Zoom Stryder Quick Start Manual

QUICK

START

GUIDE

YOUR SCOOTER IS DESIGNED FOR USE BY PERSONS 16 YEARS OLD
AND ABOVE. It is meant for one adult at a time only, please do not

attempt to carry two persons at the same time.

THE ACCELERATION THROTTLE IN TURBO MODE IS EXTREMELY
SENSITIVE to make the scooter to make the board responsive and

fun, but it also means fast or sudden inputs can easily cause you to
fall off. Start by trying to move forward as slowly as possible in these
modes.

HILLS AND HIGH SPEED CAN BE VERY DANGEROUS because crashes
can cause serious injuries. Be extra careful when pushing the limits of
the scooter, even if you’re an experienced rider.

CARS AND OTHER VEHICLES CAN KILL YOU, so always be aware of
your surroundings when riding in the presence of other vehicles.

Ride defensively and assume other vehicles can’t see you. Be aware

of the laws that govern the use of your board on public roads, bike
paths, sidewalks, or other places that you may ride.

ALWAYS WEAR A HELMET. Other safety gear, like gloves, pads, and
long sleeves, is highly recommended.

DO NOT RIDE WITHOUT

READING THIS FIRST

WARNING: Whenever you ride the Zoom Stryder, you risk death or
serious injury from loss of control, collisions, and falls. To ride safely,
you must read and follow all warnings and instructions in this manual.

1. Always wear a helmet and other protective gear when riding.

2. Do not ride a Zoom scooter in environments, on inclines, or at

speeds where you would not be safely in control of an
unpowered kickscooter. In the event of electronic failure, you
may need to rely on the rear emergency brake to stop safely.

3. Do not use the scooter when the temperature is lower than

minus 5 ℃.

4. Please slow down or get off when riding in rough or uneven

road conditions.

5. Do not ride the scooter on slippery or ice terrain.

6. Please adjust the height of handlebar to the appropriate

location according to your height to ensure riding safety.

7. Do not immerse the scooter in water of more than 4cm depth

to avoid damaging of the electronics. In heavy rain conditions,
please stop riding for safety.

WARNING: PINCH POINTS

Keep fingers, hair, and clothing away from motor, wheels,
and all moving parts.

WARNING: RISK OF ELECTRIC SHOCK

Do not open or tamper with electronics housings, which

also voids the warranty.
WARNING: CURBS

Do not attempt to ride across any curbs or stairs higher

than 3cm.

WARNING!

Please ride responsibly and respect those around you. How you ride
will determine how people view this new of transportation

Main Function Parts

Handlebar and Display

Adjustable height clamp
Hook to secure to rear fender

Charging port

Folding lever

Rear fender

Operation

Display Screen

1. Battery Voltage (for 2s when

powered on)

5. Speed Level (1, 2, 3)

2. Battery % and level

6. Front Light Symbol (On/Off)

3. Temperature

7. Speed

4. LED Light Mode

(Normal/Manual)

8. Distance Travelled
(Trip/Odo)

Switch from kilometre (km) to miles (m):

1. Turn on your scooter. The default mode is in kilometres.

2. Press and hold both ① and ② to go into the setting mode.

3. The screen should show P00. Press ③ once to change to P01. The
value at the bottom of screen should indicate 0. Press ② once to
change it to 1. After 4 seconds, the display should display in miles.

(3) Power On/Off

(2) Mode

(1) Light

Acceleration Throttle

Regenerative

Brake Throttle