starting a wash programme.
Add rinse aid
No water
Check that the appliance fills with water.
Wash cycle
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Programme |
|
Pre-Rinse |
|
Washing |
|
Drying |
|||
|
|
|
end |
||||
|
|
|
|
|
|
|
|
Options
Time and failure display 3)
Indicates in hours the time remaining until
the start of the wash cycle. Switches off at
programme start and indicates the
remaining time in hours and minutes.
“F....” Information for the After-Sales Service
“Delayed start” buttons
The wash cycle can be programmed to start after 1 - 24 hours. With each successive touch of the button, the delayed start indicator increases by 1 hour, and after 24 returns to 00. Then press the Start button. The dishwasher will start at the set time.
“Half load” button
This function can be used with any programme. The indicator lamp switches on. The wash cycle is activated for the upper or lower rack only.
When washing without the top rack, press the “Half Load” button (LED alight).
|
|
|
|
Programme chart |
Detergent 2) |
Consumption 3) |
|||||
|
|
|
Programmes |
|
Loading instructions |
A |
B |
Litres |
kWh |
Minutes |
|
|
|
|
|
AutoNormal |
40-55°C |
Automatic programme recommended |
|
|
|
|
|
|
|
|
|
for routine washes, with no dried-on |
X |
X |
10-13 |
0.8-1.05 |
60-120 |
||
|
|
|
|
|
|
or burnt food (not for EN 50242). |
|
|
|
|
|
|
|
|
|
|
|
Automatic programme recommended |
|
|
|
|
|
|
|
|
|
AutoIntensive 60-70°C |
for heavily soiled crockery with dried- |
X |
X |
13-20 |
1.1-2.0 |
100-150 |
|
|
|
|
|
on or burnt food, for example pans |
|||||||
|
|
|
|
|
|
|
|
|
|||
|
|
|
|
|
|
and saucepans. |
|
|
|
|
|
|
|
|
|
Pre-Rinse |
cold |
Crockery to be washed later. |
- |
- |
4.0 |
0.03 |
14 |
|
|
|
|
||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Glass |
40°C |
Light soiling, for example glasses and |
X |
- |
10.0 |
0.80 |
55 |
|
|
|
|
||||||||
|
|
|
|
|
|
cups. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Rapid 30 min |
40°C |
Lightly soiled crockery with no |
X |
- |
10.0 |
0.65 |
30 |
|
|
|
|
|
|
dried-on food. |
|
|
|
|
|
|
|
|
|
Eco 1) |
50°C |
Normally soiled crockery. |
X |
X |
13.0 |
1.05 |
145 |
|
|
|
|
|
|
|
|
|
|
|
|
1)Reference programme for energy label in compliance with EN 50242 regulations;
2)Refer to “User instructions“;
3)Program data obtained in conformity with European standard EN 50242. Values may vary in relation to usage, e.g.: different loads, water temperatures - above or below 15°C - as well as water hardness and power supply voltage, etc.
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.
5019 496 90315
(We reserve the right to make technical modifications)
BK/I/B/GB
How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Switch on the appliance
How to fill the detergent dispenser
Check the rinse aid level
Check the regeneration salt level
Load the racks
Close the door, turn on the water tap
Select a programme
Select additional options
Press the ON / OFF button.
Large compartment A:
With each wash cycle. A B C
Small compartment B:
For programmes with pre-wash only.
Mechanical indicator C.
Electric indicator on control panel (if provided).
On models with water softener system only.
Mechanical indicator D.
Electric indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
The last programme selected will light up.
Select the desired programme (using the specific button or knob). The corresponding indicator lamp lights up.
If necessary (and if provided) the corresponding indicator lamp lights up.
Press the START button
Wash cycle
Switch off the appliance
Shut off the water tap, unload the racks
The selected programme is then memorised (even in the event of power failure).
“Change programme”
Press the START button for 2 sec. until the Start indicator lamp switches off; Select another programme and press the START button again.
-Only open the dishwasher if necessary (Warning: beware of hot steam).
-If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted.
Only after the START button has switched off: Press the ON / OFF button. All the indicator lamps switch off.
Warning: when the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
BK/II/B/GB
Loading...