Apple iMac G5 Instructions
iMac G5
Inverter, 17-inch
Replacement Instructions
Follow the instructions in this sheet carefully. Failure to follow these instructions could
damage your equipment and void its warranty.
Note:
Online instructions are available at http://www.apple.com/support/doityourself/.
Tools Required
• Use the tool provided, or a Phillips #2 screwdriver, preferably with a magnetized tip
• Screw tray or something equivalent to hold the screws
• Flat-blade screwdriver
Part Location
033-2502 Rev. D
Important Things to Know
1.
All customer removable screws are brass colored. Do not remove screws
unless they are brass colored, or you will void your warranty
2. A magnetized “L”-shaped Phillips screwdriver is included with the replacement part.
3. Remove the gray plastic inverter cover before returning the inverter to Apple. The
procedure will show you how.
4. Ground yourself when working on the computer. The procedure will show you how to
ground yourself.
5. Do not pull on individual wires when disconnecting a part; pull on the connector.
6. Keep drinks and other liquids away from the area you are working on the iMac.
.
2 -
iMac G5 Inverter, 17-inch
Opening the Computer
Note: These instructions cover the iMac G5 (17-inch) models. The models may look
slightly different from one shown in the illustration; however, the following
procedure applies to both models.
1. Turn your computer off by choosing Shut down from the Apple (K) menu.
2. Disconnect all cables and the power cord from your computer.
3. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of the
computer and slowly lay the computer face down as shown.
iMac G5 Inverter, 17-inch -
3
4. Locate the three silver case screws circled below. You may have to lift the stand to
locate the middle case screw.
display/bezel assembly and cannot be removed.
Using the tool provided, or a Phillips #2 screwdriver, loosen the three captive screws.
Turn the screws to the left until they stop turning.
stop turning
.
Note:
These screws are captive; they are part of the
Don’t force the screws once they
5. Holding the back cover by the metal stand, tilt the cover up and lift it off the computer.
Set the back cover aside.
4 -
iMac G5 Inverter, 17-inch
Removing the Inverter
1. To access the inverter assembly other service modules have to be removed. This
procedure will show you how to remove and replace each module. As you remove
each module, set it aside, along with the screws for that module.
2. Ground yourself. Touch the metal surface (as shown below) on the inside of the
computer to discharge any static electricity.
Warning: Always discharge static electricity before you touch any parts or
install any components inside the computer. To avoid generating static
electricity, do not walk around the room until you have finished installing the
part and closed the computer
.
iMac G5 Inverter, 17-inch -
5
3. Locate the optical drive.
4. Using the tool provided, or a Phillips #2 screwdriver, remove the three optical drive
screws circled below. Set the screws aside.
6 -
iMac G5 Inverter, 17-inch
Loading...