3D Connexion RMR203HG User Manual

Loading...

Temperature and Humidity Station

with Atomic Time

Model: RMR203HG

USER MANUAL

 

CONTENTS

 

Overview...........................................................................

2

Front View...........................................................................

2

Back View............................................................................

2

Remote Sensor...................................................................

3

Getting Started..................................................................

3

Insert Batteries....................................................................

3

RemoteSensor...................................................................

3

Sensor Data Transmission.................................................

4

Clock.................................................................................

4

Clock Reception..................................................................

4

Manually Set Clock............................................................

5

Temperature And Humidity............................................

5

Ice Warning.........................................................................

5

Backlight..........................................................................

5

Reset................................................................................

5

Precautions......................................................................

5

Specifications..................................................................

6

About Oregon Scientific..................................................

6

EU-Declaration of Conformity

7

EN

 

1

RMR203HG IM EN R5.indd 1

 

 

2007.8.9 5:27:36 PM

 

 

 

 

 

 

3D Connexion RMR203HG User Manual

EN

OVERVIEW

FRONT VIEW (FIG 1)

OUT

1.Remote sensor reception indicator

2.Clock signal reception indicator

3.MODE: Change settings / display

4.backlight for 5 seconds

: Increase / decrease settings; activate / deactivate clock reception signal

6.Outdoor temperature and humidity

7.Indoor temperature and humidity

2

8.Clock with weekday

9.MEM: View current, maximum, minimum temperature / humidity

10.Ice alert LED indicator

BACK VIEW (FIG 2)

1.°C / °F: Select temperature unit

2.RESET: Reset unit to default settings

3.EU / UK: Select the nearest radio signal

RMR203HG IM EN R5.indd 2

 

 

2007.8.9 5:27:38 PM

 

 

 

 

 

 

REMOTE SENSOR (FIG 3)

2

1

4

3

5

1.LED status indicator

2.Wall mount hole

3.Battery compartment

4.RESET hole

5.CHANNEL switch

GETTING STARTED

INSERT BATTERIES

1.Remove the battery compartment.

2.Insert the batteries, matching the polarities (see FIG 2).

EN

LOCATION

MEANING

 

 

 

Clock / alarm

Main unit batteries low

 

 

Outdoor temperature

Sensor batteries low

and humidity area

 

 

 

REMOTE SENSOR

The main unit can collect data from up to 3 sensors.

To set up the sensor:

1.Open the battery compartment (see FIG 3).

2.Select a channel then press RESET.

3.Close the battery door.

4.Place the sensor within 30 m (98 ft) of the main unit using the table stand or wall mount.

TIP Ideal placements for the sensor would be in any location on the exterior of the home at a height of not more than 1.5 m (5 ft) and which can shield it from direct sunlight or wet conditions for an accurate reading.

3

RMR203HG IM EN R5.indd 3

 

 

2007.8.9 5:27:41 PM

 

 

 

 

 

 

+ 4 hidden pages